Determine all the cable tensions and the mass of block E of the system shown below. Use the vector triangle method. D 400 20 60° 50 kg E

Q: 1. The unstretched length of spring AB is 3.3 m . If the block is held in the equilibrium position…

A: Given Data: The spring constant of AB is kAB = 30 N/m. The spring constant of AC is kAC = 20 N/m.…

Q: the 200-kg engine in the position for which e = 30o. The diameter of the pulley at B is negligible (…

A: Given Data m=200 kg

Q: Q I ?- Determine the maximum mass of the lamp that the cord system can support so that no single…

A: TCD TB cos45 TA cos53.13 TA sin53.13 θ MAg 300 Given: TA ,TB , TCD and TE should not be more than…

Q: The ball having mass of 50-kg is between two surfaces as shown. There is no friction between. the…

A:

Q: The door has à weight of 200lb and a center of gravity at G. Determine the constant force F that…

A: Given that, Mass of the door, m=200 lb,length of the door, s=12 ft,time to open the door, s=5 sec,…

Q: Q: Body A weights 80 lb and body B weight 100 lb and they are connected by cable and equilibrium.…

A: Given:mass of Body A(mA)=80 lbmass of body B (mB)=100 lbα+β+120°=180°α+β=60°To find :- α and β

Q: Cable AB is 0.5 m long. The unextended length of the spring is 0.4 m. When the 50-kg mass is…

A: The given data are: L=0.5 mm=50 kgΔx=0.45 m-0.4 m=0.05 m Here, L denotes the length, m denotes the…

Q: J. Plot the variation of the maximum weight of the cylinder F for the system to remain in…

A: let the weight of the cylinders E and F in the general case be E and F respectively. As per the…

Q: The horizontal force P 421 N. Determine the normal reaction forces at A and B. The mass of the…

A:

Q: The man pushes The wheelbarrow at a steady speed with a force P= 150 N, which is parallel to the…

A:

Q: Determine all the cable tensions and the mass of block E of the system shown below.

A:

Q: A fixed crane has a mass of 1000 kg and is used to lift a 2400 kg crate. It is held in place by a…

A: Given data:

Q: FIGURE BELOW shows a scale constructed using the 10 kg mass of cylinder, the 2 kg pan P, and the…

A:

Q: A fixed crane has a mass of 1000 kg and is used to lift a 2400 kg crate. It is held in place by a…

A: Given: The mass of crane = 1000 kg The mass of crate = 2400 kg…

Q: If cylinders E and F have a mass of 20 kg and 40 kg, respectively, determine the following: 2.1 The…

A:

Q: Determine the force P required to maintain the 200-kg engine in the position for which e = 30o. The…

A:

Q: The mass of the flowerpot is 47 kg . Set x = 2 m and z= 15m  1. Determine the tension developed in…

A:

Q: If block B weighs 0.5kg and block C weighs Ikg, determine the required weight of block D and the…

A: We will use lammi's theorem to solve this question

Q: A spring having original length of L1 is constricted by the 4 cords having length of L2. So, those…

A:

Q: Find the minimum force P to start the motion of any part of the system of three blocks(Fig(3)).

A:

Q: 1. The ball D has a mass of (50D+12.5B) kg. If a force F = 100C + 25A N of is applied horizontally…

A:

Q: B 30° D E

A: Vector is a physical quantity that has magnitude and direction both. Scalar is a physical quantity…

Q: The forces F1 = 500 N, F2 = 400 N, and F3 %3D = 700 N all of which act on point A of the bracket,…

A: Given:              F1 = 500 NF2 = 400 NF3 = 700 N             Angle which force F1 makes with the…

Q: The homogeneous box has mass m. The magnitude of force P is slowly increased until motion occurs.…

A: To obtain the magnitude of the required force P, we will resolve the force P into its horizontal and…

Q: A force of P = 500 N is applied to the 80-kg cart. Determine the reactions at both the wheels at A…

A: Given data as per question force of P = 500 N MASS = 80 kg

Q: Q/For the mass - spring shown, determine the magnitude of the mass m 50 mm. 1 3 kg mass www www...…

A:

Q: 11.) In the figure shown, if u = 0.30 under both blocks and A weighs 400 lb, find the maximum weight…

A:

Q: The 45-kg cylinder is suspended from a clamping collar at C which can be positioned at any…

A: Concept: Lami's theorem: When three coplaner forces impinge on an equilibrium point, each force is…

Q: Determine the displacement (m) of the whole spring system given if the net force applied to the…

A:

Q: At the shown position, the ground reaction forces measured using a force platform are 600N in the…

A: Draw the free-body diagram of the limb.

Q: Determine the driving force and normal force exerted by the partially spiral track on the 200- kg…

A: Find the driving force and normal force on the motorcycle.

Q: equilibrium position (k = 460 N/m) used to stop the block. Find the maximum compression of the…

A:

Q: The homogeneous box has mass m. The magnitude of force P is slowly increased until motion occurs.…

A:

Q: The two springs are identical, with unstretched length 0.4 m. When the 150-kg mass is suspended at…

A:

Q: The electric motor is used to pull a train at a maximum constant speed of 60 km/h. This motor has a…

A:

Q: The homogeneous box has mass m. The magnitude of force P is slowly increased until motion occurs.…

A:

Q: Q4/. If the mass of cylinder A is 50 kg, determine the mass of cylinder C in order to hold the…

A:

Q: Determine the range of values of vo if the balls are to land between points B and C. -7 m- B 12 m…

A:

Q: The grey block D in the sketch has a mass of 100 kg. The blue wedges (B and C) have a mass of 10 kg.…

A:

Q: The horizontal steel shaft has a mass of 360 kg and is suspended by a vertical cable from A and by a…

A:

Q: The drop gate at the end of the trailer has a mass of 1000 kg and mass center at G. If it is…

A: Given data  The drop gate at the end of the trailer has a mass of 1000 kg and mass center at G. If…

Q: A light fixture of negligible mass, has three applied forces acting on it as shown. F,| = 4 kN %D…

A:

Q: The man pushes the 120-lb homogeneous crate with the horizontal force P. Determine the largest…

A: given data weight of crate (W) = 120 lb coefficient of friction (μs) = 0.4 To determine  The…

Q: the 200-kg engine in the position for which e = 30o. The diameter of the pulley at B is * negligible…

A:

Q: (b) The 0.31 Kg mass slides at the shown frictionless wire that lies in a vertical plane. What is…

A:

Q: Determine the maximum mass of the flowerpot that 25 can be supported without exceeding a cable…

A:

Q: shown, determine the smallest mass of block A so that it will prevent sliding motion of B down the…

A:

Q: Block A has a mass of 4 kg and block 8 of 4 kg Neglecting the mass of the pulleys, find the tension…

A:

Q: Each cord can sustain a maximum tension of 700 N .  Determine the largest mass of pipe t

A: GIVEN:

Chemical and Phase Equilibrium

Phase diagrams or equilibrium phase diagrams are the graphical representations that show the phase transformations of the constituting elements with respect to the pressure, temperature, and compositions. The diagrams show the conditions that limit the different phases, namely solid, liquid, and gas. The diagram can also be utilized to verify the relations between the state variables. Most of the phase diagrams are temperature-pressure phase diagrams, with the variable parameter as the composition. Usually other variables such as solubility and pressure parameters are not indicated in the phase diagram. For a one-component system (unary phase diagram), the phase diagram is generally a function of temperature and pressure as the state variables, or temperature and volume. However, for a binary system (two-phase) having two components, the phase diagram is a function of temperature and composition as the state variables only. Coexisting of the different phases of the constituting elements is indicated in the phase diagram. A ternary phase diagram can be characterized by consisting of three phases in equilibrium.