A wind turbine gives maximum output put of 1MW at a wind speed of 15m/s. Refer to the above wind turbine choose the correct statement a. The wind rotor swept area is 638 square meters. b. The wind rotor swept area is 835 square meters. c. The wind rotor swept area is 700 square meters d. The wind rotor swept area is 400square meters.

A wind turbine gives maximum output put of 1MW at a wind speed of 15m/s. Refer to the above wind turbine choose the correct statement a. The wind rotor swept area is 638 square meters. b. The wind rotor swept area is 835 square meters. c. The wind rotor swept area is 700 square meters d. The wind rotor swept area is 400square meters.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter32: Three-phase Motors

Section: Chapter Questions

Problem 8RQ

See similar textbooks

Similar questions

A wind turbine gives maximum output power of 1MW at a wind speed of 15m/s. Refer to the above wind turbine choose the correct statement a. The wind rotor swept area is 400square meters. b. The wind rotor swept area is 835 square meters. c. The wind rotor swept area is 700 square meters d. The wind rotor swept area is 638 square meters.
Draw and explain a typical power curve for a wind turbine and write the definition of the four important terms that are shown in the power curve
(a) Show the voltage waveforms across each half of the secondary winding and across RL when a 100 V peak sine wave is applied to the primary winding in Figure. (b) what is Vavg and fout if fin = 50 Hz?
Untitled Section Jalis 6 In d.c. generators armature reaction is produced by field current O armature current commutating winding current none of the mentioned compensating winding current *.The use of d.c. generators eliminated the use of rectifiers and ac supplies True False O
Capacitors are used after the converter toA. smooth out the DC current.B. suppress the noise.C. change the voltage frequency.D. reduce the voltage.
please write introduction about AC Circuits and Parallel Circuits
A commutator has 456 segments. Indicate whether or not the windings are possible a. Duplex-wave, eight poles b. Simplex-wave, 10 poles
BASIC ELECTRICAL ENGINEERING UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTONS LEGIBLY.
Machine has 6 pole pairs and it is supplied with 50 Hz frequency. In order to double rated rotational speed, number of pole pairs in the design of the electrical machine must be changed to (put new number of pole pairs)
List the different factors which determine the output from a wind energy converter
What is use of solenoid coil in the pressure to converter? a. To produce magnetic field in the LVDT b. To change the LVDT output c. To bring back the pivoted beam normal position d. To produce linear displacement in bellows
Damping ratio quettion.