Choose all of the processes from below which describe changes which are independent of the path by which the change occurs. the elevation increase experienced by a traveller travelling from Grand Isle, LA to Denver, Colorado ☐ the effort required to capture a tiger in the wild the enthalpy released by the combustion of a gallon of gasoline the potential energy gained by a satellite as it is shot into a specific orbit the work generated by the body of an athlete as it metabolizes the sucrose in a cube of sugar the distance travelled by a steer in a rodeo attempting to evade capture the heat generated by a chemical reaction carried out at constant temperature and pressure

Choose all of the processes from below which describe changes which are independent of the path by which the change occurs. the elevation increase experienced by a traveller travelling from Grand Isle, LA to Denver, Colorado ☐ the effort required to capture a tiger in the wild the enthalpy released by the combustion of a gallon of gasoline the potential energy gained by a satellite as it is shot into a specific orbit the work generated by the body of an athlete as it metabolizes the sucrose in a cube of sugar the distance travelled by a steer in a rodeo attempting to evade capture the heat generated by a chemical reaction carried out at constant temperature and pressure

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter5: Temperature And Heat

Section: Chapter Questions

Problem 14Q

See similar textbooks

Similar questions

Topic: Thermodynamic Measurements and Quantities 2.) 5. An Olympic-size pool is 50.0 m long and 25.0 m wide. How many gallons of water (density = 1.0 g/mL) is needed to fill the pool to an average depth of 4.8 ft?
Suppose that the average U.S. household uses 10100 kWh10100 kWh (kilowatt‑hours) of energy in a year. If the average rate of energy consumed by the house was instead diverted to lift a 1.80×103 kg car 11.3 m into the air, how long would it take? 1. car: ______ seconds? Using the same rate of energy consumption, how long would it take to lift a loaded Boeing 747 airplane, with a mass of 4.10×105 kg, to a cruising altitude of 9.92 km? 2. airplane: ______ seconds?
Give three applications of thermodynamics in daily life.
Sweating is one of the main mechanisms with which the body dissipates heat. Sweat evaporates with a latent heat of 2,430 kJ/kg at body temperature, and the body can produce as much as 1.6 kg of sweat per hour. If sweating were the only heat dissipation mechanism, what would be the maximum sustainable metabolic rate, in watts, if 81% of the energy used by the body goes into waste heat? __________________W
Direction: Solve the following problems. Please box your final answer and write your solution clearly. A cargo ship has tanks for carrying fuel oil. The oil is measured in barrels, while the tank dimensions are in meters, 1m x 5m x 15m. How many barrels does the tank hold? How many gallons? (42 gal = 1 barrel) In a non-flow process carried out 5.4 kg substance, there was a specified internal energy decrease of 50 kJ/kg and a work transfer of the substance of 8.5 kJ/kg. Determine the heat transfer and a state whether it is gain or loss.
Explain the 3 principal dynamic components of molecular kinetic energy?
Heating The amount of chemical potential energy stored in one gallon of heating oil is approximately 130 MJ. This is the amount of energy released as heat during combustion. (Note: 1.0 kWh = 3600 kW-sec = 3600 kJ = 3.6 MJ. Verify this equivalency and use it to answer the following question.) a. Suppose that during the winter, heating your home with oil may require an average of 6 gallons of oil per day. Assuming that to be the case, what is the average daily energy consumption? (Express your answer in kWh.) b. If the cost of heating oil is $3.00/gallon, what is the daily cost to heat your home? Use this information to find the cost of heating with oil in units of cents/kWh.
Thermodynamics. Describe the principles of the following instruments used for accuratemeasurement of temperature. In your answer, draw diagrams showing thesetup for each instrument, state the temperature range in which they are usefuland give one important advantage of each instrument.(a) Magnetic thermometer(b) Optical pyrometer(c) Vapor pressure thermometer
The piston cylinder set shown in Figure 01 contains 1 liter of water at 105 ºC with a titer equal to 0.85 (% steam = 85.00%). When the assembly is heated, the piston moves and when it meets the spring the volume is equal to 1.5 liters. Heating continues until the temperature reaches 600 ºC. Knowing that the piston diameter is 150 mm and that the spring constant is 100 N / mm. Calculate: a) The pressure in the water at the end of the process.b) The total work done.c) The amount of heat transferred to heat the system from 105 ºC to 600 ºC.
A 45-kg person drinks 5.6 × 102 g of milk, which has a caloric value of approximately 3.0 kJ/g. If only 17 percent of the energy in milk is converted to mechanical work, how high (in meters) can the person climb based on this energy intake? Enter your answer in scientific notation. Hint: The work done in ascending is given by mgh, where m is the mass (in kg), g is the gravitational acceleration (9.8 m/s2), and h is the height (in meters).
An unknown metal is heated and placed in a beaker of room temperature water. After a few seconds, the temperature of the water is raised from 20.0°C to 55.0°C. If 3.50 x 103 J of thermal energy is absorbed by the water, calculate the mass of water in grams. Record your rounded three-digit numeric response in the blank space below. Mass of water (g): A/ Note: Do not include units in your answer. con
Determination of the amount of theoretical thermal energy (heat) transferred to 1 litre of water (usefulenergy output). Please watch the videos before attempting the following.a) What is the specific heat capacity of water?_________________________b) Calculate the thermal energy (Q) transferred to a litre of water when you are using a domestic kettle to boil the water, given the following equation:and assuming the following:? = ??∆?Equation 1Initial Temperature, Ti = 20 °C, Final temperature, Tf = 100 °C, 1 litre of water ≈ 1kg of water. Show all your calculations.____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________c) Comment on the assumptions and approximations that you have made. _____________________________________________________________________…