acitan 40 μF 50 μF 30 μF 10 μF 20 μF

Q: Determine the percent voltage regulation of a transformer, given: V1 = 473 V V2 = 3467 V S rating = ...

A:

Q: a circuit

A: Source transformation-

Q: How did he get the value inside the circle? Can you explain step by step and clear line please? i. I...

A: In this question we will write about how we will find sending current with given data...

Q: a. When the number of poles in a squirrel-cage motor is changed from 4 to 8, the speed is

A:

Q: Plane Z=0 and Z=4 carry a current K= -10ax A/m and K= 10 ax A/m respectively. Determine H at I) p(1...

A: Given  Z=0 plane carry current k=-10 ax A/m and Z=4 plane carry current k=10 ax A/mTwo points P(1,1,...

Q: Example: Suppose that an analog signal is given as x(t) = 5cos (2n x 10 t) and is sampled at the 8kH...

A:

Q: State the six (6) Boolean Postulates that are fundamental to Boolean Algebra. For each Postulate, st...

A: The Boolean postulates are used to reduce the given Boolean expression and the reduced Boolean expre...

Q: 3. Prove that block diagram shown below can produce AM signal. A cos w t m square Divide the frequen...

A: Let signal is xt then xt is given as-xt=Amcosωmt.Accosωct2+Accosωct2xt=Am2 Ac2 cos2ωmt.cos2ωct+Ac2co...

Q: . 2.00 p

A:

Q: 5+j30 2+j60 5-j42 a 2+j80 3-j60 6+j30 j100 30

A:

Q: Use node and superposition method to solve for i.

A:

Q: Theoretical Calculations: 1. What is the polarity of the input voltage Uin compared with the output ...

A:

Q: Sequential Circuit has 2 flip flop A and B, 2 inputs X and Y and 1 output Z.    The FF equation are ...

A: Sequential Circuit- It’s an electronic circuit in which output of the circuit depends on present inp...

Q: Assume that each diode has a turn-on voltage 0.7V in the circuit shown in Figure Q1. By using the co...

A: In this question,  We need to check which diode act as on and off.  Assume forward bias diode voltag...

Q: Compute the current through the 222 resistor of the circuit in Figure Ql using superposition theorem...

A:

Q: 1. Use NODAL ANALYSIS to determine the branch currents: 11, 12, 13, 14, 15. 50 V A 35 Ohm 25 Ohm 25 ...

A: The solution is given below 

Q: A single line diagram of a system is shown in Fig. All the values are in per unit on a common base. ...

A: The given circuit is shown below: V=1 p.u.P=1p.u.cosϕ=0.8 lagging

Q: Explain the stability analysis of a Dc system in a detail

A: Dc system - It’s main use is to power anything that has a battery. The battery is used mainly for th...

Q: 6. In the circuit of Fig. 5-30, find V if 13=0.2 A. Then find IT. = 0.2A 20 1 20 N 10 Fig. 5-30

A:

Q: Design a CMOS gate circuit for the Boolean expression (circuits and input- output curves) F= XZ + XY...

A: CMOS: It stands for complementary metal oxide semiconductor and is used for making the ICs.  

Q: Find the V and the input power factor of the network shown in Fig. 4(a). 20 kW 16 kW 12/0° A rms 0.8...

A: Power factor: It tells how much active power is utilized by load from the apparent power.

Q: The amplitude of a free-running triangle wave generator can be adjusted by modifying the O a. Both r...

A:

Q: For the capacitor circuit shown in Figure Q3(a), calculate: (i) (ii) (iii) The equivalent capacitanc...

A:

Q: 2. Kirchhoff's Current Law (KCL) Experimental Procedure Design the circuit using resistors and power...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts fo...

Q: Simplify the following table in POS form

A: The solution is given below 

Q: A parallel-plate waveguide has plate separation d = 1 cm and is filled with Teflon having dielectric...

A: Waveguides-Waveguides are nothing but a guided medium to transmit electromagnetic energy from one pl...

Q: 1. Explain the difference between a slip ring and a squirrel -cage motor.

A: Solution 1 -  The rotor in a slip ring induction rotor has the same three phase winding as the stato...

Q: Q.3 a) The frequency spectrum of Amplitude Modulation with Full Carrier (AM-FC) signal is shown in F...

A: As per our guidelines we are supposed to be answered the first question only. Kindly repost the othe...

Q: In the circuit of Figure 2 with RL = 1 kilohm, determine the maximum value of Rs which will allow th...

A: A series combination yields the most resistance, whereas a parallel combination has the lowest resis...

Q: Show solutions

A:

Q: solenoid 10 cm long is wound with 300 turns of wire. The solenoid needs a current of 1 A in order to...

A:

Q: Show, diagrammatically and with an explanation, how channels are combined into groups and groups int...

A: Multiplexing on Communication Technology to send a number of different signals together, with the sa...

Q: A B 2 3 Y 5 2 3. 4.

A:

Q: 6. A circular coil has a mean diameter of 100 cm having an electron density of 3.34 x 1024 e/m³ with...

A: The solution is given below

Q: (use Loug division) 2x'-3x*+リメ+5 X+ 2

A:

Q: Implement a circuit converting rectangular wave to positive cycle sinusoidal waves. Explain its work...

A: Wave converting circuit is define as the circuit which is used to convert the nature of the waveform...

Q: 24 V 10 V 2 H t = 0 (+1) ww

A:

Q: Use node method to find i

A:

Q: 400 µA/V², |Vt| 0.4 V, L = 0.2 µm, For the NMOS, µnCox W = 1 µm, and VA 2.5 V for both devices. For ...

A:

Q: (For Nos. 1 and 2) For the circuit shown below, assume all charges and currents are zero at t-0. L= ...

A:

Q: Assume you have a 6V battery and a 1.5V flashlight bulb which draws 0.5A when the bulb voltage is 1....

A: V=IR here V= voltage  I=Current R resistor 

Q: Given an analog input signal whose voltage ranges from –-5 to 5 V, and a 8-bit digital encoding, cal...

A:

Q: Define the following 1RF Refraction, 2RF Reflection, 3RF Absorption, 4RF Scattering and 5RF Diffract...

A: These are the phenomena we generally observe in light propagation as particle as well as wave. 

Q: 15 If no input signal at the base of two transistors, what is the condition of the two * ?transistor...

A: The solution is given below 

Q: The triangular current pulse shown in the provided figure is applied to a 500 mH inductor. A.) Use ...

A:

Q: What is the RMS value of 169sin 377t?   Answer: 119.5 volts

A:

Q: Ex. Calculate the PA for the follow assembly code which is assume the DS = 4500h, SS = 2000h, BX = 2...

A: The given code is: 01 org 100h02 MOV BX+20,  AX03 MOV SI+10, AX04 MOV BP+2, AL04 ret It is given tha...

Q: Consider the WAN, or wide-area network, as your preferred wireless access method. What makes this op...

A: Wide Area Network (WAN) -  it is a big data system that is not limited to a single place. Through a ...

Q: Instructions: In-order to solve: The (1st picture) is the guide to solve the (2nd Picture) you need ...

A:

Q: o figures, step by step, clear, please 5 cos (27 X103t) Sempled at f. = 8 KKZ Skekh me sPpectrum of ...

A:

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.