Determine the thickness of a 3000 mm long, 75 mm wide copper bus bar required to produce a resistance of 6.88x10–5 Ω

Q: For the following system, if the input X[k]= 8(k+ 1) +2.4k and output Y[k]= 2(k)u[k], the impulse…

A:

Q: The Following Test to a lloku, 2300v, Foure pole, 60t 23 Inductio motor short circuit test V = 268 V…

A:

Q: A cube with sides L is located in such a way that one of its vertices coincides with the origin of…

A:

Q: A ramp input applied to an unity feedback system results in 5% steady state error. The type number…

A:

Q: The output of a transmitter is 100 kW with carrier unmodulated and 118 kW when carrier is modulate…

A: Given, Carrier unmodulated power, Pc=100 kW. Carrier modulated power, Pt=118 kW. Modulation index,…

Q: Q9/G(A,B,C,D,E,F)=(2,3,5,7,22 ,23,32,33,34,35,37,39,52,53,54 ,55)+ dΣ(8,9,10,11,16,17,18,19,60,6…

A:

Q: 8.1 The resistance, inductance, and capacitance in a parallel RLC circuit are 2000, 250 mH, and 10…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Using superposition, find the current through ne 6 2 resistor of the figure beside Ive R₁ +₁₁ 12 02…

A:

Q: 2) 2401 6 A ↑ GA 22 Mar 120 V Find the curent in 22 ww 22 20 Mr 522 22 isl 22

A: We have to find the current i2 in the given circuit

Q: The Z-transform of the following function f[k] = 2.2k +$.(-5)* - 3 (-4)* 33 is 42 so the constants A…

A:

Q: 1. Conditions: Continuous load rated 45A served by a conduit containing only the conductors for the…

A: Note::: you asked multiple questions as per guidelines I solved 1st question only.. remaining…

Q: C(S) 1. Compute the transfer function () for the block diagram given below. 4 pts R(S) R(S) G1 G2 H1…

A:

Q: Q6/F1-A'B'+B'C+ABC+A'C' F2=A+B'C+A'C F3=B'+ABC F4=A'B+AB'C+A'BC' Chose the correct answer O F1=F3 O…

A:

Q: A ramp input applied to an unity feedback system results in 5% steady state error. The type number…

A:

Q: Given:μ = 1200 The core has square cross section and all dimension are in cm. 10 A 1² N₁ 500 turns…

A:

Q: A coil has resistance 10 Ω , inductive reactance 20 Ω . A capacitance of 50 uF is connected in…

A:

Q: 3-phase A-connected induction motor has a rated current and a full-load slip of 4 %. Answer the…

A: Given - For three phase induction motor- Direct starting current to rated current = 800% Slip value,…

Q: ii) A receiver has an input power of 72.2 mW and SNR for the receiver is 41.03 dB. Find the noise…

A: Given: A receiver has an input power, Pin=72.2 mW. SNR = 41.03 dB.

Q: QI/A- Chose the correct answer with explanation 1- A 3-phase 440 V, 50 Hz induction motor has 4%…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Q4/ The decimal 793.251)= ( number number ( O 1431.204 O 1431.200 O No one of them O 1341.200 O…

A:

Q: Determine the current through R₁ in figure below if Vs = 50 V +0- Vs A www R₁ 560 Ω R₂ 330 Ω R₂ 330…

A: Given circuit: Source voltage, Vs=50 V.

Q: 6 similar amplifiers are cascaded, with lower cut-off frequency 100Hz. Bandwidth is B1=10 kHz. What…

A:

Q: 8. ± √36 = 16 V25 9. 10. + 169 V256

A:

Q: = For maximum power transfer, RL 3Ω 20V 5A 2Ω _ ix 10V 3A R₁ Q. 2ix

A: Concept- It is known that For maximum power transfer, RL=RTH, where,  RTH=Thevenin equivalent…

Q: The reference node is shown in the figure. How many non-reference node are there? Blank 1 19 4Ω 20 Ω…

A: To find the number of non-reference nodes in the network given

Q: Q1/Find( (90)10/(36)8)* (F1)16+(1100111)2=( )Gray O 1000101100 O 110100111 O None of them O…

A:

Q: A balanced abc-sequence Y-connected source with Van -220L 0° V is connected to a delta-connected…

A:

Q: Fifty years into the future, the way we will probably make base load energy include(s) Select one:…

A: Energy:- Energy is present in different forms, it is capable to move an object or doing work. Solar…

Q: 6 similar amplifiers are cascaded, with lower cut-off frequency 100Hz. Bandwidth is B1=10 kHz. What…

A: The higher cut-off frequency lowers and the lower cut-off frequency rises as a result of cascading,…

Q: B. Define ( resistance, reactance, impedance.

A: Resistance- It is the process by which flow of current is being opposed  by an electric circuit. It…

Q: R₁ Ⓒ S Ⓒ 2V R1 R3 ww V₂ (11-13) R1 R3 + R₂ Vx 1-1/2) (12₂) + ( 1 / 2² + R3 1 1 1 (2₁-23) (02) -…

A: Given circuit:- We have to find the KCL equation across the supernode.

Q: Using KVL state the transfer function of the following Sallen-Key:

A: Given- Sallen key Op Amp- Resistance = R1 and R2 Capacitance = C1 and C2   To find- Transfer…

Q: A discrete time signal, I. II. III. IV. 2 X [n] = e-0.¹¹ sinn Determine the values of x[n] for each…

A:

Q: Can you please give 5 examples of Maxwell Mesh Method with figure and complete solution each?(I need…

A:

Q: MILL. 2. Could the input and the output impedance of this circuit be measured using an ohmmeter?…

A: ANSWER NO we can not measure INPUT and OUTPUT impedance of the circuit…

Q: The speed control of an AC motor can be achieved by using 2 common types of drive circuit, namely…

A:

Q: Can you please give 5 examples of Kirchhoff's Voltage Law(KVL) with figure and complete solution…

A:

Q: An inductor of 150 mH with a resistance of 75 Ω and a capacitor of C fed are connected in series.…

A:

Q: The Z-transform of the following function /[k].2+(-5)*(-4)* in So the constants A and B are........…

A: Given, fk=942×2k+517×-5k-336×-4k f[Z]=Z×[A+BZ2](Z-2)×(Z+5)×(Z+4) Here, we have to find the values of…

Q: Q5: A unity feedback system shown in Figure 5, operating with a damping ratio of 0.5, design a…

A:

Q: If 5 V and 16 V power supplies are connected in series aiding, what is the total voltage? 16 V 80 V…

A: Given: Two power supplies are connected in series aiding. Vs1=5 V,Vs2=16 V.

Q: What is the mesh equation for the supermesh below? σν + σΚΩ M ΕΚΩ I1 ΚΩ (1) 5mA 6 ΚΩ Τα ...

A:

Q: A single phase a.c. generator supplies the following loads : (a) Lighting load of 40 kW at unity…

A:

Q: The wave Fom X(t) = 20 +20 sin (500t +30°) is to be Sampled periodically and later to be reproduced…

A: Please comment if you need any clarification. If you find my answer useful please put thumbs up.…

Q: Q-AN AMPLIFIER HAS A OPEN LOOP VOLTAGE GAIN OF-500. THIS GAIN IS REDUCED TO -100 WHEN NEGATIVE…

A: Given- Open loop voltage gain A=-500, Closed loop gain Af=-100, To Find- The reverse transmission…

Q: A 3-phase transformer having line-voltage ratio of 0-4 kV/11kV is connected in star-delta and…

A: We have a 3-phase transformer which is connected in star-delta and a protective transformer is also…

Q: 3. The total capacitance for this circuit is 10 F C₂ 10 F

A: Circuit is given as:

Q: 1;, = 2.75 mA Α- Figure 6-9 ΙΚΩ 1.5 Κ Ω | 4.7 ΚΩ Μ 3.9 Κ Ω Jour B Given the circuit in Figure 6-9,…

A: The given circuit is,

Q: The decimal number

A:

Q: Q4/ The decimal 793.251)= ( number number ( O 1431.204 O 1431.200 O No one of them O 1341.200 O…

A:

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.