A wind energy generator generates 1050 w at rated speed of 26 mph at the atmospheric pressure and temperature at 20 deg C. calculate the change of output if wind generator is operates altitude of 1800 m temperature 10 deg C, wind speed 24 mph , atmospheric pressure 0.88 atm. Area= power generated for 1800 m=

A wind energy generator generates 1050 w at rated speed of 26 mph at the atmospheric pressure and temperature at 20 deg C. calculate the change of output if wind generator is operates altitude of 1800 m temperature 10 deg C, wind speed 24 mph , atmospheric pressure 0.88 atm. Area= power generated for 1800 m=

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

i. A wind turbine has the following data: Downstream wind velocity = 9 m/s Upstream wind velocity =18 m/s Rotor Power output = 1 MW a. Compute the wind rotor efficiency. b. Calculate power in the wind and the length of the rotor blades ii. ComparethedifferenttypesBiogasplants?
1. A centrifugal pump has external and internal diameters of 300 mm and 150 mm respectively. The vane angles of inlct and outlet are 25 and 30° and the pump runs at 1450 r.p.m, If the velocity of flow through the pump is constant, find the work done per kN of water. (Ans. 20-2 kJ)
Maximizing the wind velocity of 92 m/s and 25 units of wind turbine was installed at the seaside shore. What is the total power if the area of turbine blade equal to 42 sq.m. with air density of 1.2041 Kg/cu.m. A 1.969 MW 1,968,998 Watts 4,923 watts D 49.23 MW
A Large wind turbine has blade span diameters of 110 m. It sits high off the ground where the average wind speed is 7 m/s. Assume the air density to be 1.25 kg/m3, and the efficiency of the wind turbine, its generator and its electric grid synchronization device is 26%. What is the average electric power that this turbine can output to the grid? a. Sketch the problem. b.Draw lines identifying the control volume, or control mass. c.Identify the states with numbers, letters, or descriptions such as “in” and “out”. d.Write down the knowns and unknowns. e.Identify what is being asked for. f.State all assumptions.
A two-blade wind turbine is installed on top of a hill experiencing winds of up to 80 mile/h. Downstream of the propeller the wind speed is 50 mile/h. Assume ideal gas and standard condition for air and find the tip to tip diameter of the propeller to obtain a theoretical efficiency of 50%.
What is the crossover point in miles between thehybrid vehicle in Problem S5.4 and this alternative vehicle from acompeting auto manufacturer?
The array spacing is 5D by 10D, for 1 MW wind turbines, 60 mdiameter.a. How many turbines can be placed in a square kilometer?b. Assuming the average wind power potential is 500 W/m2 at 50 mheight and the capacity factor of 35%, estimate the annual energyproduction for each turbine and the designed wind farm.c. Calculate the cost of gearbox for each turbine if a medium speedgenerator is used. In what condition you can eliminate that cost?
What size pump is needed to supply 10 gpm to a cylinder when the electric motor is rotating at 1725 rpm? Assume 100% efficiency and state your answer in in3/rev to two decimal places.?
A system requires a pump to deliver 30 gal/min at 1500 lbf/in2 at an engine speed of 2000 rpm. calculate theoretical pump displacement, engine torque to drive the unit, and horsepower.
Considering the wind speed of 5 m/s, air density of 1 kg/m3, exponentfactor is 0.20 and turbine diameter of 100 m:a. Calculate the turbine electrical power considering the maximumBitz limit,b. The original wind speed was taken at a height of 10 m,calculate the turbine power if it is now installed at 50 m height.c. In what condition a capacity factor of 73% can be reached bythis turbine.
1. A fuel pump is delivering 10 gallons per minute of oil with a specific gravity of 0.83. the total head is 9.15m. Find how much energy/power does the pump consumes in kJ per hour. 2. A pump driven by an electrical motor moves 25 gallons per minute of water from a reservoir A to B, lifting the water to a head of 245 ft. The efficiency of the pump is 65%. Neglecting velocity head, friction head and minor losses; What power input in horse power is required?
2. A pump draws water from a lake delivered to a height of 50 meters above the lake and encounters 15 meters of headloss. Determine the pump power requirement in Kilo-Watts to deliver a constant supply of 500 Liters per second? The correct answer has a margin of 1 from exact answer. Velocity head is neglected.