A transformer with 10: 1 rato and rated at 50 KVA, 2400 7 240 V, 50 Hr is used to step down the voltage of a distrbution system. The low-tension voltage is to be kept constant at 240 V i. What load impedance connected to the low-tension side will be loading the transformer fully at 0.8 power factor lagging?   ii.What is the value of this impedance referred to high-tension side?   iii. What is the value of this current referred to high-tension side?

Q: The reliance-compliance model of automation dependence proposes that as the threshold for an alert…

A: Since, While miss-prone automation seemed to solely effect operator reliance, false alarm-prone…

Q: Calculate the pulse width, rise time, and fall time of the pulse below. on an aprądzy 100 80 70 60…

A: Given: Waveform:

Q: Norton equivalent FR₁ d 1022² 2A R₂=4-₁2 -ЛАМА- Ra 952 R4 42 RN || >

A: In this question We need to determine the Norton equivalent circuit.  We are solving this problem…

Q: Q7. Given the circuit of Figure below. Rs=60 M 02 30 V Į₁ R₁ 6Ω www 12 R3 3 Ω V1 R5 18 Ω R₂ 1412 V4…

A: Kirchoff's Law (KCL and KVL) and Ohm's law is very important to analyze electrical circuits. As per…

Q: A 120 V power line is protected by a 20 A fuse. What is the maximum number of 100 W lamps that can…

A: In this question We need to determine the number of lamps required to operate with 120V and 20A fuse…

Q: Ł i(t) Figure 3

A:

Q: A single phase, 60Hz, 200-km medium nominal-T transmission line receives 700 MW at 0.95 lagging pf…

A:

Q: The circuit shown in Fig (2) supplied by a voltage source of vs(t) = 50 +100 u(t) volt. Find: 1)…

A: The general expression of inductor current in series RL Circuit is given as…

Q: calculate the power consumption in watts of a 48 amp train motor that operates on 800 volts

A: In this question We need to determine the power consumption by the train if  Voltage V= 800V Current…

Q: The motor control system with the K1 Amplifier controller is shown in Figure P.2.b. It is known that…

A:

Q: For the circuit shown in the figure, find Zeq and use that to find current . Let w = 10 rad/s and…

A:

Q: Determine the inductor current i(t) for both t= 0 and t> 0 for the given circuit. Assume V 26 V. 352…

A:

Q: In a seires RLC circuit with 20 R=1222, L= 1.2 H, C=- - mF, E= 12,000 sin (25t) V 3 the circuit is…

A: In this question We need to choose the  correct options We are solving this problem using the…

Q: 4 The current through a 5-mH inductor is shown in following Fig. Determine the voltage across the…

A: Given data, Graph of current time graph is given by,

Q: Question 6 Determine Vo during the Positive Half Cycle of the input voltage. 10 V A -10 V 10 k www…

A: Both positive and negative wave clipper is given we need to determine the output for positive half…

Q: 2. The following difference equation defines the system y[n] = 4x[n] + 3x[n-1] - 3x[n- 2] + 2x[n-3]…

A:

Q: Find the value of R & C for RC circuit that produce a sinewave if the input to circuit is a square…

A: Given: A RC filter produces sine wave if the input to circuit is a square wave.  Fundamental…

Q: 1. A 4-pole shunt generator with wave-wound armature has 41 slots, each having 12 conductors. The…

A: In this question We need to determine the voltage across the load.  We know  Induced emf E=…

Q: 2. For the Feedback Amplifier circuit shown in Figure 4, determine the following: a. Identify the…

A:

Q: Find V. in the following network.

A: The current through the mesh can be calculated by using the mesh analysis and by using the mesh…

Q: Draw the frequency response for the band-pass filter, where the system has a sampling rate of 48…

A: According to the question, we need to draw the frequency response for the band-pass filter, where…

Q: In the blanks, write the word 'increases' or 'decreases' for each letter a, b, c and d, to signify…

A: Given data The speed of the motor is given that getting increased. We need to comment upon the rpm1,…

Q: Please draw the small signal model and show how the equations

A:

Q: A long shunt generator is connected to a load that draws 28.8 kW, R, 0.04 ohm, R 0.01 ohm and 45…

A:

Q: lov +1 301 w 102 w ≤15-22 201 m US ль (+) rav

A: We need to find the current through 10 ohm resistor i.e 'I'. Using nodal or superposition or source…

Q: What is the total output power of a communication system with 2 watts of power if it passes a…

A: In this question,  We need to determine the total output power.  Input power Pinput = 2W Given…

Q: lease resolve the problem above. Same givens above but follow the way of solving in the attached…

A: here we have to find the voltage and currents.

Q: Describe the difference between AC and DC voltage. How does each affect a 'reactive component?' What…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: Design a two-pole high pass Butterworth active filter with curoff frequency of 10 kHzand a unity…

A: Given: In this question, the given details are, Here, design a two-pole high pass butter-worth…

Q: Given the truth table of a set of digital circuits with four inputs (a,b,c and d) and three outputs…

A: Given: To do: Implement the output G using 2:1 multiplexer and one variable as d.

Q: R₁ R₂ Is = 0.05 A, R₁ = 75 S2, R₂ = 50 2 For the circuit shown calculate the current in each…

A:

Q: 50V cuit given below. 2-) Determine the maximum power that can be delivered to the resistor R₁, for…

A:

Q: SHOW YOUR COMPLETE SOLUTION, ANSWER MUST BE IN 2 DECIMAL PLACES. SHOW WHAT IS GIVEN AND WHAT IS THE…

A: Note:  Types of DC Machine Self-Excited DC Machine Shunt DC Machine Series DC Machine Compound DC…

Q: Design a counter that has an En (Enable) input such that when En is equal to 1 the counter goes…

A: Given, A counter has En(Enable) input. When En=1, the counter sequence is 0,1,2,3,0,1.... When En…

Q: A three phase 300km long line has a total series impedance of 200/90° ohms per phase and a total…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Assume the Fiber Optic manufacturing technique produces minimal/zero defects. Why is it more energy…

A: Telecommunication It is the process of transmitting the data from sending end to receiving end via a…

Q: Determine the value of the current is using superposition.

A: The superposition theorem state that the sum of response of individual sources acting alone is equal…

Q: Construct a state diagram that has an input w and an output z. The output z is equal to 1 if either…

A: The given problem is from state machine. Let there will be overlapping of sequence is allowed. The…

Q: polar form

A: According to Company rule , an expert can provide answer to one question with 3 subparts , here 5…

Q: 1. Show that the transfer function H(f) for the RL circuit shown below is given by H(f) = 1+1/ where…

A:

Q: 15. Consider this ideal transformer circuit: i(t) 12 Ω ww v (t) = 100 cos (3t) V 3:1 Vo(t) = 25 Ω 8…

A:

Q: Q2: Determine, the subtransient current in the fault F, the subtransient current in the breaker B,…

A: Given Base MVA =Sb =50 MVA We assume base voltage =11 kV for G2, M2 and T2  base voltage  =4.5 kV…

Q: ed Calculate the capacitor voltage for t= 0 (zero negative) and t> 0 for the given circuit. Assume R…

A: In this question We need to determine the voltage across the capacitor.  We know capacitor act as…

Q: Given the Cascode Amplifier with Cascode Current Mirror Active Load as well as the following…

A: The circuit is as shown below, Given,

Q: For the circuit shown in the figure, find Zeq and use that to find current I. Let w = 10 rad/s and…

A:

Q: Question 2 Determine VO during the Negative Half Cycle of the input voltage, V 12 V f=1 kHz 1 -12 V…

A:

Q: Ο 6 mA R₁ σK? 9VR 14 ΚΩ R3 E RA 12 ΚΩ 35 ΚΩ

A: here we have to find I2 by using superposition theorem.

Q: 03:(B) Compute the DFT using matrix relation method of the signal x[n]={1, 2, 3, 4).

A:

Q: A voltage (t) = 100 cos(60t+20°) V is applied to a parallel combination of a 28-k resistor and a 44-…

A:

Q: Q1. Use source transformation method to find the value of lo 6 A w 552 3 A 292 20 V

A: The given circuit diagram is shown below,

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.