(a) What is the appropriate cable used at each of the labeled (1-4) network connections?  (b) Why there are green and red signals at cable no.1 and no.2 respectively? Explain the issue. (c) Explain the purpose of cable no. 4?  (d) What is the network type that represents by the connection at cable no.3? Explain how it's different from the network type that connects Router0 and Switch0. Refer the image for solving the question

Q: 5. Check applicable statements for a wired DSL, WiFi and Fiber modems (multiple checks possible):…

A: We need to find the correct options.

Q: What type of cables might connect from: R1 to R2 (assume Ethernet)? R2 to R3? AS4 edge router to AS5…

A: 1. R1 to R2  Router1 to router2 is connected using Ethernet cross over cable. The internal wiring of…

Q: etworks" is exactly what it sounds like. Do routers fall under this category? What does the…

A: Over layers of network: A logical PC network that is built on top of one more physical network is…

Q: In the case of Ethernet, there is no centralised control node, hence a single node's failure will…

A: Definition: A distributed system consists of multiple independent node groups that collaborate to…

Q: 192.168.10.1 192.168.100.1 a. Consider A, B, C, D, E, F are Routers, and link cost are given. Find…

A: The given question is based on the routing of nodes (in this case routers ) in the network. The…

Q: Two PC’s are connected to a switch. The IP addresses of the PC’s are as displayed in the diagram. PC…

A: Actually, IP stands for Internet Protocol.

Q: QUESTION 29 If all the links in the Internet were to provide reliable delivery service, the TCP…

A: Given : 1) If all the links in the Internet were to provide reliable delivery service, the TCP…

Q: What are the important parameters and settings of a network router or a switch, which we need to be…

A: Note: There are multiple questions are given in one question. According to the rule, you will get…

Q: The kind of cable used to link the switch and the router must be determined. What piece of hardware…

A: Dear Student, The piece of hardware that is used to connect two networks operating under distinct…

Q: From the above scenario, RIP and internal EIGRP routing protocols were configured on the same…

A: If a network has configured with both RIP and EIGRP, that type of configuration is called hybrid…

Q: an implementable routing and bridging solution for the network. Your solution must address the…

A: It is defined as Network-to-network connections are what make the Internet possible. The "network…

Q: Assume seven devices are arranged in a mesh topology. How many cables are needed? How many ports are…

A: We are bounded by our guidelines to answer the first question only.   - The question states wants to…

Q: .6 The local area network shown in Figure 7‐21 (Prescribed material) has two hubs (X and Y)…

A: given data is 1.6 The local area network shown in Figure 7‐21 (Prescribed material) has two hubs…

Q: smission? Give a numerical example assuming a specific capacity of the link and an initial value of…

A: TCP manages congestion, both for the connection’s own benefit (to improve its throughput) and for…

Q: What is the name of a network-layer Packet? b) Both router and Link-layer switch are used to switch…

A: Network: A network is a collection of computers or servers or devices connected with each other…

Q: Computer Science a. Explain with illustrations the hidden terminal and the exposed terminal problems…

A: Hidden Terminal Problem: A wireless organization with absence of brought together control element,…

Q: B. Let us assume that Node A transfers data to Node D through local area notwork LAN1, R1 router,…

A: I have answered this question in step 2.

Q: give proper solution for both (A) and (B) give proper explaination  subject networking    (a) The…

A: The first statement given is:  The purpose of the OSI model is to show how to facilitate…

Q: The network address given is 192.168.1.0/24. Your task is to do subnetting to support 62 hosts for…

A: Given 192.168.1.0/24 is a class C address, 24 bits are there in the network ID. if we choose a 26…

Q: a) The purpose of the OSI model is to show how to facilitate communication between different systems…

A: The question is a multiple type question. So, according to the guidelines only first question (a) ha…

Q: Suppose  your network is connected to another network via a router. Network layer  OSI  model layer…

A: Routing information by Network layer in OSI model

Q: Use VLSM to subnet the 128.153.0.0/22 network based on the following requirements shown on the…

A: VLSM happens when an internetwork involves more than one veil for various subnets of a solitary…

Q: True or False: [  ] Routing decision is always required for every packet of a message at each node…

A: (1) The statement “Routing decision is always required for every packet of a message at each node in…

Q: q31-  Which statement is true regarding packet-switched networks as opposed to circuit-switched…

A: Packet switching: In a network application, the hosts need to send data to one another over…

Q: 1. Answer the following questions with respect to “Link state Routing Protocol". 5 2 192.168.10.1…

A: Link state routing is one network where routers share knowledge to its neighbors.

Q: a) What is the difference between congestion control and flow control b) Which of the two may…

A: Given: a) What is the difference between congestion control and flow control?b) Which of the two may…

Q: 2. Given the follow network. Where the units are the maximum network unit load each line the line…

A: Bandwidths for the seven flows are:  "Flow 1:" "10 Mbps"  "Flow 2:" "10 Mbps" "Flow 3:" "10 Mbps"…

Q: i- Minimum frame time, Maximum length of the network, ili- ii- If frame change is available as…

A: Ethernet IEEE 802.3:   The frame formats or frame structures produced inside the MAC layer of the…

Q: Q: Question five 3- Explain in detail the operation of an Ethernet bridge when used to connect two…

A: A bridge is nothing but a mechanism used to connect two segments of the LAN and it operates on the…

Q: What are the data plane and the control plane in the network layer conceptually? How do they relate…

A: The network layer is considered as the backbone of the open system interconnection model.

Q: Answer the following questions with respect to "Link state Routing Protocol". 192.168.10.1…

A: Link state routing protocol is a dynamic routing protocol which is used to find the routing distance…

Q: Do the source and destination IP addresses change at location point 2 in the figure? Explain. Do the…

A: STEP BY STEP COMPLETE SOLUTION REGARDING YOUR PROBLEM :

Q: 1. It is known that the MAC address is the only address that is used in order to communicate and…

A: Given- eg1

Q: COMPUTER CONSTRUCTION QUESTION : The routers in the network depicted by the figure above agree to…

A: Given,  Table B Dest Cost Next Hop A 4 A B 0 B C 4 D D 3 D F 1 F Table F Dest…

Q: Explain in detail what the collision domain and broadcast domain of a switch and a router are and…

A: Answer: The collision domain and broadcast domain both are very important for networking. A…

Q: The stop-and-wait technique is explained in detail. What are the primary drawbacks and drawbacks of…

A: The stop and wait for technique is defined as the fundamental technique which is providing reliable…

Q: Both Layer-2 Switch and Router are used to forward network traffic from one interface to another.…

A: Difference between switch and router: Router is defines the path of the data transmission. Switches…

Q: Match each characteristic with the particular topology.  we have to choce between (Bus, Star, Full…

A: WAN provides the network communication services in the work place, connecting locations that can be…

Q: A. Class C network address of 210.10.11.0/24 with no subnetting. Design two subnets for the above…

A:

Q: 1. Build a Router network which has three Generic Routers and totally of Six networks in it. From…

A: Build a Router Network which has three Generic Routers and totally of Six networks in it.From each…

Q: Assume that there are two routers, each router is connected with pc A and pc B. Find the number of…

A: Answer: I have given answered in the handwritten format in brief explanation.

Q: You are employed as a network engineer and have been asked to analyze a communication network to…

A: Solution ::

Q: Question 3: a server and receives a corresponding reply also with 60 B of data. The client and…

A: Solution : Check the detailed solution below.

Q: a. packet networks support either connection-oriented or connectionless circuits b. A connection…

A: Connection oriented circuits creates a end to end connection before sending out packets from sender…

Q: In a network with dozens of switches, how many root bridges would you have?

A: The number of root bridges is given below -

Q: What exactly is a network overlay? Do routers fall under this category? Where exactly do the margins…

A: Inspection:: What exactly is a network overlay? Do routers fall under this category? Where exactly…