A solution is prepared by diluting 2.79 mL of the blue dye stock solution to 25.00 mL. The measured absorbance for the prepared solution is: Blue dye stock solution = 0.293 M Absorbance at 630 nm = 0.00265 Calibration curve y = 0.0833x A.) What is the theoretical molar concentration? B.) What is the experimental molar concentration? C.) What is the percent error?

A solution is prepared by diluting 2.79 mL of the blue dye stock solution to 25.00 mL. The measured absorbance for the prepared solution is: Blue dye stock solution = 0.293 M Absorbance at 630 nm = 0.00265 Calibration curve y = 0.0833x A.) What is the theoretical molar concentration? B.) What is the experimental molar concentration? C.) What is the percent error?

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter24: Introduction To Spectrochemical Methods

Section: Chapter Questions

Problem 24.16QAP

See similar textbooks

Similar questions

Blue Blue dye stock solution Absorbance at 630 nm Calibration curve Part 1: 0.1944 M 0.00697 y = 0.0682x A purple solution is prepared by mixing 5.00 mL of the blue dye solution with 6.75 mL of red dye solution. The calibration curve for each color is provided. Part 2 out of 3 (a) Determine the theoretical molar concentration of each dye in the mixture. [Blueltheoretical = 8.27 x 10-2 [Red] theoretical = 1.16 [Bluelexperimental [Redlexperimental " *10-1 M M x 10 (b) Using the absorbance and calibration curve for each dye, calculate the experimental molar concentration of each dye in the mixture. x 10 Red Red dye stock solution Absorbance at 500 nm Calibration curve 0.2015 M 0.00193 y = 0.0170x M M
.Q1. To determine the concentrations (mol/L) of Co(NO3)2 (A) and Cr(NO3)3(B) in an unknown sample, the following representative absorbance data wereobtained.A (mol/L) B (mol/L) 510nm 575nm5×10−1 0 0.714 0.0970 6×10−2 0.298 0.757Unknown Unknown 0.671 0.330Measurements were made in 1.0 cm glass cells.i. Calculate the four molar absorptivities: ∈A(510), ∈A(575), ∈B(510) and ∈B(575).ii. Calculate the molarities of the two salts A and B in the unknown.
A colored ion solution has a concentration of 0.200 M with a measured absorbance A = 0.880. Another ion solution made of the same chemicals has an absorbance A = 0.172. What is the concentration of this unknown sample solution?
6. Blue Blue dye stock solution 0.293 M Absorbance at 630 nm 0.00265 Calibration curve y = 0.0833x A solution is prepared by diluting 2.79 mL of the blue dye stock solution to 25.00 mL. The measured absorbance for the prepared solution is listed in the data table. (a) What is the theoretical molar concentration? [Blue]theoretical x 10 |M (b) What is the experimental molar concentration? [Blue]experimental x 10 M (c) What is the percent error? Percent error (blue) = %
What is the concentration of a solution with an absorbance at 600 nm (A600) of 0.8 that has an extinction coefficient of 2.0 L/(mmol cm) (assume pathlength is 1 cm and provide your answer should in units of mM, but do NOT write the mM).
Based on the calibration curve, what is the molar concentration for a solution with a measured absorbance of 0.383?
A 0. 6875 g rock sample containing an unknown amount of Ca was dissolved in HCl and diluted to 200.00 mL. Aliquots of 20 mL of this unknown solution were added to different volumes of a 8.02?g/mL Ca standard solution and diluted to 100.00 mL. A plot of absorbance vs. concentration of standard gives a trendline of with slope of 1746. 7. The solution of 20 mL of unknown diluted to 100 mL and without any standard gave an absorbance of 215.8. Find the weight percent of Ca in the rock.
An unknown amount of a compound with a molecular mass of 270.57 g/mol is dissolved in a 10 mL volumetric flask. A 1.00 mL aliquot of this solution is transferred to a 25 mL volumetric flask, and enough water is added to dilute to the mark. The absorbance of this diluted solution at 355 nm is 0.495 in a 1.000 cm cuvette. The molar absorptivity for this compound at 355 nm is €355 = 6149 M-¹cm-¹. What is the concentration of the compound in the cuvette? concentration: What is the concentration of the compound in the 10 ml flask? concentration: How many milligrams of compound were used to make the 10 mL solution? mass: M M mg
A solution in part B initially contains (4.0800x10^-4) molar SCN and (2.850x10^-3) molar Fe3+ This solution was then measured using the colorimeter, and an absorbance of (4.810x10^-1) was recorded.The calibration curve prepared in part A of the experiment yielded a linear fit equation of y = (3.72o0x10^3)x+(4.16x10^-2) and an R2 value of 0.9964. Using the data provided above, determine the equilibrium concentration of Fe3+, [Fe* le in this solution. Note: Your answer is assumed to be reduced to the highest power possible. Your Answer: x10 Answer units
Suppose that a solution has an absorbance of 0.226 at a wavelength of 450 nm. If the concentration of the solution is 24 μM, what is the value of the molar absorptivity? The data were taken with a standard 1-cm cuvette.
Solve the problems using a step-by-step process (solutions). 1. A 1.0x10-3 M solution of a dye X shows an absorbance of 0.20 at 450 nm wavelength and an absorbance of 0.05 at 620 nm wavelength. Calculate the extinction coefficient for each wavelength. (Ans. e450 = 200 ; e620 = 50)
A solution of Tryptophan has an absorbance at 280 nm of 0.54 in a 0.5 cm length cuvette. Given the absorbance coefficient of trp is 6.4 x 103 Lmol-1cm-1. What is the concentration of solution? The options are as follows A) 0.17 x10-3 mol/L B)2.56x10-3mol/L C)0.17x10+3mol/L D)2.56x10+3mol/L