A vertical piston-cylinder arrangement with a diameter of 120 mm contains water with a quality of 60%. The pressure is 3 bar. Initially the piston rests 40 mm above the bottom of the cylinder. Heat is then added until the volume is 3 times the original volume. (a) Determine the mass of the water in the cylinder [ Select ] O kg (b) Determine the work done. [ Select ] () (c) The final temperature [ Select ] PC (d) The heat transferred to the system [ Select ]

A vertical piston-cylinder arrangement with a diameter of 120 mm contains water with a quality of 60%. The pressure is 3 bar. Initially the piston rests 40 mm above the bottom of the cylinder. Heat is then added until the volume is 3 times the original volume. (a) Determine the mass of the water in the cylinder [ Select ] O kg (b) Determine the work done. [ Select ] () (c) The final temperature [ Select ] PC (d) The heat transferred to the system [ Select ]

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A volume of 400 cc of air is measured at a pressure of 740 mm Hg absolute and a temperature of 18 ˚C. What will be the volume (in cc) at 760 mm Hg and 0 ˚C?
(e) The piston of a cylinder-piston device has a mass of 72 kg and a cross- sectional area of 0.06 m², as shown in Figure Q1(e). The depth of the liquid in the cylinder is 2.4 m and has a density of 1660 kg/m³. The local atmospheric pressure is 1.25 bar, and the gravitational acceleration is 9.8 m/s?. Determine the pressure at the bottom of the cylinder.
A water storage tank contalns Liquid and Vapor in equilibruim at lloE. The distance from bottonm of the tank to the Liquid level is 8 m. What is the absolute pressure at the bottom of the tank. [218 kpa]
As shown in the diagram, the state of helium gas is changed in such a way that its PV graph is a straight line segment with volume Vo increases to yVo and pressure Po increases to xPo where x and y are arbitrary constants. During this process the total heat transferred to the gas is equal to the heat necessary to double the absolute temperature of the gas at constant volume. What is the maximum ratio for the volume increase? xP, P. Vo
A small solid ball is released from rest while fully submerged in a liquid and then its kinetic energy is measured when it has moved 4.10 cm in the liquid (if it moves). The figure gives the results after many liquids are used: The kinetic energy K is plotted versus the liquid density plig, and Kg = 1.70 J sets the scale on the vertical axis. What is the volume of the ball in m3? K, 1 3. Pliq (g/cm³) K (J)
(Q5] (a) The chamber contains 0.05 m' of ideal gas at a pressure of 20 KPa. The gas is subjected to an isothermal compression. until pressure reaches to 30 KPa. After that the gas is subjected to compression according to PV 2-const until pressure reaches to 40 KPa then an isobaric compression is done till volume reaches 0.005 m3. Assume that no loss in gas during the whole process : I- Sketch the process on P-V diagram and P-T diagram II- Find the work done during the entire process and temperature at end of each process.. gas
In the figure given, fluid 2 is carbon tetrachloride and fluid 1 is benzene. If patm = 101.5 kPa, determine the absolute pressure at point A. fluid 1 A T 12 cm Patm fluid 2 35 cm ] LIVE 10 nexxt Reimagine Education. www.dlsl.edu.ph
For a certain ideal gas R = 25.8 ft.lb /lb °R and k =1.09a. What are the values of cp and cv?b. What mass of this gas would occupy a volume of 15 cu ft at 75 psia and 80 °F?c. If 30 Btu are transferred to this gas at constant volume in (b), what are the resultingtemperature and pressure? include the diagram
Water at 350 kPa has a specific volume of 0.4 m3/kg. Its phase can be described as [phase] and its temperature is [T] oC.Note: use 5 significant digits for temperature.
Consider a column of a planet's atmosphere. The planet's atmosphere is a compressible ideal gas at rest that obeys the polytropic relation Po %3D 3/2 Po 3/2 where pis pressure and pis density. Here, p, and P, are the values of pressure and density, respectively, at the planet's surface. Take z (altitude) to be positive upward with z=0 at the surface, take R to be the gas constant for the planet's atmosphere, and take g to be the downward acceleration due to gravity. a) Starting from hydrostatic balance and the polytropic relation above, derive an expression for the pressure field, p(z), in terms of the given parameters. Leave all parameters except the polytropic index as algebraic. b) Derive an expression for the density field, p(z), in terms of the given parameters. Leave all parameters except the polytropic index as algebraic. c) Derive an expression for the temperature field, T(z), in terms of the given parameters. Leave all parameters except the polytropic index as algebraic.
5. If 10 m3 of atmospheric air at zero degrees centigrade temperature are compressed to a volume of 1 m3 at 100oC, what will be the pressure of air in kPa? (3 DECIMALS IN FINAL ANSWER PLS)
|Q4:0 Skg of Steam at pressure of 4.9 bar is produ- ced from uwater at 20%. Determine the amount 0.9 dry. [12263 leg] of heat supplied it the Steam is to o