During an all-night cram session, a student heats up a 0.786 liter (0.786 x 103 m³) glass (Pyrex) beaker of cold coffee. Initially, the temperature is 18.7 °C, and the beaker is filled to the brim. A short time later when the student returns, the temperature has risen to 95.5 °C. The coefficient of volume expansion of coffee is the same as that of water. How much coffee (in cubic meters) has spilled out of the beaker? Cold Hot Number i Units î

During an all-night cram session, a student heats up a 0.786 liter (0.786 x 103 m³) glass (Pyrex) beaker of cold coffee. Initially, the temperature is 18.7 °C, and the beaker is filled to the brim. A short time later when the student returns, the temperature has risen to 95.5 °C. The coefficient of volume expansion of coffee is the same as that of water. How much coffee (in cubic meters) has spilled out of the beaker? Cold Hot Number i Units î

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter1: Temperature And Heat

Section: Chapter Questions

Problem 49P: The height of the Washington Monument is measured to be 170.00 m on a day when the temperature is...

See similar textbooks

Similar questions

At 25.0 m below the surface of the sea, where the temperature is 5.00C, a diver exhales an air bubble having a volume of 1.00 cm3. If the surface temperature of the sea is 20.0C, what is the volume of the bubble just before it breaks the surface?
(a) Find the density in SI units of air at a pressure of 1.00 atm and a temperature of 20 , assuming that air is 78% N2, 21% O2, and 1% Ar, (b) Find the density of the atmosphere on Venus, assuming that it's 96% CO2 and 4% N2, with a temperature of 737 K and a pressure of 92.0 atm.
A bubble having a diameter of 92 cm is released from a depth of 4.5 m from the bottomof a swimming pool. The temperature of thewater at the surface is 22◦C, whereas it is 16◦Cat the point of release.What will the diameter of the bubble bewhen it reaches the surface? The accelerationof gravity is 9.8 m/s2and the density of wateris 1000 kg/m3.Answer in units of cm.
A brass lid screws tightly onto a glass jar at 15°C. To helpopen the jar, it can be placed into a bath of hot water.After this treatment, the temperatures of the lid and thejar are both 55°C. The inside diameter of the lid is 8.0 cm.Find the size of the gap (difference in radius) that developsby this procedure.
Thick fluids such as asphalt and waxes and thepipes in which they flow are often heated in order to reducethe viscosity of the fluids and thus to reduce the pumpingcosts. Consider the flow of such a fluid through a100-m-long pipe of outer diameter 30 cm in calm ambientair at 0°C. The pipe is heated electrically, and a thermostatkeeps the outer surface temperature of the pipe constant at25°C. The emissivity of the outer surface of the pipe is 0.8,and the effective sky temperature is -30°C. Determine thepower rating of the electric resistance heater, in kW, thatneeds to be used. Also, determine the cost of electricityassociated with heating the pipe during a 10-h period underthe above conditions if the price of electricity is $0.09/kWh.
An 8-m-internal-diameter spherical tank made of1.5-cm-thick stainless steel (k = 15 W/m·K) is used to storeiced water at 0°C. The tank is located in a room whose temperatureis 25°C. The walls of the room are also at 25°C.The outer surface of the tank is black (emissivity « = 1),and heat transfer between the outer surface of the tank andthe surroundings is by natural convection and radiation. Theconvection heat transfer coefficients at the inner and theouter surfaces of the tank are 80 W/m2·K and 10 W/m2·K,respectively. Determine (a) the rate of heat transfer to theiced water in the tank and (b) the amount of ice at 0°C thatmelts during a 24-h period. The heat of fusion of water atatmospheric pressure is hif = 333.7 kJ/kg.
A spherical steel ball bearing has a diameter of 2.540 cm at 27.00°C. (Assume the coefficient of linear expansion for steel is 11 x 10-6 (°C) ¹.) (a) What is its diameter when its temperature is raised to 116.0°C? (Give your answer to at least four significant figures.) cm (b) What temperature change is required to increase its volume by 1.200%? °℃
A spherical steel ball bearing has a diameter of 2.540 cm at 26.00°C. (Assume the coefficient of linear expansion for steel is 11 x 10-6 (°C)-1.) (a) What is its diameter when its temperature is raised to 89.0°C? (Give your answer to at least four significant figures.) cm (b) What temperature change is required to increase its volume by 1.200%? °C
A steel plate has a hole in it with a diameter of exactly1.0 cm when the plate is at a temperature of 20°C. A steelring has an inner diameter of exactly 1.0 cm at 20°C. Boththe plate and the ring are heated to 100°C. Which statement is true?(a) The hole in the plate gets smaller, and the opening inthe ring gets larger.(b) The opening in the ring gets larger, but we need therelative size of the plate and the hole to know whathappens to the hole.(c) The hole in the plate and the opening in the ring getlarger.(d) The hole in the plate and the opening in the ring getsmaller.(e) The hole in the plate gets larger, and the opening inthe ring gets smaller
A balloon contains 3.9 liters of nitrogen gas at a temperatureof 84 K and a pressure of 101 kPa. If the temperature of the gas isallowed to increase to 28 °C and the pressure remains constant,what volume will the gas occupy?
A 380-mL spherical flask contains 0.065 mol of an ideal gas ata temperature of 283 K. What is the average force exerted on thewalls of the flask by a single molecule?
A machinist bores a hole of diameter 1.35 cm in a steelplate that is at 25.0°C. What is the cross-sectional area of the hole (a) at25.0°C and (b) when the temperature of the plate is increased to 175°C?Assume that the coefficient of linear expansion remains constant overthis temperature range.