Briefly, write the advantages and disadvantages of Delta Modulation ? .Note( Don't copy and paste it)
Q: A cold junction of a themocouple is at room temperature of 83°C. A voltmeter connected to the…
A: The solution is given below
Q: 4. On what variable of the information signal does the distains of the side band oscillation
A: There are infinite sidebands in the frequency modulated signal and these sidebands are equally…
Q: 2. For the cascode amplifier below, determine (a) the base and collector currents of each transistor…
A:
Q: A 2320.2 VA step-down transformer has the following parameters as referred to the primary side:…
A:
Q: please do it correctly.. A system starts with omnidirectional transmit antennas. This produces a…
A:
Q: a) If the opamp is working in the linear region, What is the range of values where V, is working. b)…
A:
Q: 1. A current is given by i = 22.62sin (377t) A. Determine a) maximum value; b) rms value; c)…
A: The solution is given below
Q: 2. Find the inverse Fourier Transform of X (w) with the magnitude and phase spectrum below. |X(w)|…
A:
Q: Determine Vp(rect), Vr(pp), VDc(filter) and the Ripple factor F 10:1 D3 DI 110 V rms Output V písec)…
A: The given circuit diagram is shown below:
Q: 9.) Given the Star Connection, convert into equivalent Delta Connection and solve for resistance…
A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…
Q: Find the Fourier Traneform of the functions
A:
Q: A system has a complex conjugate root pair of multiplicity two or more in its characteristic…
A:
Q: 4) A synchronous machine has its field winding on the rotor and polyphaser armature winding on the…
A:
Q: 18V 2K Ioss= 8mA 680k 12V W VD= 12 V ll0K 0.68K find; 1- IDQ 2- VS, VDS 3- VP
A: The solution is given below
Q: Given the signal flow graph, apply Mason’s Rule to acquire the single transfer function, G(s).…
A: In this question we need to find a transfer function of the given signal flow graph by using Mason…
Q: A 220-V dc shunt motor runs at 500 rpm, when the armature current is 50 A. Calculate the speed if…
A: Given, Problem regarding to shunt motor. Please find the below attachments for the clear…
Q: What would the resonant frequency of a Wien bridge circuit be if the resistors are 400 KN and…
A:
Q: 1. Simplify the following functions, and implement it using only two input NAND gate. F(S, T, U, V)…
A:
Q: 1. Electric utility installations and equipment under the exclusive control of the utility do not…
A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…
Q: a. Given B =100 re = u.5 and Yo a40k2, Sketch the approxinate hy brid equivalent circuit
A: Please refer the attached images for the complete answer..
Q: 2 1. T (s) = s+2
A: Rise time: This is the time taken by the system to reach 10 percent to 90 percent of its final…
Q: Calculate the output impedance of a current-shunt feedback having gain of -100 and output impedance…
A: In this question we will find output impedance of current shunt feedback...
Q: (b) In the bridge type circuit shown in Fig. QI, the diodes are assumed to be ideal. Assume primary…
A:
Q: What are the maximum and minimum frequencies of a 16-MHz crystal with a stability of 200 ppm? The…
A:
Q: 20 krad/s, K = 5, and Design a notch filter based on Fig. 14.47 for wo Q = 10. Use R = R¡ = 10 k2.
A: Consider the formula for the gain as, K=RfRi Determine the value of the feedback resistance required…
Q: A generator is connected to a resistor and a 0.049-H inductor in series. The rms voltage across the…
A: The solution is given below
Q: What will happen if the back emf drops to zero because the external mechanical load stops the…
A: We need to state What will happen if the back emf drops to zero because the external mechanical load…
Q: Design a voltage to current converter amplifier. Assume that you have 5v input voltage to the…
A: We need to design a voltage to current converter amplifier. Assuming that we have a 5 V input…
Q: For an AM commercial broadcast band receiver (535 kHz to 1605 kHz) with an input filter Q-factor of…
A:
Q: A cold junction of a themocouple is at room temperature of 83°C. A votmeter connected to the…
A:
Q: A copper conductor wire with a total length of 100ft is used in a 15 amp common household circuit…
A: Resistance of the circuit = resistance per meter length × length Given resistance per meter length…
Q: What is the overali efficiency of the solar collector with the following test results? Calculated…
A:
Q: pls answer only the d. e. f.
A:
Q: A perfecty cenducting plane in locatl in free space at X=4 and aunitorm infiaite bire chapge ef 40…
A: Please refer the attached images for the complete answer..
Q: 7) Using Vivado, design a 2-input exclusive-NOR circuit. Obtain the design module, and the test…
A: In this question we have to write the verilog code
Q: Plot the magnitude and phase plot for the following transfer function, use the templates from the…
A: Given,The transfer function is,Hjω=10jω0.01jω+10.1jω+1Here,WE have to draw magnitude and phase…
Q: (a) For the common base circuit shown in Fig. Q2(a), determine Ic and VcB. Assume the transistor to…
A: Please refer the attached images for the complete answer..
Q: 6.) Find the Thevenin's equivalent across 5-ohm resistance (branch AB) and determine its Branch…
A:
Q: NOTE: Show COMPLETE Solution, NO Shortcuts. Thank you so much!
A:
Q: 5. A 15-HP motor operates at full-load from a 600 V, 3-phase, 60 Hz, delta connected source. The…
A: Power: It is the rate per unit time and at this rate electrical energy is transferred by the…
Q: 8- Discuss the effect of increasing the frequency of the input signal on the reconstructed signal at…
A: Disclaimer: “Since you have asked multiple question, we will solve the first question for you. If…
Q: constant current of 3.119A for 4 hours is required to charge an automotive battery. If the terminal…
A: The solution is given below
Q: Q1 R2 R3 VCC R1 Calculate the value of RB in ohms. at VCC=18 V, IB=27 uA, and VC=6V and B=63
A: Solve the first question, unless the student has asked for a specific question to be solved, subject…
Q: IR = 25.620° VeN Iy = 24.5Z-152° Scales: 1cm=5A IB = 18.6Z134° VRN
A: A phasor diagram is given with phase voltage and current values. We need to explain how the phasor…
Q: 2. A discrete-time signal x[n] is shown in Fig. Q2. Sketch and label each of the following: a) x1[n]…
A:
Q: Selp paced 8 * pirst NINE prime uumwbers R3 V = 110 Obtain everything, prow Req P, - Pa. to Rz…
A: Given, We have a circuit. We have to find Req and power P1 - P2 Please find the below attachments…
Q: a- what is the physicalmeaning of system instability? b- All other things being equal, is a system…
A:
Q: What kVA rating is required for a transformer that must handle a maximum load current of 8 A with a…
A: Maximum load current, I = 8 A Secondary voltage, V = 2 kV
Q: 5. Give some practical application for the FM ?*
A: Frequency Modulation: Frequency modulation is a way of encoding information on a signal (analogue or…
Q: Write the expression for an AM voltage wave with the following values: Unmodulated carrier = 20 V,…
A:
Step by step
Solved in 2 steps with 1 images
- Q2: Explain the problems that the delta modulation system suffers from, and compare between the adaptive delta modulation and delta modulation.Q2: Explain the types of error in delta modulation (DM). Q3: Draw the block diagram of delta-sigma modulation system (Transmitter and Receiver). eply...8) In digital communication systems, analog signal input is converted to digital form by three processes which are sampling, quantization quantization and encoding. List out and explain briefly the sampling types.. Ca mal
- Pulse-code modulation (PCM) is the standard form of digital audio in computers, compact discs, digital telephony and other digital audio applications. Figure 3 shows the 3bit PCM system that transmit the 250 kHz analog signal with the voltage range from -6 mV to 6 mV. i) Identify the quantized value, voltage range and binary code for each level by building your own quantization table. ii) Calculate the minimum sampling rate and sampling time. ii) Identify the corresponding sampled voltage, the quantized voltage and binary code if the input signal is sampled at time t1 = 2us, t2 = 4us, t3 = 6us, t4 = 8µs. iv) Sketch the output in (iii) if it is fed to Manchester coding line encoder with bit rate of 20000 bit/sec and amplitude of +4 V. 5 4 3 2 10 Timel(usec) Figure 3 Amplitude (mV)What is meant as baud rate? I don't understand explain in bit details and what's the difference between baud rate and bit rate?1-what is the difference between AM &DSB modulation? 2-Draw & discuss the freq. Spectrum of DSB-SC.? 3-What is B.W of DSB modulation? 4-What is equation of the demodulator ? 5-What are advantages and disadvantages of DSB-SC over DSB-AM?
- (A)- In Differential Pulse Code Modulation (DPCM), Prove that x4(nT,)=x(nT,) +q(nT,) (B)- What are the Advantages and disadvantages of Delta Modulation (DM)A) For the -K FFs shown below. Given the waveforms, Determine the Q output wave (PGT) CK B) Perform each of the following conversions: (0110.0000) BCD =(---s. (11100.1)2= (---- c d1001010) -6 (100010)- (-----)aray cod, (D3.E) 16- (-----) 2 BCD.Solve in digital format please In your words, describe what the signal modulation process consists of.
- Determine the following. a. Forward path gainsb. Loop gainsc. Non touching loopsd. Transfer function output/ inputExplain the data rate (bps), symbol rate, bandwidth and noise. What are the relationship amongthem.2- Discuss the advantages and disadvantages of the delta modulation compared to PCM. 3- What are the factors that affect the slope overload distortion in delta modulation?