An engine absorbs 422 J of heat and does 113 J of work in each cycle. 1) (a) What is its efficiency? % Submit You currently have 0 submissions for this question. Only 10 submission are You can make 10 more submissions for this question. 2) (b) How much heat is rejected in each cycle? Submit

An engine absorbs 422 J of heat and does 113 J of work in each cycle. 1) (a) What is its efficiency? % Submit You currently have 0 submissions for this question. Only 10 submission are You can make 10 more submissions for this question. 2) (b) How much heat is rejected in each cycle? Submit

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter4: The Second Law Of Thermodynamics

Section: Chapter Questions

Problem 24P: An engine with an efficiency of 0.30 absorbs 500 J of heat per cycle. (a) How much work does it...

See similar textbooks

Related questions

Q: given |F| = 20 N d= 2 m Find work done by force F. Answer in [Joules] (that is N.m)

Q: 16. Compare and contrast the physical quanti- ties emf and potential difference. 17. Birds on high…

A: EMF means electromotive force .

Q: If the jet is moving at a speed of 1000 km/h at the lowest point of the loop, determine the minimum…

Q: Forces stick-block. In the figure below, a 37 kg block is pushed across a frictionless floor by…

A: Mass of block (M)= 37kg Mass of stick(m)= 3.8 kg Block moves from rest ( ui= 0) through distance…

Q: Trial 1 Trial 2 Trial 3 5.50 s 6.70 s 6.78 s 23.2 m 28.3 m 28.7 m Speed= Distance/Time 23.2 M/5.50 S…

A: Given: For Trial 1, time is t1=5.50 s and distance is d1=23.2 m For Trial 2, time is t2=6.70 s and…

Q: Noninertial frame projectile. A device shoots a small ball horizontally with speed 0.288 m/s from…

Q: The diagram shows three resistors connected in a parallel the voltage drop across R2 is 1260 V…

A: Given, 3 resistors in parallel, ie, R1,R2 and R3 are in parallel. The voltage drop across R1 and R3…

Q: A point-like mass is constrained to move along the z-axis only. It is attached to two springs, each…

Q: The terminal velocity of a 4x10-5 kg raindrop is about 9 m/s. Assume a drag force FD = -bv. Part A…

A: Mass of rain drop m= 4(10-5 ) kg Terminal velocity vt = 9 m/ s Drag force FD =-bv

Q: Determine the acceleration of the crate as it slides down the plane. - If the crate starts from…

Q: In a carnival booth, you win a stuffed giraffe if you toss a quarter into a small dish. The dish is…

Q: Q8. In FIGURE 3, two identical speakers S₁ and S₂ emit in phase sound waves of frequency 343 Hz. If…

Q: 1. Sketch the electric field lines for a positive point charge. 2. If the point charge above has a…

A: The potential due a charge q at distance r is viven as V= Kq/r where q is in columb and r is in…

Q: The diagram below shows two long parallel wires ANB the direction of the current for each wire is…

Q: A picture window has dimensions of 1.40 mx2.50 m and is made of glass 5.70 mm thick. On a winter…

A: Answer the following question is

Q: An object moves in a circle of radius 25 m with its speed given by v = 3.6 + 1.5t², with v in meters…

Q: Snakes on the ground Tarzan swings on a vine from a cliff to rescue Jane, who is standing on the…

Q: 30 The homogeneous wire ABCD is bent as shown and is attached to a hinge at C. Determine the length…

A: Given that the homogenous wire ABCD is bent. Also, the length BD = 80 mm + L

Q: Olaf is standing on a sheet of ice that covers the football stadium parking lot in Buffalo, New…

Q: Each sketch below shows three objects with an electric charge. In each case, decide whether there is…

Q: Consider a horizontal pinball launcher as shown in the diagram below. The 80.6 g ball with a radius…

Q: Let R1 = 94 ohms, R2 = 22 ohms, and R3 = 46 ohms. R2 and R3 are connected in parallel, and then that…

A: Given value--- R1 = 94 ohms. R2 = 22 ohms. R3 = 46 ohms. Given value--- total resistance?

Q: 9 53 63 Question 10 A A motor rotates an axle that is connected to one end of a rod, as shown in the…

Q: hi can you please write this out instead of typing.

Q: Mary applies 76N of force to a box to with an acceleration of 0.6m/s2. She then increases the…

A: We can use Newton's second law of motion, F = ma, to find the mass of the box. For the first…

Q: A hockey puck (m=174 g and v0=2.25 m/s) slides without friction on the ice and hits the rink board…

Q: A 50.0-kg box rests on a horizontal surface. The coefficient of static friction between the box and…

A: Given data: Mass (m) = 50.0 kg Coefficient of static friction (μs) = 0.300 Coefficient of kinetic…

Q: Noninertial frame projectile. A device shoots a small ball horizontally with speed 0.288 m/s from…

A: Basic concepts of Projectile motion: When an object is thrown horizontally it means it has no…

Q: A positive charge q is fixed at point (−4, 3) and a negative charge -q is fixed at point (-4,0).…

Q: Suppose the coefficient of kinetic friction between mA and the plane in the figure is k = 0.10, and…

Q: A car traveling at 53 km/h hits a bridge abutment. A passenger in the car moves forward a distance…

A: Given, Mass, m=38 kg The initial velocity of the car at which the passenger moves forward,…

Q: tA e electron just misses the upper plate as it emerges from the field, find the magnitude of the…

A: Given data: Initial horizontal speed of the electron,v= 1.4× 10⁶ m/s Distance travelled by the…

Q: A 700 ounce object is attached to a 500 ounce object by a strong thread. They hang together over a…

Q: What is the magnitude of the flow speed of the charge carriers (mm/s)? Diameter=1.5 mm I=2.01 A…

Q: A 29.0-kg box is released on a 28∘ incline and accelerates down the incline at 0.30 m/s^2. - Find…

Q: T = 2πtr/V 5 = Δθε 1 rotation = 2π = 360° 9 V=Wr = 9.80 m/s² at/r = Δω/Δ+ A massive spiky metal…

A: Answer the following question is

Q: State how many degrees of freedom the following systems have. In each case indicate appropriate…

Q: A block of mass m = 4.45 kg slides along a horizontal table with speed up = 6.50 m/s. At x = 0, it…

A: Given data: The mass of the block is m=4.45 kg The initial speed of the mass v∘=6.50 m/s The spring…

Q: A car drives around a circular track of diameter 161 m at a constant speed of 47.4 m/s. During the…

A: Given data: Diameter of track, d = 161 m Speed, u = 47.4 m/s Angle turn, θ = 256°

Q: assume that you are studying a cart and mass system. given m1 = 20kg and m2 = 30 kg and theta = 35…

Q: How fast (in rpm) must a centrifuge rotate if a particle 7.50 cm from the axis of rotation is to…

Q: 8. An object (A) of mass mA = 30.5 kg is moving in a direction that makes angle of 60° south of west…

Q: 25. You have two flat metal plates each of area 1.00 m², with which to construct a parallel- plate…

A: Given Area of each plate is A=1.00 m^2 Capacitance of capacitor is C=1.00 F

Q: A bullet of mass (20g) was fired at a speed of (v) at a static piece of wood suspended like a…

Q: The kinetic energy operator in 3-D is: O a. ħ 2m T=- Ob.. T= O d. F2 2 OC. 0₁₁ π = " 2m -h 2m ħ2 →…

A: Note: As per the guidelines, we can only answer first question of multiple question. Sorry for the…

Q: Direction: Describe the intermolecular force/s exhibited on the following liquids 4. An ant…

A: 4. An ant suspended at the surface of the water: The intermolecular force exhibited on the surface…

Q: The plates of a parallel plate capacitor are 2.5 cm apart. Between the plates they create a uni-…

A: Given value--- Separation between plate r = 2.5 cm = 0.025 m . electric field = 525 N/C We have…

Q: Why does charge accumulate on the surface of a polarized dielectric, rather than distributing evenly…

A: For conducting material, the charge is distributed throughout the whole volume. But the dielectric…

Q: What is the capacitance of a metal sphere of radius R?

A: The capacitance of a metal sphere of radius R is C = 4πε₀R. Where ε₀ is permittivity of free space.

Q: 8.1 Potential Energy The only force acting on a particle is conservative force F. If the particle is…

A: According to work energy theorem, work done = - change in potential energy W=-∆UW=-UB-UAW=UA-UB…

Question

Any help with doublechecking my work would be great!

An engine absorbs 422 J of heat and does 113 J of work in each cycle.
1) (a) What is its efficiency?
% Submit
You currently have 0 submissions for this question. Only 10 submission are
You can make 10 more submissions for this question.
2)
(b) How much heat is rejected in each cycle?
J Submit

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Show that the coefficients of performance of refrigerators and heat pumps are related by COPref=COPhp1. Start with the definitions of the COP s and the conservation of energy relationship between Qh, QC, and W.
The Carnot cycle is represented by the temperature-entropy diagram shown below. (a) How much heat is absorbed per cycle at the high-temperature reservoir? (b) How much heat is exhausted per cycle at the low-temperature reservoir? (c) How much work is done per cycle by the engine? (d) What is the efficiency of the engine?
A heat engine operates between two temperatures such that the working substance of the engine absorbs 5000 J of heat from the high-temperature bath and discharges 3000 J to the low-temperature bath. The rest of the energy is converted into mechanical energy of the turbine. Find (a) the amount of work produced by the engine and (b) the efficiency of the engine.
An engine with an efficiency of 0.30 absorbs 500 J of heat per cycle. (a) How much work does it perform per cycle? (b) How much heat does it discharge per cycle?
It is found that an engine discharges 100.0 J while absorbing 125.0 J each cycle of operation. (a) What is the efficiency of the engine? (b) How much work does it perform per cycle?
During one cycle, a refrigerator removes 500 J from a cold reservoir and discharges 800 J to its hot reservoir. (a) What is its coefficient of performance? (b) How much work per cycle does it require to operate?
This problem compares the energy output and heat transfer to the environment by two different types of nuclear power stationsone with the normal efficiency of 34.0%, and another with an improved efficiency of 40.0%. Suppose both have the same heat transfer into the engine in one day. 2.501014J. (a) How much more electrical energy is produced by the more efficient power station? (b) How much less heat transfer occurs to the environment by the more efficient power station? (One type of more ef?cient nuclear power station, the gas—cooled reactor, has not been reliable enough to be economically feasible in spite of its greater eficiency.)
A refrigerator has a coefficient of performance of 3.0. (a) If it requires 200 J of work per cycle, how much heat per cycle does it remove the cold reservoir? (b) How much heat per cycle is discarded to the hot reservoir?
Suppose you build a two-engine device with the exhaust energy output from one heat engine supplying the input energy for a second heat engine. We say that the two engines arc running in series. Let e1 and e2 represent the efficiencies of the two engines. (a) The overall efficiency of the two-engine device is defined as the total work output divided by the energy put into the first engine by heat. Show that the overall efficiency e is given by e=e1+e2e1e2 What If? For parts (b) through (e) that follow, assume the two engines are Carnot engines. Engine 1 operates between temperatures Th and Ti. The gas in engine 2 varies in temperature between Ti and Tc. In terms of the temperatures, (b) what is the efficiency of the combination engine? (c) Does an improvement in net efficiency result from the use of two engines instead of one? (d) What value of the intermediate temperature Ti results in equal work being done by each of the two engines in series? (e) What value of Ti results in each of the two engines in series having the same efficiency?
A freezer has a coefficient of performance of 6.30. It is advertised as using electricity at a rate of 457 kWh/yr. (a) On average, how much energy does it use in a single day? (b) On average, how much energy docs it remove from the refrigerator in a single day? (c) What maximum mass of water at 20.0C could the freezer freeze in a single day? Note: One kilowatt-hour (kWh) is an amount of energy equal to running a 1-kW appliance for one hour.
Two hundred joules of heat are removed from a heat at a temperature of 200 K. What is the entropy change of the reservoir?
An engine between heat reservoirs at 20 and 200 extracts 1000 J per cycle from the hot reservoir. (a) What is the maximum possible work that engine can do per cycle? (b) For this maximum work, how much heat is exhausted to the cold reservoir per cycle?