An RC circuit includes a 2-k N resistor, a battery with emf of 12.0 V and a capacitor. At t = 0 the switch is closed, and the charging of the capacitor begins. Knowing that the time constant of the circuit is measured to be 1 ms calculate: (a) the capacitance of the capacitor; (b) the time it takes for the voltage across the resistor to reach 4 V, and (c) the charge accumulated on the capacitor during this time interval.

An RC circuit includes a 2-k N resistor, a battery with emf of 12.0 V and a capacitor. At t = 0 the switch is closed, and the charging of the capacitor begins. Knowing that the time constant of the circuit is measured to be 1 ms calculate: (a) the capacitance of the capacitor; (b) the time it takes for the voltage across the resistor to reach 4 V, and (c) the charge accumulated on the capacitor during this time interval.

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter21: Current And Direct Current Circuits

Section: Chapter Questions

Problem 67P: The values of the components in a simple series RC circuit containing a switch (Fig. P21.53) are C =...

See similar textbooks

Similar questions

A capacitor with initial charge Q0 is connected across a resistor R at time t = 0. The separation between the plates of the capacitor changes as d = d0/(1 + t) for 0 t 1 s. Find an expression for the voltage drop across the capacitor as a function of time.
An ECG monitor must have an KC time constant lessthan 1.00102s to be able to measure variations involtage oversmall time intervals, (a) If the resistance of the circuit (duemostly to that of the patient's chest) is 1.00kTwhat is the maximum capacitance of the circuit?(b) Would It be difficult in practice to limit the capacitance to less than the value found in (a)?
The values of the components in a simple series RC circuit containing a switch (Fig. P21.53) are C = 1.00 F, R = 2.00 106 , and = 10.0 V. At the instant 10.0 s after the switch is closed, calculate (a) the charge on the capacitor, (b) the current in the resistor, (c) the rate at which energy is being stored in the capacitor, and (d) the rate at which energy is being delivered by the battery.
Figure 21.55 shows how a bleeder resistor is used to discharge a capacitor after an electronic device is shut off allowing a person to work on the electronics with less risk of shock, (a) What is the time constant? (b) How long will it take to reduce the voltage on the capacitor to 0.250% (5% of 5%) of its full value once discharge begins? (c) If the capacitor is charged to a voltage V0through a 100-O resistance, calculate the time it takes to rise to 0.865V0(This is about two time constants.)
The timing device in an automobile’s intermittent wiper system is based on an RC time constant and utilizes 0.5.00F capacitor and available resistor. Over what range must R be made to vary to achieve time constants from 2.00 to 15.0 s?
Figure P29.60 shows a simple RC circuit with a 2.50-F capacitor, a 3.50-M resistor, a 9.00-V emf, and a switch. What are a. the charge on the capacitor, b. the current in the resistor, c. the rate at which the capacitor is storing energy, and d. the rate at which the battery is delivering energy exactly 7.50 s alter the switch is closed?
A circuit contains a D-cell battery, a switch, a 20- resistor, and three 20-mF capacitors. The capacitors are connected in parallel, and the parallel connection of capacitors are connected in series with the switch, the resistor and the battery, (a) What is die equivalent capacitance of the circuit? (b) What is the KC time constant? (c) How long before the current decreases to 50% of the initial value once the switch is closed?
Power P0 = I0 V0 is delivered to a resistor of resistance R0. If the resistance is doubled (Rnew = 2R0) while the voltage is adjusted such that the current is constant, what are the ratios (a) Pnew/P0 and (b) Vnew/V0? If, instead, the resistance is held constant while Pnew = 2P0, what are the ratios (c) Vnew/V0, and (d) Inew/I0?
Consider a series RC circuit as in Figure P28.38 for which R = 1.00 M, C = 5.00 F, and = 30.0 V. Find (a) the time constant of the circuit and (b) the maximum charge on the capacitor after the switch is thrown closed. (c) Find the current in the resistor 10.0 s after the switch is closed.
Regarding the units involved in the relationship t = RC, verify that the units of resistance times capacitance are time, that is, . F = S.
In the figure shown, the total resistance is 15.0 kΩ and the fem of the battery is 24.0 V.the time constant is measured at 24.0 µs calculate a) the total capacitance of the circuit and b) the time it takes the voltage through the resistor to reach 16.0 V after the switch is closed.
A capacitor is charged with a total charge of q = 8.7E-05 C. The capacitor is wired in series with a resistor, R = 5 Ω. Part (a) Input an expression for the time constant, τ, of this circuit using the variables provided and C for capacitance. τ = Part (b) What is the value of the time constant in s if the capacitor has capacitance of 1.0 μF? τ = Part (c) How long will it take the capacitor to discharge half of its charge in seconds? t =