An ideal parallel-plate capacitor has a capacitance of 78.5 pF. The rectangular plates of the capacitor are 0.235-mm apart and are effectively separated by a vacuum. If a 9.00-V potential difference is applied across the capacitor, what is the resulting magnitude of electric field in between the plates?

An ideal parallel-plate capacitor has a capacitance of 78.5 pF. The rectangular plates of the capacitor are 0.235-mm apart and are effectively separated by a vacuum. If a 9.00-V potential difference is applied across the capacitor, what is the resulting magnitude of electric field in between the plates?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter8: Capacitance

Section: Chapter Questions

Problem 61P: The dielectric to be used in a parallel-plate capacitor has a dielectric constant of 3.60 and a...

See similar textbooks

Similar questions

A 60.0-pF vacuum capacitor has a plate area of 0.010 m2. What is the separation between its plates?
(a) Find the magnitude and direction of the electric field at the position of the 2.00 C charge in Figure P13.13. (b) How would the electric field at that point be affected if the charge there were doubled? Would the magnitude of the electric force be affected?
An electron and a proton, each starting from rest, are accelerated by the same uniform electric field of 200 N/C. Determine the distance and time for each particle to acquire a kinetic energy of 3.21016 J.
A thin conducing plate 2.0 m on a side is given a total charge of 10.0C . (a) What is the electric field 1.0 cm above the plate? (b) What is the force on an electron at this point? (c) Repeat these calculations for a point 2.0 cm above the plate. (d) When the electron moves from 1.0 to 2.0 cm above the plate, how much work is done on it by the electric field?
A double charged ion is accelerated to an energy of 32.0 keV by the electric field between two parallel conducting plates separated by 2.00 cm. What is the electric field strength between the plates?
(a) What is the final speed of an electron accelerated from rest through a voltage of 25.0 MV by a negatively charged Van de Graff terminal? (b) What is unreasonable about this result? (c) Which assumptions are responsible?
Figure CQ16.3 shows equipotential contours in the region of space surrounding two charged conductors. Find (a) the work WAB in electron volts done by the electric force on a proton that moves from point A to point B. Similarly, find (b) WAC, (c) WAD, and (d) WAE. Figure CQ16.3
From a distance of 10 cm, a proton is projected with a speed of v=4.0106 m/s directly at a large, positively charged plate whose charge density is =2.0105 C/m2. (See below.) (a) Does the proton reach the plate? (b) If not, how far from the plate does it turn around?
On a typical clear day, the atmospheric electric field points downward and has a magnitude of approximately 100 N/C. Compare the gravitational and electric forces on a small dust particle of mass 2.01015 g that carries a single electron charge. What is the acceleration (both magnitude and direction) of the dust particle?
A proton is fired from very far away directly at a fixed particle with charge q = 1.28 1018 C. If the initial speed of the proton is 2.4 105 m/s, what is its distance of closest approach to the fixed particle? The mass of a proton is 1.67 1027 kg.
An election enters a region between two large parallel plates made of aluminum separated by a distance of 2.0 cm and kept at a potential difference of 200 V. The electron enters through a small hole in the negative plate and moves toward the positive plate. At the time the electron is near the negative plate, its speed is 4.0103 m/s. Assume the electric field between the plates to be uniform, and find the speed of electron at (a) 0.10 cm, (b) 0.50 cm, (c) 1.0 cm, and (d) 1.5 cm from the negative plate, and (e) immediately before it hits the positive plate.
An electric dipole is located along the y axis as shown in Figure P24.48. The magnitude of its electric dipole moment is defined as p = 2aq. (a) At a point P, which is far from the dipole (r a), show that the electric potential is V=kepcosr2 (b) Calculate the radial component Er and the perpendicular component E of the associated electric field. Note that E = (1/r)(V/). Do these results seem reasonable for (c) = 90 and 0? (d) For r = 0? (e) For the dipole arrangement shown in Figure P24.48, express V in terms of Cartesian coordinates using r = (x2 + y2)1/2 and cos=y(x2+y2)1/2 (f) Using these results and again taking r a, calculate the field components Ex and Ey. Figure P24.48