Answered: By doing the " Coloumbs Law Lab " how…

By doing the " Coloumbs Law Lab " how do you calculate the electric force on suspended balloon and the charge on each balloon? Can you give an sample calculation

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter2: Basic Electricity

Section: Chapter Questions

Problem 20RQ: What is a proton? Where does it normally exist in an atom, and what is its charge?

See similar textbooks

Related questions

Q: For the network determine the unknown currents 12 in amperes. Given: IT-8A; I3-2A; R1-902; R2-18; 12…

A: The given circuit is, Here IT=8 A,I3=2 A,R1=9 Ω,R2=18 Ω.

Q: Find the angular velocity of a waveform with a frequency of a. 100 Hz. b. 0.25 kHz.

A: a) Given, Frequency, f=100 Hz.

Q: Determine the conductance of 200 feet of aluminum bus bar (at a temperature of 20 degrees celcius)…

A: Conductance refers to the simplicity with which an electric current may go through materials such as…

Q: Why it didnt use a wye or delta transformation?

Q: The value 1.2 x 10-6 can be expressed as O 1.2 μ or micro O 1.2 M or Meg O 0.00012 O 1.6 E2

A: Given: The given value is 1.2×10-6.

Q: 1. Are the following signals si(t) and $2(t) orthogonal over the interval [0, 2]? Justify your…

Q: Calculate the output voltage swing. Vin A B 10 V D -14.3 V 14.3 V C) 5.7 V 20 V -10 V + Vin DESIGN…

Q: MAKE A CONCLUSION FOR THIS (8 SENTENCES ONLY) The content must be the connection of resistor color…

A: According to the question, for the given resistor color code and measurements as shown below, We…

Q: O-A 400 V. 15 kW, 4 pole, 50 Hz, Y-connected induction motor has full load slip of 4%. The output…

A: We need to find out the torque of the given Motor , first we will find out speed then we will find…

Q: If the ratio of outer conductor diameter to inner conductor diameter of an air-insulated coaxial…

A: Given: The ratio of outer conductor diameter to inner conductor diameter, ba=7.39.

Q: 7. a. Determine V₁, I₁, Iz, and I for the network Fig. 2.186 if R₂ = 1802. Rs 20 V 10 IR 220 22 Vz =…

A: We need to find out the voltage, current for given circuit. For the given voltage regulated circuit…

Q: 1. Each R is 10 ohms. Find R T and IT. 60V( +1 $7

A: Given: Required: RT and IT.

Q: Calculate the power factor in Delta connected load. If the phase voltage at the load is 200 V and…

Q: When a 4.7 uF capacitor is connected to a 1 kHz source, what is its capacitive reactance? A. 4.7…

Q: Two loads are connected in parallel to a source of emf whose voltage is (110 + j63.5). if the branch…

A: In this question, We need to determine the total current, equivalent impedance, total power and…

Q: 3. J-KL (K+LM) + (M+LM) X-(A + BC) + (BC) (AC +C)

Q: Answer in 4 sentences only. 3. Why should you not hold the resistor while measuring its resistance?

A: We should not hold the resistor will measuring its resistance.

Q: A 47 kW, 329 V DC shunt generator has an armature and field resistance of 0.02 ohms and 87 ohms…

A: Given data are: The power output of a dc shunt generator, Po=47kW, The terminal voltage of a…

Q: Sf is is the Transistor off 102 VB 20 120 V and -ff 3RL + •+NCE=US Source heak Switching loss at and…

Q: 2. The noise output of a resistor is amplified by a noiseless amplifier having a gain of 60 and a…

Q: A lossless transmission line having 50 characteristic impedance and length is 4 short-circuited at…

Q: Calculate the equivalent admittance Y, for the network in Fig. the current I if Vs = 60/45° V.…

A: In this question, We need to determine the admittance of the given circuit and current I as shown…

Q: R(s) = = = S G(s) s+3 s+4 C(s)

Q: The voltage u (t) = 100 cos (314t + 15°) V is applied to a 100-μF capacitor as shown in Figure. Find…

A: In this question, We need to determine the current in the capacitor as shown the circuit. We know…

Q: An optical fiber has a core refractive index n1=1.5 and a cladding refractive index n2=1.48. the…

Q: A radiograph was produced using 70kVp, 40mAs at 72 inches. How much time is needed to produce the…

A: Given information for the first case, The radio-graph is produced using 70 KVp, 40mAs at 72 inches.…

Q: ➡ A four-pole Series connected generator has a lap connected armature with 728 conductors. If the…

Q: find i and Vx and Vo please i dont have time Vx 12 V + 402 -+ 4 Vx + 2Ω VA 0+ +2VA Vo O

Q: A B D OR C &#x XOR D E F AND G

A: This is the problem of logic gate functions.Here the inputs are A,B,C,D.The intermediate outputs are…

Q: The triggering circuit of thyristor is shown in figure. The thyristor requires a gate current of 10…

A: Given: Vb= 12±4 vIg=10 mA Find: Value of R =?

Q: 2. If the coordinate frame o,x,y,z, is derived from the coordinate frame ooXYoZo about the y-axis…

Q: 8.12 Find the impedance, Z, shown in Fig. of 400 Hz. Z 10 mH m 102 252 ww 10 μF at a frequency

A: Given, Frequency F= 400Hz Inductance L = 10mH Cpacitance C= 10μF

Q: A 120 resistor must carry a maximum current of 25 mA. Its rating should be at least A. 4.8 W B. 150…

A: Given, Resistance, R=120 Ω. Maximum current, Imax=25 mA.

Q: 22 The motor in Fig. 23 drives a hoist, raising a mass m of 800 kg at a uniform rate of 5 m/s. The…

A: Given an electric hoist with following parameters m = 800kg v = 5m/s r = 20cm = 0.2m Calculate…

Q: the truth table above for the original or simplified equation? I need both if possible. Sorry for…

A: Here one of the expert directly written the output F values.So For your understanding purpose i am…

Q: If a transmission line used at 1 GHz has an inductive reactance of 40 ohms and a capacitive…

A: Given, f=1GHz XL=40 ohms XC=10 ohms β = ?

Q: A 25 KVA transformer has 500 turns on the primary and 50 turns on the (5 secondary winding. The…

A: Transformer convert or shifts the same power with low and high voltages on either sides,…

Q: A radiograph is produced using 80kVp and 50mAs at 40 inches. If I change to 90kVp at 72 inches and…

A: The density difference between adjacent areas on a plain radiograph is known as radiographic…

Q: 16V +1 ww 2.0 13 4H

A: Given data, Circuit diagram is given as,

Q: etermine the electrical force of attraction between two balloons with separate charges of +3.5 x 10…

A: Charges can be positive and negative. In electrostatic the charges are in rest. The force between…

Q: A 36- pole alternator is operated at 200 rpm. What frequency is generated?

A: Given data: Pole, P = 36. Speed, Ns = 200 rpm.

Q: A power of 10V was applied across the resistance of 100. What is the current flowing through the…

Q: The current that varies sinusoidally with time. Blank 1

A: Current is defined as rate of flow of electron in a conductor.

Q: (c) An instrumentation amplifier is shown in Fig. 3 VB VA SRg R2 R2 Fig. 3 {R3 w R3 Prove this…

Q: How does a multi-meter measure resistance?

A: The multi-meter is a device that measures various quantities such as resistance, voltage, current…

Q: Draw the Timing diagram for MVI B, 43,i > Fetching the Opcode 06 from the memory 2000μ. > Read the…

A: Solution !!

Q: can you give me 20 types of lamps?

A: Names of the 20 types of the lamps are given below.

Q: An impedance equal to 44∠69º is connected to across a 220 volts source what should be the value of a…

A: Given,Impedance, Z1=44∠69° ΩVoltage, V=220 V

Q: 85. If the current in a 1 k 2 resistor is 2 mA, the potential across the resistor is

A: Given, Current, I=2 mA. Resistance, R=1 kΩ.

Q: 5. In a DC generator, the iron losses at 1000 rpm are 10 kW at a given field current. At a speed of…

Concept explainers

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.

Question

By doing the " Coloumbs Law Lab " how do you calculate the electric force on suspended balloon and the charge on each balloon? Can you give an sample calculation

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Four point charges are placed at corners of a square . At the top left is a charge of - 1 C, at the top right is a charge of - 2 C, at the bottom right is a charge of -3 Cand at the bottom left is a charge of - 4 C. What is the direction of the net electric force due to the four point charges on a positive charge Q located at the center of square ? O due North O due South O Sw O SE
Question 3 a. Some materials exhibit the property of superconductivity under certain conditions. State what is meant by superconductivity and explain the required conditions for the material to become superconducting. b. The diagram below shows the cross-section of a cable consisting of parallel filaments that can be made superconducting, embedded in a cylinder of copper. copper cylinder filament The cross-sectional area of the copper in the cable is 2.28 x 10-7 m². The resistance of the copper in a 1.0 m length of the cable is 0.075 N. Calculate the resistivity of the copper, stating an appropriate unit. State and explain the what happen to the resistance of the cable when the embedded filaments of wire are made superconductive? i.
3. There are four point charges at each corner of a square of side L. Find the magnitude and direction of the force on the charge -2Q in terms of Q and L. Q L -2Q L 3Q L L Q
Particles of charge +75μC, +48μC, and−85μCare placed in a line (asshown in the figure below). The center one is 0.35mfrom each of the others. Calculatethe net force on the negative charge due to the other two.
6. You take a copper wire as shown in the figure, where the cross-section area A doubles between parts 1 and 2 of same length, and apply a potential difference across it so that a current flows from part 1 to 2. What happens in part 2 of the wire, as compared to part 1?" r A) The electron current increases B) The electron density increases C) The resistance increases D) The electric field or drift speed decrease E) The electric field and drift speed decrease E
5) ) The point charge at the bottom of the figure is, Q = 17 nC and the curve is a circular arc, of radius r = 5 cm. What is the magnitude of the force on the charge Q due to the other point charges shown? -6.0 nC 2.0 nC 2.0 nC 45° 45° 5.0 cm 5.0 cm +) Explain or Show Work Here:
(b) Figure 2 shows a plastic rod with a uniform charge -Q. It is bent in a 120° circular arc of radius r and symmetrically aced across an x-axis with the origin at the centre of curvature Pof the rod. Show that electric field, E at point P is given by 0.83Q E = 4T Egr2
b. A piece of pencil lead is connected in series with an ammeter and a power supply. The power supply is turned on. After a few minutes, although the potential difference across the pencil lead does not change, the current in the circuit increases significantly. Explain why the current increases. c. Electric fields are caused by both point charges and by parallel plates with a potential difference across them. Describe the difference between the electric field caused by a point charge and the electric field between parallel plates. Your answer should include a diagram of each type of field and reference to electric field strength. Question 2
give 2 examples of electrostatic devices with explanation
A negative charge q'is located as shown in the figure: a, I. What is the direction of the electric field created by the charge q'at location P? Up Down Left Right b. An electron is placed at location P What is the direction of the electric force on the electron due the charge q'? Up Down Left Right
Charges A andB are placed a distance of 1.5m from one another. The charge of particle A is 0.3 C whereas the charge of particle B is 0.4 C. Charge B experiences an electrostatic force of FB from charge A. Similarly, charge A experiences an electrostatic force of FA from charge B. What is the ratio of FA to FB?
3. Four point charges are placed at the corners of a square of side a, as shown in Figure. 34 29 (a) What is the electric field at the location of charge q? (b) What is the net force on 2g?