D5.4. A copper conductor has a diameter of 0.6 in. and it is 1200 ft long. Assume that it carries a total de current of 50 A. (a) Find the total resistance of the conductor. (b) What current density exists in it? (c) What is the de voltage between the conductor ends? (d) How much power is dissipated in the wire?

D5.4. A copper conductor has a diameter of 0.6 in. and it is 1200 ft long. Assume that it carries a total de current of 50 A. (a) Find the total resistance of the conductor. (b) What current density exists in it? (c) What is the de voltage between the conductor ends? (d) How much power is dissipated in the wire?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.17P: Determine the GMR of each of the unconventional stranded conductors shown in Figure 4.30. All...

See similar textbooks

Similar questions

5. What is the resistance of a copper bus-bar with the dimensions shown figure below.
I changed the wire material from copper to aluminum to string refer to the figures below. Can you explain the difference of the three materials? There are overload that happened.
QUESTION 2 a) The total AAC cross sectional area is 544.7522 x 106 m2. Each strands having a radius of 0.34 cm and length of conductor is 2 m. Assume that the increase in resistance due to spiraling is 1.4 %. Given the resistivity of AAC at 20 °C is 2.83 x 10* Qm and T = 228 °C. Determine the total composed strands and DC resistance at 30 °C. b) Figure 2 shows the configuration of a single-phase two-conductor in the transmission line. Calculate the total inductance "Ltotal" of the line. (Given, rx = 0.02 m and ry-0.03 m) 3' 1.20 m 0.22 m 2.09 m 0.44 m 2" Conductor 'x' Conductor 'y' Figure 2
What do the conductors have in common? What do the insulators have in common?
Figure Q1(a) shows a piece of ferromagnetic core with magnetic flux (B) with circular current (I) around the core. Figure Q1(b) show laminated ferromagnetic core with the same magnetic flux (B) and circular currents. With the aid of diagrams, explain how the current as highlighted in red (I) is developed in the ferromagnetic core in Figure Q1(a). B (a) (b) Figure 1(a) A ferromagnetic core and (b) laminated ferromagnetic core
A 2-wire d.c. ring distributor is 300 m long and is fed at 240 V at point A. At point B, 150 m from A, a load of 120 A is taken and at C, 100 m in the opposite direction, a load of 80 A is taken. If the resistance per 100 m of single conductor is 0.030. find: (i) current in each section of distributor (ii) voltage at points B and C.
Describe what will happen to the current flow through a conductor given the following changes in properties: a) Increase in electrical resistivity -b) Decrease in electrical conductivity -c) Increase of temperature -d) Decrease in length -e) Thinning -
D5.4. A copper conductor has a diameter of 0.6 in. and it is 1200 ft long. Assume that it carries a total de current of 50 A. (a) Find the total resistance of the conductor. (b) What current density exists in it? (c) What is the de voltage between the conductor ends? (d) How much power is dissipated in the wire?
what is the definition of line charge
H. W.: The cost of a 2-core feeder cable, including installation is (90 a + 20) per meter and the interest and depreciation charges are 10 per cent. The cable is 2 km in length and cost of energy is 4% per unit. The maximum current in the feeder is 250 A and the demand is such that the current copper loss is equivalent to what would be produced by the full flowing for 6 months. If the resistance of a conductor of 1 square cm and 1 km length is 0.173 Q, calculate the most economical cross-sectional area.
What do you calla closed conducting path? A Node B Short circuit C) Loop Junction
The principle operation of LVDT is based on the variation of Select one a. Self inductance b. Reluctance c. Mutual inductance d. Permanence