(B) The 800-kg car at B is connected to the 350-kg car at A by a spring coupling. Determine the stretch in the spring if (a) the wheels of both cars are free to roll and (b) the brakes are applied to all four wheels of car B, causing the wheels to skid. Take (Hi.)n = 0.4. Neglect the mass of the wheels. See figure (2)

(B) The 800-kg car at B is connected to the 350-kg car at A by a spring coupling. Determine the stretch in the spring if (a) the wheels of both cars are free to roll and (b) the brakes are applied to all four wheels of car B, causing the wheels to skid. Take (Hi.)n = 0.4. Neglect the mass of the wheels. See figure (2)

Name: (B) The 800-kg car at B is connected to the 350-kg car at A by a spri
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: (B) The 800-kg car at B is connected to the 350-kg car at A by a spring coupling.Determine the stretch in the spring if (a) the wheels of both cars are free to roll and (b)the brakes are applied to all four wheels of car B, causing the wheels to ski

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.19P: The 3600-lb car with rear Wheel drive is attempting to tow the 4500-lb crate. The center of gravity...

See similar textbooks

Similar questions

Find the largest value of b/h at which the folding table is in equilibrium. The coefficients of static friction are 0.5 at A and 0.3 at C. Neglect the weight of the table.
The 40-lb spool is suspended from the hanger GA and rests against a vertical wall. The center of gravity of the spool is at G and the weight of the hanger is negligible. The wire wound around the hub of the spool is extracted by pulling its end with the force P. If the coefficient of static friction between the spool and the wall is 0.25, determine the smallest P that will extract the wire.
The 1200-lb homogeneous block is placed on rollers and pushed up the 10 incline at constant speed. Determine the force P and the roller reactions at A and B.
The 3600-lb car with rear Wheel drive is attempting to tow the 4500-lb crate. The center of gravity of the car is at G, and the coefficients of static friction are 0.6 at B and 0.2 at C. Determine if the crate will slide.
End B of the uniform 2.7-kg bar AB is connected to a small roller that moves in a horizontal slot. The other end of the bar is pinned to the homogeneous 1.8-kg disk that rolls without slipping on the vertical surface. The spring attached to A has a free length of 0.3 m and a stiffness of 58 N/m. After the system is becomes horizontal. Determine the magnitude of the force P that acts on the bar at B. 2.1 m 0.24 m 0.9 m www 1.8 kg 1.5 m 2.7 kg P
The uniform blocks A and B weigh 90lb and 60lb, respectively. The coefficients of static friction at the three contacting surfaces are shown in the figure. Find the maximum value for P in the direction shown which maintains static equilibrium. The sliding surfaces are flat and parallel to the applied force P.
3- Can the system in figure be in static equilibrium in the position shown? The uniform bar AB weight 500 lb, and the weight of block C is 300 lb .Friction at A is negligible and the coefficient of static friction is 0.4 at the other two contact. 10 ft В 30° C 50°
2. Find the horizontal force P to start the motion of any part of the system of three blocks resting upon one another as shown. The weight of the blocks are W-300 KN, Ws= 100 KN and Wc =200 KN. Between A and B μ=0.30, between C and B, μ =0.20 and between C and the ground, p=0.10. 1 sni brod nog 02.0-4 B C 05.0-4 Solution: tamos quoy worla bre sosia asquar 005 300 en of jells400 N₁-300 F3 N-300- N₂=300 Assuming B and C will not move. F₁ = 300 (0.30) F₁ = 90 kN ne à bns A zelboß 1 P = 90 kN es ensla berb hebnu 02.0- y elin 05.0= q V in Celpris orllanimetsa MX 008 Assuming C will not move: al 1st F2=400 (0.20) = 80 kN OTE Bm ribirte F₂ vica Assuming the three blocks move: F3 = 0.10 (600) F3 = 60 kN P=60 KN Least force is 60 kN.
4. The mine car and its contents have a total mass of 6000 kg and a centre of gravity at G. If the coefficient of static friction 10 kN between the wheels and the 0.9 m •G tracks is u = 0.4 when the wheels are locked, find the normal force acting on the front wheels at B and the rear 0.15 m 0.6 m - 1.5 m wheels at A when the brakes at both A and B are locked. Does the car move? [Ans. NA = 16.5 kN, Ng =42.3 kN, the car does not move] %3D lyp
It is required to climb a cylinder one step, rolling without slipping; Said cylinder has a weight W and a radius R. To do this, it is pushed with a horizontal force F, parallel to the floor and directed towards its center as shown in the figure. If the step has a height h = R / 4 the magnitude of the necessary force is:
(B) The 1400 kg coal car with load is being pulled by the weight E as shown in the figure. If the mass of E is 100 kg, determine the corresponding reactions at wheel supports A and B. The wheels are rolling without sliding (i.e. there is no friction force at the wheels). Pulley at D is smooth. 1400 kg 0.4 m I m 0.6 m
The uniform bar is at rest on a smooth half-sphere with radius R = b / 2. In A there is a ball joint and the bar rests at B against the vertical wall without friction. If the length of the bar AB is 4 m, and its weight is W = 200 N, at the midpoint of the bar. Take b = 1.6 m and d = 2.8 m, determine in Newtons: a) The magnitude of the normal force FN of the hemisphere on the bar. b) The magnitude of the normal force FB of the wall on the bar. c) The force AX of the patella on the bar in the X-axis. d) The force AY of the patella on the bar in the Y-axis. e) The force AZ of the patella on the bar in the Z-axis.