please show all the work with diagrams 1. Using trig, determine the distancethe load slides.2. Using the radii of the double pulley,determine how high John will rise based on your previous answer.3. Using these distances, account for the work done by:•Gravity, on John (is this positive or negative?)4. Determine the final kinetic energy of the system (recall that you can relate the variouslinear velocities to the angular velocity of the double pulley)Friction, between the load and the incline (is this positive or negative?)Gravity, on the load (is this positive or negative?) John Wick once again finds himselfoutnumbered, outgunned, and injured, and isrunning for his life when he happens upon aconstruction site. He observes that there is alarge load sitting on an inclined surfaceanchored with a rope wound around a largewooden double pulley. He decides that hecan cut the anchor and ride the rope up asthe load drops down the incline. As he runstowards the rope, he estimates the followingparameters:John has ditched most of his gear andnow weighs -185 lbs• The load weighs -500 lbsThe large double pulley weighs-100 lbsThe double pulley has an outer radiusTA = -4.5 ft, an inner radius r = ~2.5 ft,and a radius of gyration k = -3.1ftThe load is h = -80ft off the ground• The incline sits at 8 = -65°The coefficient of friction between theload and the incline is μ = -0.15Assuming John's estimations are correct andneglecting axle friction at the pulley,determine John's height and speed when theload comes crashing to the ground.You may find the following steps helpful:1. Using trig, determine the distancethe load slides.TAľв+++h

John's weight, Load weight, Large double pulley weight, The outer radius of the double pulley, The…

dista the load slides. 2. Using the radii of the double pulley, determine how high John will rise based on your previous answer. 3. Using these distances, account for the work done by: • Friction, between the load and the incline (is this positive or Gravity, on the load (is this positive or negative?) Gravity, on John (is this positive or negative?)

dista the load slides. 2. Using the radii of the double pulley, determine how high John will rise based on your previous answer. 3. Using these distances, account for the work done by: • Friction, between the load and the incline (is this positive or Gravity, on the load (is this positive or negative?) Gravity, on John (is this positive or negative?)

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.89RP: The woman is trying to move the crate of weight W by pulling on the rope at the angle to the...

See similar textbooks

Similar questions

The level of a common steelyard without hook connections weights 7kg and acts at 5cm to the left of the fulcrum. The hook which carries the load,weights 4kg and is also attached on the left-hand side of the fulcrum at a distance of 12cm.if graduation mark 72cm from the fulcrum reads 50kg. Find (a).the weight of rider (b). How far is the zero graduation from fulcrum (c).What is the movement of riderper kg of graduation?
Determinethehorizontal and vertical componentsof the Pin reaction B)onA Be for frameshown inthefigure
Draw the FBD of the entire frame, assuming that friction and the weights of the members are negligible. How many unknowns appear on this FBD?
The figure shows a steel bar being processed by a rolling mill. Given that P=80kN and r =0.016, determine the force F required to advance the bar at a constant speed.
The 15-m-long cable supports the loads W1 and W2 as shown. Find the ratio W1/W2 for which the segment BC will be horizontal; that is, 2=0.
find the weight of the wooden beam shelf attach on the wall.
An old single-leaf drawbridge is made of a thin rectangular board of mass M, width a(into the page) and length bwhich can pivot at oneend. When it is not in use, the span of the bridge is held at a 60ºangle from the horizontal direction. The two ideal cables that holdit at itsfarther end areanchored to the ground so that they forma 30º angle with the horizontal direction, as shown in Fig. 3.The acceleration due to gravity has magnitude g. a) Set up all the detailed scalar equations (not the general version)expressing the static equilibrium of the drawbridge. b) Determine the magnitude T of the tension force exerted by each of the two cables on the board. c)Determine the magnitude Fh of the hinge force exerted on the board and the angle h that the force forms with respect to the horizontal direction.
find the mobility and determine the Grashof condition
A 200# stone is being lifted off the ground by a levering bar. Determine the push P required to keep the stone in the position shown.
A cylinder is supspended by five cables. No cable can sustain more than 100 Ntension. Determine the maximum weight of the cylinder that the cord system can support. Draw allnecessary FBDs.
Show all the applied forces in FBD. Please answer fast because I only have 30 minutes left.
The spring clamp of Fig. block Fagainst the floor. The force in the spring is F = k(e – lo), where e is the present length of the spring, lo = 3 in. is the unstretched length of the spring, and k = 240 lb/ft is the spring constant. Determine all forces acting on mem- ber ÁBC of the spring clamp and the force exerted by the spring clamp on the block E. is used to hold the 8 in. D E 8 in. 6 in -6 in.- 6 in.