An isolated 50 Hz synchronous generator is rated at 15 MW which is also maximum continuous power limit of it's prime mover. It is equipped with a speed governor with 5% droop. Initially, the generator is feeding three loads of 4MW each at 50 Hz. One of these loads is programmed to trip permanently if the frequency falls below 48 Hz. If additional load of 3.5 MW is connected, then the frequency will settle down to

An isolated 50 Hz synchronous generator is rated at 15 MW which is also maximum continuous power limit of it's prime mover. It is equipped with a speed governor with 5% droop. Initially, the generator is feeding three loads of 4MW each at 50 Hz. One of these loads is programmed to trip permanently if the frequency falls below 48 Hz. If additional load of 3.5 MW is connected, then the frequency will settle down to

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.7P

See similar textbooks

Similar questions

The load characteristic curve of the DC generator is the relationship between the O Load current and load voltage Generated voltage and field current O Generated voltage and load current O Load voltage and field current
A synchronous generator runs at 250 rpm and generators at 60HZ. There are 240 slots each containing 5 conductors arranged in full-pitched winding for three-phase star connection. All the conductors of each phase are in series and the flux per pole at no-load distributed sinusoidally over the pole pitch is 2.5 x106 Maxwell. What is the emf induced in each winding and the terminal voltage?
What is the operating frequency of a synchronous generator with a power factor of 0.8 and an idle frequency of 62 Hz with a SP of 2MW / Hz and a 2 MW load
To change the direction of rotation of a series wound DC generator the general rule is to
The terminal voltage of a dc series generator running at rated speed and no load is equal to * rated voltage half its rated voltage O zero O a very little voltage
The synchronous generator voltage can be regulated by changing its rotational speed. O True O False
In a synchronous generator * the OC voltage leads the terminal voltage by an angle known as power factor angle the OC voltage lags the terminal voltage by an angle known as power factor angle the OC voltage leads the terminal voltage by an angle known as power angle the open-circuit voltage (OC) lags the terminal voltage by an angle known as power angle
If the number of poles is constant, how to control on the generated frequency of 3 phase synchronous generators.
An ideal dc generator has regulation of 40% 20% O 30% Zero
tal The DC generator has both shunt and series field winding which wound on to the same poles. O Shunt Series Compound O separately excited Fearch
Permanent-split capacitor motor is in effect a 2-phase motor and at no load could attain the synchronous speed. True False
The emf induced in the dc generator armature winding is * O AC and DC O DC O None of the above O AC