Answered: Does it possible to use gravimetric…

Does it possible to use gravimetric analysis to quantiify certain parameters as indicators of quality in squash soup? If yes, please explain the process

Chemical Principles in the Laboratory

11th Edition

ISBN:9781305264434

Author:Emil Slowinski, Wayne C. Wolsey, Robert Rossi

Publisher:Emil Slowinski, Wayne C. Wolsey, Robert Rossi

Chapter17: Classification Of Chemical Substances

Section: Chapter Questions

Problem 1ASA

See similar textbooks

Similar questions

A new procedure for the rapid determination of sulphur in kerosene was tested on a sample known from its method of preparation to contain 0.123% S (µ = 0.123% S). The results for % S were 0.112, 0.118, 0.115, and 0.119. Determine whether the data indicate that there is a bias in the method at the 95% confidence level
In the Analytical Chemistry laboratory, one of the B.Sc student Ms. Fatma wanted to analyze the presence of Iron(II) ion in the water samples collected from Sohar Industrial Area in the Sultanate of Oman and analyzed by Spectrophotometric method. (1) 250.00 mL of this water sample (Solution A) known to contain unknown amount of FeSO4. She has diluted Solution A by a dilution factor 10 to make 250.00 mL solution, which she labeled Solution B. Using Spectrophotometer, she has measured the absorbance value (0.642) for Solution B at 508 nm using 1.00 cm cell (cuvet). The molar absorptivity value for Fe2* ion at 508 nm is ɛ508 = 30.8 M-1cm-1. (i) What volume of the solution A did she require to make the 250.00 mL of Solution В? (ii) in (i)? What instrument should she use to transfer the volume of the Solution A calculated (ii) Concentration of FeSO4 in Solution B. (iv) Concentration of FeSO4 in Solution A. Mass of FeSO4 in Solution A (Show your calculation) (v)
Ceramics used as abrasives must be hard and tough and be able to withstand high temperatures that arise from frictional forces. What is the minimum required hardness (measure in Mohs scale) for a material to be used as abrasive? Your answer
Which of the following given statements is false? 1. The electrical conductivity of water is dependent on the temperature of the water sample. Removal of suspended particles by sedimentation depends upon the size and specific gravity of those particles. Suspended solids retained on a filter may remain in suspension if their specific gravity is similar to water while very dense particles passing through the filter may settle. Sodium hydroxide and sodium chloride are both bases. 2. In a sedimentation process, the solid particles settled at the bottom of the container because they are heavier than water and are acted upon by gravity. In the process of distillation, the condenser helps in the conversion of the vapor that goes inside it into liquid. After filtering a mixture using a filter paper, there is more solute at the bottom of the container compared to the contents of the filter paper. In the reaction between dry ferrous sulfate and dry potassium ferricyanide, no change is observed.…
The molarity of a solution is determined by four separate titrations or replicates, where the obtained data was 0.4120, 0.4920, 0.3920, and 0.4320 M. Calculate the standard error of the mean for the above data. O 0.00185 O 0.02160 O 0.43200 O 0.04320 O 0.01080
1.) In the Dumas method for determining the molar mass of an unknown volatile liquid, a sample of a volatile liquid that boils below 100 oC is vaporized in a boiling water bath and the mass of the vapor required to fill the flask is determined. The following data was collected: Flask Volume 100.0 +100.0 + 79.6 mL = 279.6 mL Mass of Flask + Cap 143.85 g Mass of Flask + Condensed Liquid 144.95 g Mass of Condensed Liquid 1.10 g Temperature of Water Bath (oC) 84.1 oC Barometric Pressure (atm) 0.985 atm a.) What is the molar mass of the unknown? b.) What will its temperature be when the pressure is 1.20 atm and the volume is 250.0 mL?
Express your answer as a chemical equation. Identify all of the phases in your answer. 1. Solid lead(II)(II) sulfide reacts with aqueous hydrochloric acid to form solid lead(II)(II) chloride and dihydrogen sulfide gas. 2. Gaseous carbon monoxide reacts with hydrogen gas to form gaseous methane (CH4)(CH4) and liquid water. 3. Solid iron(III)(III) oxide reacts with hydrogen gas to form solid iron and liquid water. 4. Gaseous ammonia (NH3)(NH3) reacts with gaseous oxygen to form gaseous nitrogen monoxide and gaseous water.
Is the concentration of the solution prepared in the question below only approximate because sodium hydroxide is not a primary standard? * Find the mass in grams of sodium hydroxide that will be required to prepare a solution with a concentration of 0.500 mol·dm⁻³ in a 250 cm³ volumetric flask. [Round the answer to three decimal places. Do not type in the unit. Use a decimal point.] *
PAPER CROMATOGRAPHY • Define chromatography • Demonstrate an understanding of the process of chromatography • Describe the steps involved in a chromatography investigation Explanation Coloured inks are often made up of several different inks. Each colour of ink will get carried a different distance by the water, allowing you to see all of the different inks. Try this with different colours to see what actually goes into a colour. This technique is called chromatography and can be used in chemistry to find out what is in an unknown mixture. II. Materials .Felt tip pens (non-washable) . Kitchen roll .A bowl or cup . Water • Scissors III. Health and safety • Make sure that you thoroughly clean any equipment after the experiment before using for food IV. Procedure Method 1 1. Take a sheet of kitchen roll and draw a simple picture with a non-washable felt tip pen. 2. Place the sheet over an empty bowl. This is to keep the paper from getting too wet. 3. Carefully add a few drops of water…
You are preparing a 100.0 mL standard solution needed for titration analysis. The NaOH (40 g/mol) pellets are measured to be 0.5341 g in a balance with acceptable uncertainty of +0.001 g. Mass of the pellets is recorded after taring the container. The pellets are put in a beaker and added with 50 ml distilled water measured by a graduated cylinder. The solution is then quantitatively transferred to a 100-mL volumetric flask with uncertainty of ±0.08 mL and diluted to a 100-mL mark. What is the concentration (M) of the solution and estimate its uncertainty by propagation? Assumption: There is no uncertainty in molar mass. Express your answer as C+/- u M.
what Carbonate Reservoir Heterogeneity ?
Anna Divi, a young and ambitious researcher, is planning to put her very own research laboratory. However, she does not have the funds for this to happen. She then approached Alan Read, CEO of a well-known funding agency, to help her pursue her dream laboratory. Before Alan considers Anna's proposal, Anna must perform an experiment on determining the melting point of solutions. She must have an accurate result with a percent error not greater than 3%. The data on the experiment is given below. Help Anna achieve her goals by performing the necessary calculations below. Table 1. Data on the determination of the melting point of the solution. Parameters Values Theoretical freezing point of solvent, °C 65.8 Freezing point depression constant (kç) of solvent, °C m-1 2.49 mass of solute, g 0.250 mass of solvent, g 2.100 molar mass of solute, g mol-1 148.21 A. Calculate the molality of the solution. B. Calculate the theoretical freezing point of the solution. C. Anna performed the same…