B се 450 In Fig. 2, the partioles A and B, of mass 8 kg and 6 kg respectively, are connected by a light inextensible string which passes over a smooth pulley fixed at C. A lies on a rough horizontal plane and B lies on a smooth plane inclined at 45° to the horizontal. The coefficient of friction between A and the plane is u. The system is in limiting equilibrium. Find the value of H Given that Bis replaced with another particle of mass 8 kg, find (a) the acceleration of the system, (b) the tension in the string. Fig. 2 (Take g asi0 ms-*) ce

B се 450 In Fig. 2, the partioles A and B, of mass 8 kg and 6 kg respectively, are connected by a light inextensible string which passes over a smooth pulley fixed at C. A lies on a rough horizontal plane and B lies on a smooth plane inclined at 45° to the horizontal. The coefficient of friction between A and the plane is u. The system is in limiting equilibrium. Find the value of H Given that Bis replaced with another particle of mass 8 kg, find (a) the acceleration of the system, (b) the tension in the string. Fig. 2 (Take g asi0 ms-*) ce

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 38P: A uniform horizontal strut weighs 400.0 N. One end of the strut is attached to a hinged support the...

See similar textbooks

Similar questions

A wooden door 2.1 m high and 0.90 m wide is hung by two hinges 1.8 m apart. The lower hinge is 15 cm above the bottom of the door. The center of mass of the door is at its geometric center, and the weight of the door is 260 N, which is supported equally by both hinges. Find the horizontal force exerted by each hinge on the door.
In Example 14.3, we found that one of the steel cables supporting an airplane at the Udvar-Hazy Center was under a tension of 9.30 103 N. Assume the cable has a diameter of 2.30 era and an initial length of 8.00 m before the plane is suspended on the cable. How much longer is the cable when the plane is suspended on it?
A uniform ladder 10.0 m long and weighing 50.0 N rests against a smooth vertical wall. (a) If the ladder is just on the verge of slipping when it makes a 50.0° with the ground, find the coefficient of static friction between the ladder and ground. (b) If the coefficient of static friction is 0.360, and the same ladder makes a angle with respect to the horizontal, how far along the length of 60.0° the ladder can a 65-kg painter climb before the ladder begins to slip?
A uniform ladder of length L and weight w is leaning against a vertical wall. The coefficient of static friction between the ladder and the floor is the same as that between the ladder and the wall. If this coefficient of static friction is μ = 0.435, determine the smallest angle the ladder can make with the floor without slipping. | 0 A 14.0 m uniform ladder weighing 480 N rests against a frictionless wall. The ladder makes a 63.0⁰-angle with the horizontal. (a) Find the horizontal and vertical forces (in N) the ground exerts on the base of the ladder when an 850-N firefighter has climbed 4.10 m along the ladder from the bottom. horizontal force magnitude direction vertical force magnitude direction ---Select--- |---Select--- ✓ N N (b) If the ladder is just on the verge of slipping when the firefighter is 9.40 m from the bottom, what is the coefficient of static friction between ladder and ground? m (c) What If? If oil is spilled on the ground, causing the coefficient of static…
- 5. Two identical, uniform beams of length 3 m and weighing 260 N each are connected at one end by a frictionless hinge. A light horizontal crossbar, attached at the midpoints of the beams maintains an angle 50° between the beams. The beams are suspended from the ceiling by vertical wires so they form a V. See figure. (a) What force does the crossbar exert on each beam? (b) Is the crossbar under compression or tension, i.e. are the ends of the crossbar being pushed together or stretched farther apart? (c) What force (magnitude and direction) does the hinge exert on each beam? Crossbar Hinge
A 10 m long ladder with mass of 20 kg rests against a smooth wall at height of 8 m at an inclination a to the rough ground floor. Assuming that there is no friction between the wall and the ladder, but there is a frictional force between the floor and the ladder. (a) Determine the minimum static coefficient of friction, 4 between the floor and the ladder for which equilibrium is possible. (b) A worker of mass 80 kg climbs up the ladder. Determine how far the worker may go up before the ladder starts to slip. (c) By comparing between frictional force of floor and wall, determine whether a worker can climb safely to the top of the ladder or not.
A 6.0 m long ladder AB leans against a smooth wall making an angle of 60º with the floor (Figure 3). The ladder is uniform and has a mass of 20.0 kg.(a) Determine the forces exerted on the ladder by the floor and the wall (i.e. at A and B, respectively).(b) Determine the minimum value of the coefficient of static friction to prevent the ladder from slipping.
A 5.00 m, uniform 20 kg ladder rests on a wall, making an angle of 55◦to the ground. There is no frictionalong the wall, but a coefficient of friction of 0.300 along the ground. How high can a 75.0 kg personclimb the ladder without it slipping?
A uniform ladder of length L and weight w is leaning against avertical wall. The coefficient of static friction between the ladderand the floor is the same as that between the ladder andthe wall. If this coefficient of static friction is μs = 0.500, determinethe smallest angle the ladder can make with the floorwithout slipping.
A safe mass M = 430kg hangs by a rope from a boom has a mass m = 85kg. Find the tension T, in the cable and the magnitude of the net force exerted on the beam by the hinge. Cable Rope (a) Hinge Beam com
A uniform ladder of mass 35 kg and L=7m long is placed against a vertical wall at an angle of 68 degrees with respect to the floor. The coefficient of friction between the ladder and wall is 0.33 and that between the ladder and the floor is 0.48. Find how high a man of mass 84.5kg can ascend; before the ladder begins to slip.
a 1001 N uniform beam is attached to a vertical wall at one end and js supported by a cable at the other end 1550 N crate hangs from the far end of the beam find the magnitude if the tension in the wire the angle theta is 21 degrees and phi is 32 degrees length of beam is L