Çalculate the current in
Q: QI A 220-V d.c. Machine has an armature resistance of 0.52. If the full-load armature current is 20…
A:
Q: Use source transformations to find the voltage V. 4Ω -j3 2 j4 2 ww rell 20/0° V (+ j2 2 -j2 2 = V,…
A:
Q: (b) An inductive load consisting of resistor, R and inductor, L in series feeding from a 240230°…
A:
Q: Column A Column B 1. VxA = 0 2. .F=0 A. 48 3. â at(2,90',270') С.О D. 5. à, •â atp = 2n 6. The…
A:
Q: A Sine wave has a Peak Voltage of 36V. Determine the voltage after a 135° rotation and the RMS…
A: General expression of V = Vpeak sin(wt) Put wt =135 degree Vrms = Vpeak / 1.414
Q: is zero at t = 0. Assume The initial energy in the circuit of Fig. that v, = 15u(t) V. (a) Find…
A:
Q: Sketch the Bode plot for the following system: 10(s+ 1) (-s+2)(s+5) G(s) = Provide as much…
A: The bode plot of a transfer function helps us to determine the stability of a given control system.…
Q: Using superposition theorem to find the magnitude of the current fl branch AB of the circuit shown.…
A: Solve the problem
Q: 2) Find the transfer function X(s) / F(s) K B M f(t) x(t)
A:
Q: A single loop consists of inductors (L1 = 4.3 mH, L2 = 8.9 mH), capacitors (C, = 2.0 µF, C2 = 5.3…
A: In this question we will find equivalent values of component...
Q: D7.2. A current filament carrying 15 A in the a, direction lies along the entire z axis. Find H in…
A:
Q: A balanced Wheatsone bridge ABCD has the following arm resistances : = 100 N ± 0.5%; Rcp is an…
A:
Q: : Fill in the blanks for the following 1- The three main steps of PCM system are 2- The Nyquist…
A: 1. The three main steps of PCM are Sampling, Quantization and Coding. The given signal should be…
Q: An electric duct heater has a capacity ranging from 0 to 10 kW. The proportional controller signal…
A: Gain: It is the ratio of the amount of the change in the output to the measured variable change that…
Q: hydroelectric power station has a head of 324 m and an average flow of 1370 m/s. The reservoir has…
A: Given, A large hydroelectric power station has, Head, H = 324 m Rate of flow, Q = 1370 m3/s…
Q: For the following ac networks, determine, using the superposition theorem, the ndicated currents.…
A: The superposition theorem states that a circuit with many sources is equal to a circuit with…
Q: Suppose you have an loT device with three modes of operation : -Transmitting: lasting for T =36ms…
A: Transmission is the process of delivering the information or data to a particular destination.…
Q: 3. Referring to the network below determines DC analysis to get ro and calculate amplifier parameter…
A: The required parameters can be calculated by using DC and AC analysis of the amplifier circuit.
Q: + + vdt) L 5H i(t) (1 0,1F R Vg(t) 10
A:
Q: PROB. 2 2 Uving nodal analysis, determine the value of voltages a models I nd 2 in Fig. 15.23. IV,…
A:
Q: Problem 6 a- Explain the reasons for applying system grounding in electric power systems. Consider…
A: The current flowing through a circuit during a fault condition is called fault current. Fault types…
Q: Example: Simplify y = ln; Vz
A: The solution is given below
Q: (a) Given the transfer function of a continuous-time LTI system, 4s H(s) = s2 + 42 i. Sketch the…
A: As per the guidelines of bartleyby I need to answer first three subparts only so kindly repost other…
Q: 6. Solve the turns ratio of a three-phase transformer to transform 10,000 kVA from 230 kV to 4160 V…
A: In this question we will find turn ratio for different combinations of transformers .....
Q: A 3 phase 6 pole star connected induction machine operates from a 120 V (phase voltage) and 50 Hz…
A: You have asked multiple independent questions. We are authorized to answer one question at a time.…
Q: Home Work 14: A 3-phase, 400 V, 6-pole, 3-phase, 50 Hz, star-connected synchronous motor has a…
A:
Q: 1. Explain the effect of increasing the armature voltage on the behavior of the series wound machine…
A:
Q: A nuclear power station delivers 1 GW of electricity for a year from uranium fission. Given that a…
A: Given A nuclear power station delivers 1 GW of electricity for a year from uranium fission. Given…
Q: 18.31 The h parameters for the two-port amplifier circuit in Fig. P18.31 are h1 = 500 N; h12 10-3,…
A:
Q: QUESTION 3 Determine Vol and Vo2 for the networks of Figure 3. Si Ge Si 4.7 k2 1.2 k2 +12 Vo -10 Vo…
A:
Q: In 3-Phase circuit shown, finct th currentdistribution ithe ABC Phase sequence 4 Supply Voltag =…
A:
Q: Find the transfer function H(s) = I,(s)/I,(s) in the circuit of Fig. 16.18. 12 12 2s V(s) 4 2 Figure…
A:
Q: EXAMPLE 18.4 For the network in Fig. 18.12, determine the sinu- soidal expression for the voltage u,…
A:
Q: c) Draw and explain a grid network from generation to street mains, using a 11kV ring.
A: Types of Distribution Radial distribution system Loop distribution system ( Ring) Network…
Q: Jsing the impulse-invariant design method, design a DT system to approximate the CT systems vith the…
A:
Q: The modulation index of the modulated waveform shown below is Amplitude 2.5 0.75 0.75 -2.5 Time O a.…
A: In this question, We need to choose the correct options What is modulation index?
Q: (b) A radio station that radiates from a point source transmits a 10-kW signal. It operates at 100…
A: Antenna- Metal device, which captures and transmits radio electromagnetic waves. it is know as…
Q: 1. Referring to Figure Q1, apply Mesh Analysis to calculate current (I) for each loop by applying…
A: The solution is given below
Q: D7.3. Express the value of H in rectangular components at P(0, 0.2, 0) in the field of: (a) a…
A: Rectangular Components: "Rectangular vector components are defined as the sections of a vector that…
Q: c) A 35 kVA, 415/240 V, 50 Hz single-phase transformer has the follo R1 = 0.16 Q R2 = 0.0852 Rc =…
A: It is given that: P=27 KW=27×103 Wcosϕ=0.85P2=240 VR1=0.16 ΩR2=0.085 ΩRc=240 ΩX1=0.30 ΩX2=0.15…
Q: a) Explain mathematically how to covert impedance Z per unit using new MVA and kV bas values. b) A…
A: In this question we will write how we will convert impedance from old MVA and KV to new MVA and…
Q: 1. For 8-bit binary numbers: a. Compute 125-75 using 2's complement to represent negative numbers.…
A:
Q: Let x.(t) be aperiodic continuous-time signal x(n) = Acos(20071) + Bcos(500ra) That is sampled with…
A: We need to find out Fourier series coefficient for given signal
Q: A high voltage 3 phase induction motor operating at rated power can be represented by a balanced…
A: You have asked multiple independent questions. We are authorized to answer one question at a time.…
Q: 0.6. - 0.1 A g" 02 Ag - 0.3 A g* – 0,4 A g" - 0.5 A g 65 Sq.waves of Mno2 0.5- 0.4. 0.3- 0.2- 0.1.…
A: Galvanostatic charge discharge curve: The galvanostatic charge and discharge is performed in a…
Q: Homework: A DM system designed to operate at 3 times the Nyquist rate for a signal with a 3 kHz…
A: In this question we will find maximum amplitudes so that modulator doesn't show slope…
Q: Solue For It ,VT and Power. (o mr 20ml 7may 8. 20 mh 20 V 2012
A: Power in resister: The power in the resister is calculated by the formula of I2R and this power is…
Q: Problem: Determine the frequancy for the circuit shown C = 5µF %3D Xc = 256 0
A: We need to find out the frequency.
Q: Q2) Consider a digital communication system that transmits information via QAM over a voice-band…
A:
Q: 064. The natural frequency and damping ratio of the control system with the following transfer…
A:
Step by step
Solved in 3 steps with 3 images
- NOTE: Solve this as soon as possible, I need this urgently. Determine the currents I, and I, in the circuit below 6 mA 1.51 1 mA2. The SONEL thermal plant in Limbe supplies SONARA with 1.0 MV at a p.d of 1.0 x 104v The total resistance between the power station and the factory is 0.52. a. What is the power output of the thermal plant b. Explain why the power station output voltage is always stepped up before transmission over a long distanceThe circuit shown below is an example of a simple voltage regulator. Determine the current through R1 in mA. Assume the following values for the resistors: R1 = 14 k0, R2 = 12 k0. Express your answer using three decimal places. Assume the opamp is ideal and Q1's ß is infinity. Q1 VCC Vref NPN U1 OUT 20V 1.2V R1 R2 ww
- Find the current in i in the electrical circuit below 54 k0 SV a. 15uA Ob.20u A c.25JA Od25pA A Moving to another question will save this response. mc021-1jpg: mc030-2jpg mc024-3 pg Verified Venfied 1:07 2021 Pr ENSolve 2,3 only.Note the load resistance is 10 ohm and frequency 60 HzConsider a step pn junction made of silicon. The p- and n-sides are doped such that Ec – EF = 0.21 eV on the n-side and EF – Ev = 0.18 eV on the p-side. The pn junction is under zero bias and kept at T = 300 K. Find the doping density in the n-side in unit of cm
- An aluminum wire 5m long and 2mm diameter is connected in parallel with a copper wire 3m long. The total current is 4 A and that in the aluminum wire is 2.5 A. Find the diametre of the copper wire. The resistivity of copper wire being 1.7 micro ohm meter and that of aluminum taken Al 2.6 micro ohm meterThe circuit shown below is an example of a simple voltage regulator. Determine the current through R1 in mA. Assume the following values for the resistors: R1 = 11 kQ, R2 = 20 kQ. Express your answer using three decimal places. Assume the opamp is ideal and Q1's B is infinity. Q1 VCC Vref NPN U1 OUT 20V 1.2V R1 R2 wW WWD4. All batteries in the infinite chain shown in the figure have emf E and internal resistance r (see figure). Find the resultant emf and internal resistance across A and B
- Q1: For the circuits shown in figures. If the temperature has changed from 25°C to 65°C, find Alc. Ic=1.5mA at 25°C. +Vcc 25°C 65°C 1k Vo 55 70 10k Ico InA 16nA 2.2k VBE 0.6 0.5 -VEE2.b. Find the indicated unknown currents in the circuits shown below. SA/ 3 A 2 A 14 ANOTE: Solve this as soon as possible, I need this urgently. Determine the currents Iy and I, in the circuit below 6 mA 1.51 1 mA