Calculate the EER rating of a 20 ton (240000 Btu) air conditioning unit with anaverage electrical load of 30 kW.An air conditioning plant supplies air to a room at a rate of 2.5 kg/s, the supplyair being made up of equal parts by weight of outdoor and recirculated air. Themixed air passes through a cooler coil fitted with a by-pass duct, face and by passdampers being used for humidity control. The air then passes through an afterheater and supply fan. In a test on the plant, the following conditions (Table Qu4) were recorded;3Table Qu. 4: Parameters recordedRelative humidityDry bulbtemperature°CWet bulbtemperature°C%Outdoor air27020.5Room air21050Supply airAir leaving cooler16011.88090coilMake neat sketches showing the plant arrangement and the psychrometric cycle andidentify the corresponding points on both diagrams.Calculate the following;mass of air through the cooler coilload on cooler coilload on heater

given that , BTU=240000 electric load =30kW =30000W we know that , EER(energy…

Answered: Calculate the EER rating of a 20 ton…

Engineering

Mechanical Engineering

Calculate the EER rating of a 20 ton (240000 Btu) air conditioning unit with an average electrical load of 30 kW.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter40: Typical Operating Conditions

Section: Chapter Questions

Problem 1RQ: The standard design conditions for air-conditioning systems established by the Air-Conditioning,...

See similar textbooks

Similar questions

your A bank of 120-employees is maintained at 24°C db and 50% RH. The heat gain due to heat transfer through walls, roof, ..etc is 10 kW. The outside air temperature is 35°C and its relative humidity is 60%. Calculate the followings: (a) Ventilation air required. (b) Sensible and latent heat gains due to occupants. (CLF = 0.86) (c) Volumetric flow rate of supply air if the supply temperature is 18°C. (d) Volumetric flow rate of moisture removed. (e) Sensible heat ratio of the theater. (f) Relative humidity of the supply air
Q.2//B// Give the reasons for each of the following: 1- Why use waste heat in air conditioning system? 2- Why during winter season the temperature of supply air must be above form room condition space? 3- Why calculate the metabolic rate of the occupants? 4- Why during the sensible heating process, the relative humidity increase? 5- Why during cooling and de-humidification process involves both latent and sensible heat transfer processes? "20min"
าา 3.15.) In air conditioning unit, 71,000 cfm at 80'F dry bulb 60% th and standard atmospheric pressure, enter the unit. The air leaves the wait at 57°F dry bulb and 90% relative humidity. Calculate the following a.) Cooling capacity of the air conditioning unit, in Btu/h 6.) rate of water removal from the unit. (.) sensible heat load on the conditioner, in Btu/h di) latent heat load on the conditioning in Blu/h e.) The dew point of the air leaving the conditioner.
An auditorium scats 1,500 persons. The inside design condition is 26°C dry bulb and 17°C we bulb temperatures. The outside dry bulb temperature is 35°C and the relative humidity is 50% The heat gain rate due to walls; roof, windows, etc. is 35 kW. The light power is 15 kW and the (CLF)L, is 0.82. Calculate the followings: (a) Mass flow rate of ventilation air required. (b) Cooling load due to ventilation air. (c) Total heating load due to occupants for evening show, assuning (CLF)oce. = 0.76. (d) Relative humidity inside the auditorium. (e) Maximum relative humidity allowed for comfort if the inside dry bulb temperature is to be maintained at 26°C. (f) Sensible heat ratio of the auditorium.
/ A hall is to be maintained at (20 °C DBT, 60 % RH) when the outdoor conditions are (40 °C DBT, 26 °C WBT). With the following conditions: Sensible heat load in the room Latent heat load in the room 66000 kJ/hr 20000 kJ/hr 30 m/min 5 °C Infiltrated air Apparatus dew point temperature. If the 60 % of the total air is recirculated from the hall and is mixed with the conditioned air after the cooling coil. Find the following: 1-The conditions of air leaving the conditioner. 2- Mass of fresh air entering the cooler. 3- Bypass factor of the cooling coil. 4- The refrigeration capacity of the cooling coil in the tons of refrigeration o 0a DDT
Air enters a coil in the air-handling unit (AHU) at dry-bulb temperature (Id) of 40 oC, and wet- bulb temperature (Tw) of 26 oC. The air leaves the coil at dry-bulb temperature (Td) of 12 oC, and relative humidity of 80%. This process is: Note: You need to use the psychrometric chart. O Cooling and humidification, and the air looses 50 kJ/kg of energy. O Heating and humidification and the air gains 110 kl/kg of energy. O Evaporative cooling and the air neither looses nor gains energy. O Cooling and dehumidification and the air looses 50 kl/kg of energy.
IDENTIFY THE FF: AIRCONDITIONING AND VENTILATION 1. Acts as a master controller which keeps the system inautomatic operation2. Adds heat to a fluid3. Ratio of the actual partial pressure of the watervapor in a space to the saturation pressure of purewater at the same temperature.4. Also known as the heat content of air-vapormixture5. Temperature as read on an ordinary temperature6. Temperature where in water will start to condense7. Equipment that removes heat8. Is the process of treating air9. Their purpose is to create atmospheric conditionsfavorable to human health, comfort and efficiency.10. The system is to maintain indoor conditions forwinter season
Exercise-47: It is required maintain an air conditioned hall at DBT=28 °C, and WBT=20 °C, Q = 45.4 kW, Q = 16.5 kW. Outside air at DBT=39°C, and WBT=28 °C is mixed with the return air is ratio of (1/4) by volume and then mixture is passed through a cooling coil with apparatus dew point temperature of 9 °C, determine; the temperature of the air after the cooling coil, volume flow rate of air supplied to the hall, BPF, cooling coil load, plot the processes of the system.
Exercise 17.5 Air is being drawn over the cold surface of the cooling coil of an air conditioning unit. If 10 m/min enters the air conditioner, calculate the mass flow rate of the condensed moisture, given that the air enters at 20°C and 70% relative humid- ity and exits at 12°C dry bulb temperature and 90% relative humidity. Calcu- late the refrigeration capacity of the coil in W and Btu/h. Solution Step 1 Draw the process diagram: ma ma W; H. H
For an office building the outdoor design condilions are 45°C dbl and humidity ratio. of G.015. The indoor design conditions are 25°C dbl and 0.01 humidity ratio. The supply air slale is 15°C dbl and 0.007 humidily ratio. Il the supply air flow rate is 1000 m/min and fresh air flow rate is 100 m/min, room sensible and room lalent heat loads are, respeclively.
The air, supplied at the rate of 249.57 gal per second to refrigerated coil, has a saturation humidity of 280 grains water per lb dry air and 13.5% RH. The estimated water flow rate of air entering the refrigerated coil in lb/min is A. 2.32B. 4.71C. 6.25D. 10.31
Quest Air (at atmospheric pressure) at a day bulb temp. an of 40°c and wet bulb temp. of 20°℃ is humidified in air washer operating with continuous water recirculation. The wet bulb depression the exif is 25% of that at theindet The day bulb temperature at the exit of the air washer is ? at