Determine the modified bus admittance matrix by eliminating node 4 for the following one-line impedance diagram. Apply both Matrix Algebra method of node reduction. j0.0133 p.016 j0.0133 2 0.0133 j0.01 jo.01 jo.0133 4 j0.0067 jo.02 16 j0.0216 3 Eg1 O 30.0133 Eg2 6 Eg3

Q: Q2) Find 13 12v 5A

A: Given

Q: Three charges were arranged and held in place in a straight line. The distance between the first two...

A: This question belongs to electro magnetic field theory . It is based on the concept of potential ene...

Q: Due to availability of NAND gate ICs only, design a digital logic circuit for the following function...

A:

Q: 200 nF 5 kN 200 nF Vcc 1 kN -Vcc vo

A:

Q: 20Ω 122 402 R 40Ω I 10A

A:

Q: 4. Find the value of V1, V2 and I from the following circuit. + 12 V - + V - 80 60 V V2 +

A: Given circuit:

Q: We consider a part of an electrical circuit represented in the figure below. The direction of the cu...

A: Since you have asked multiple questions in a single request, we will be answering only the first thr...

Q: The maximum flux density in the core of a 250/3000-volts, 50Hz single-phase transformer is 1.2T. If ...

A:

Q: In a step-up/step-down converter, Vin=12V, Vioad=15V (regulated), Itoad=250mA, Lmin = 150µH, C = 470...

A:

Q: Question 9 In a step-down/step-up (buck/boost) converter, consider alls components to be ideal. Vin=...

A:

Q: Two silicon diodes are connected in parallel and in series with resistor 0.33kohms and a battery of ...

A:

Q: )) The Nyquist Plot of a system G(s) = in a unity feedback loop (Figure 3) is shown in Figure (s+1)²...

A: Answer -

Q: 1. Silicon dioxide can sustain 10 MV/cm electric field. Calculate oxide thickness range for CMOS ICs...

A:

Q: Using the basic identities of Boolean algebra, prove the following: List the identities used at each...

A:

Q: contain energy at a single frequency and are represented by sine waves, whereas contain energy at mu...

A: Generally in the modulation techniques   Carrier Signal contain energy at a single frequency and are...

Q: The noise produced by a resistor is to be amplified by a noiseless amplifier having a voltage gain o...

A:

Q: 4. Find the value of V1, V2 and I from the following circuit. + 12 V - + V 80 60 V

A: Circuit diagram is given as, Voltage across 8 Ω resistance is given 12 V.  

Q: state table and state diagram.

A: For OR gate- y= A+B For AND gate- y= A.B

Q: EP 100 ES Relación = IP 10 IS ES = IS = 3 NP 1000 NS 20,000 EP 150 ES 10 Relación = IP 2 IS, IS = NP...

A: Transformer winding: When the winding is wind on the primary side. This winding is called primary wi...

Q: The capacitance between two plates increases with __________.         Select one: a. Shorter pla...

A:

Q: - For the circuit shown in the Figure below, use superposition to find "v" in terms of R's and sourc...

A: GIVEN: a circuit diagram                            FIND: v in terms of Resistance

Q: What is ripple?

A:

Q: In a step-up converter, Vin=12V, Vioad=24V, Itoad=500mA, Lmin=150¼H, C=470µF and Ss=20kHz. Calculate...

A:

Q: #424 Please help me answer this problem. Choose the correct answer from the given choices. Put wheth...

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: 1. WRITE THE CKT. DIAGRAM OE FOUR BASIC TYPES OF SERIES CKT.

A: Series circuit A Series Circuit occurs when two or more loads are linked in series. If one load or b...

Q: Calculate the DC voltages and currents in the circuit. Find for the current emitter, collector curre...

A:

Q: complement of

A: When we take Function and its compliment  then their multiplication is 0 and their addition is one.

Q: V2 6.0kO V1 30Vpk 50H2 VT 1.Solve IT V1 V2 VT 2.lL and Ir in Polar Form

A:

Q: The volts per turn in a 25-cycle 2400/ 230-volt transformer is 8. Calculate the maximum flux (Maxwe...

A:

Q: Given is a Series-Parallel Circuit or Combination Circuit, find RT or the total resistance of the ci...

A: If Two resistors R1 and R2 are connected in series than equivalent resistance is R1 +R2.  if Two o R...

Q: (b) If the latching current in the circuit shown in Fig. Q2(d) is 4 mA, obtain the minimum width of ...

A: The circuit diagram is shown below, Here,V=100VI=4mAL=0.1H

Q: Please help me answer this problem. Choose the correct answer from the given choices. Put whether yo...

A:

Q: 4 Grve three possible ways to express the function F with eight or fewer literals F = (A,B. C.D)= (0...

A:

Q: . Consider a device connected to an ac power supply. The current leads the voltage by 90°, with the ...

A: (a) Since the current leads the voltage by 90° the given device is capacitor. (b) The angular freque...

Q: 40. Use the Superposition Theorem to calculate the motor terminal voltage for the circuit shown belo...

A:

Q: Color 1st Band 2nd Band 3rd Band Multiplier Tolerance Temperature Coefficient (1st Digit) (2nd Digit...

A: Color coding of resistors is an important part of electronics for calculating the value of resistors...

Q: balanced polyphase system

A: Polyphase system- A combination of two or more than two voltages with same voltage magnitude and fre...

Q: Q3/ A- Design a logic circuit using only NOR gates to implement: F(A,B,C)= (A+B+C)(A+B+C)?

A: The digital circuits can be sequential or combinational circuits. The combinational circuits depend ...

Q: A 50 KVA, 4,400/220 V transformer has r1 =3.54 ohms r2=0.009 ohms, x1 =5.2 ohms and x2 =0.15 ohn Fin...

A:

Q: 1. An inductive circuit takes a current of 15 A at 0.78 pf when connected to a source 250 V, 50 hz m...

A:

Q: >>The band gap of Germanium is 7.32eV at room temperature. Find the maximum wavelength of excitation...

A: We need to find out the wavelength for given energy band gap .

Q: 1. Given : 20 KVA ( instruments on Primary side) 2200/220 V SCT :V = 205 volts OCT: V = 220 volts %3...

A:

Q: A 50 KVA, 4,400/220 V transformer has r, =3.54 ohms, r,=0.009 ohms, X, =5.2 ohms and x, =0.15 ohm. F...

A:

Q: Problem 22: Use mesh analysis to find the current through each resistor. Also find the voltage acros...

A:

Q: The primary current to an ideal transformer rated at 3300/110 V is 5 A. Calculate: (a) the turns rat...

A:

Q: F1 50 V 50 V G 10_AMP D3 D4 T1 V1 220 Vrms 60 Hz 50 v R1 10kQ 50 V 18.33 S1 Key = A Identify the com...

A: GIVEN: A circuit diagram FIND: (1) the components used in the given circuit            (2) voltage a...

Q: 31. Using Millman's theorem find current through RL for the circuit shown below. * R, =9.40 20 V 40 ...

A:

Q: How LVDT transducer may be used to measure pressure using a bourbon tube

A:

Q: 11.a. The total loss in a fiber link is 7.1 dB, the design margin is 1 dB, and the optical budget in...

A: "Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: What is the peak factor of 169sin 377t?

A:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.