Answered: The value of d28/dt2 for a synchronous…

The value of d28/dt2 for a synchronous machine, rated 50MVA, 60HZ, M = 1.06MJ.s/degree, and Pa = 2.5MW, machine is %3D a. 0.424 rad/s2 O b. 3.356 rad/s2 c. 2.358 rad/s2 d. 0.4.356 rad/s2

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.4P

See similar textbooks

Related questions

Q: 4. Take a picture of a system inside your home that utilizes the concept of control system and ident...

A: Type of control system Closed-loop control system The more accurate response even in the case on...

Q: What are the drawbacks of using OOPS?What are the drawbacks of using OOPS?

A: OOPs - The term OOP stands for object-oriented programming. it is a language of programming that en...

Q: Theoretical Calculations: 1. What is the polarity of the input voltage Uin compared with the output ...

Q: a) Deduce the expression for Y - A and A - Y conversions. Using such conversion, fir current I of th...

Q: Three point charges are located as shown in the figure. q1 =-5 x 10-12 [C] and d = 6 [cm] 42 = -4 x ...

Q: Determine Ry wrt terminals a-b. 2 A 20 N 9Ω a 20 V 5Ω

A: Given circuit:

Q: 5. Find the IR drop across each resistor in the following circuits by the voltage-divider method (Fi...

Q: Determine the annual module power output of a SANYO (HIP-215NHE5) module in Baghdad, if the monthly ...

Q: Hop)" Proof the eyuation AD-BC = 1 ; %3D Is IR %3D Vs UR IR= Is Vs AVR +BIR Isz CUR + DIR.

A: Let us take,VR- receiving end voltageVs-sending end voltageand,Is-sending end currentIR-receiving en...

Q: С. What is the integral of a square wave? d. What is the derivative (differential) of a triangle wav...

A: b) General purpose of opamp is it can be used to amplify the signals acts as amplifier. Used as a ...

Q: Q2 : Suppose you have the following modulated signal with the output wave changes of t 5.5 Vp: Vam (...

A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you a...

Q: AB OD ol 11 101

Q: A dc generator is driven at a speed of 1000 rpm and generates 120 volts. Determine the generated emf...

Q: Make a list of three technologies that have gone from analogue to digital. What was the reasoning be...

A: Analog devices are those devices which works on the analog parts of component and they gives there o...

Q: Consider two charge Q =9 x 10- (C) and Q2 = 5 x 10-0 [C] separated by a distance r = 0. 05 (m]. a. W...

A: When two charges Q1 and Q2 are kept at distance d then charges experience a force on each other. If ...

Q: A R6 R3 500 0 500 0 R7 R5 12 3 mA 1 ka 500 n 4 mA Using mesh analysis

Q: TRUE OR FALSE - When different diode models are connected in series in such a way that they are ori...

A: When different diode models are connected in series with similar orientation . Taking example of thr...

Q: 2. Design the following Boolean function using appropriate Multiplexer and logic gates F(A, B, C, D)...

A: The given logic expression is:

Q: Series Diode Configuration 5. 5. Vo and I, 1.2KQ Si IR +12 Vo Ip 2.4KQ -5V

Q: In the circur

Q: List the materials used for construction of following parts (1) commutator (2) Transformer core (3)...

Q: Assuming you have a 6V battery and a 1.5V flashlight bulb which draws 0.5A when the bulb voltage is ...

Q: A short shunt compound generator has an armature,shunt field and series field resistances of 0.02 oh...

Q: Draw the block diagram of a Displacement measurement system .Also identify the names of the functio...

A: Displacement measurement system is a system which is used to measure a displacement by an object. It...

Q: :: Vs = A VR +BIR Vs = (0.861L")(23sXlo+ (156.58/78.35° )(840 L-3 79°. Vs = 136- 7 X 103+go437.39 +j...

A: Equation is given as, Vs=AVR+BIR=0.861∠10275×1033+156.58∠78.350840∠-3.790=0.861×158.77×103∠10+00+156...

Q: a) Write down the characteristic equation of a semiconductor diode. b) What happens in a semiconduct...

Q: A communication equipment has 2 stages with voltage gains / attenuations of 0.03 (ratio), and 30dB. ...

A: We need to find out overall gain for given system .

Q: explain why a voltage divider used as a bias on a dual-clipper circuit does not give a 'clipped' out...

Q: Q2) Find z transform for 1- X(n) n2 cosne

A: The Z transform is used to convert the discrete signal in to frequency domain. The z transform of x(...

Q: I (4.00 N) = I (7.00 0) = I (20.0 0) = I (9.00 N) = A 5. DETAILS SERPSE10 27,4.OP.024. Consider the ...

A: The solution is given below

Q: 2. A standard vapor compression system produces 25 Tons of Refrigeration using R 12 as refrigerant w...

A: Vapour Compression Refrigeration Cycle- In VCR Systems like house refrigerators ,the compressor us...

Q: Pus What is he power generated by the source in the circuit and Vs 5K Rs 18K Vs R3 12K Ry 4K Vs

A: The solution is given below

Q: Find the average value of the voltage signal v(t), such that Vm = 4.5 V and time period T = 3.2 s. v...

A: Given, Voltage signal, Vm=4.5 VVT=3.2 s

Q: 18. Determine V, for the negative logic OR gate of Fig. 164. 19. Determine V, for the negative logic...

A: In this question, Find the value of output voltage Vo. Assume forward bias voltage of si type diod...

Q: In JDBC, what is the difference between CLOB and BLOB data types?

A: BLOB : Variable- length BLOB string that can be up to 2GB (2,147,483,647) long. Primarily intended t...

Q: The given data to be used for getting the AVE Values is 0, 5, 10, 30, 50, 70, 50, 30, 10, 5, 0, -5, ...

A: In this question The given data 0, 5, 10, 30, 50, 70, 50, 30, 10, 5, 0, -5, -10v. We need to determ...

Q: pos par along the x-axis is given by (X(t)=3t+2t^3 ). Find the acceleration O a= 3+6t^2 ( m/sec2) O ...

Q: 7. A purely resistive lamp is rated at 200V (rms), 120 W (i.e., it dissipates 120 W power when conne...

Q: A Fabry-Perot filter is used to select 100 channels spaced apart by 0.2nm. What should be the cavity...

A: Fabry-Perot optical filter-The Fabry-Perot optical filter consists of two flat mirrors that reflect ...

Q: Consider the WAN, or wide-area network, as your preferred wireless access method. What makes this op...

A: Wide Area Network (WAN) - it is a big data system that is not limited to a single place. Through a ...

Q: ノ Solve 5+ 2) - 3j In It - 3j 2j

Q: Find the phase inductance of the three-phase circuit shown in the figure, if the separation between ...

Q: 1. a. Using the characteristics of Fig. 152b, determine Ip, Vp, and Vr for the circuit of Fig. 152a....

Q: 4. Construct a complex circuit that will produce a total resistance of 9540.54 500 V battery, resist...

Q: Alternator A (100 kVA, 3-f, 240 V, 60 Hz, 1800 rpm) is operating in parallel with alternator B (125 ...

A: In this question We need to determine the pf of load. If Alternator A (100 kVA, 3-f, 240 V, 60 Hz, 1...

Q: 7. A purely resistive lamp is rated at 200V (rms), 120 W (i.e., it dissipates 120 W power when conne...

A: Given, A purely resistive lamp, Vrms=200 VPrms=120 W

Q: What is the value of a resistor that must be connected in parallel across a 100kN resistance to redu...

A: if R1 and R2 are in parallel then total resistance is RT 1RT=1R1+1R2 Given R1 =100 kil...

Q: Consider the WAN, or wide-area network, as your preferred wireless access method. What makes this op...

A: Wide Area Network (WAN) - it is a big data system that is not limited to a single place. Through a ...

Q: Q1. Determine the root locus for the system shown below: (s +1)(s+2) s(s +4) R(s) K Y (s)

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: Eq Resistance Rad for C1 and Eq Resistance Rab for C2

Concept explainers

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.

Question

The value of d28/dt2 for a synchronous machine, rated 50MVA,
60HZ, M = 1.06MJ.s/degree, and Pa = 2.5MW, machine is
%3D
a. 0.424 rad/s2
O b. 3.356 rad/s2
c. 2.358 rad/s2
d. 0.4.356 rad/s2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q3/ A/ Compare between de series and shunt generator. Q3/ B/ Briefly explain the commutating process in dc machine.
What is use of solenoid coil in the pressure to converter? a. To produce magnetic field in the LVDT b. To change the LVDT output c. To bring back the pivoted beam normal position d. To produce linear displacement in bellows
The p.u parameters for a 500 MVA machine on its own base are: inertia,M=20 p.u.;Reactance X=2 p.u. What is the p.u value of inertia and reactance on 100 MVA COMMON BASE. Ans is 100,0.4
A DC machine with 2 poles, wave winded (retrogressive) (two layers) with 18 slots, the values of pole pitch and commutator pitch are
A single phase full wave AC voltage controller has a resistive load of 5 ohms and an input voltage of Vs = 220 V (RMS), 50 Hz. The delay angles of both thyristors are set to 90 degrees. The maximum power that can be delivered to the load is: Select one: a. 5.65 kW b. 9.68 kW c. 11.52 kW d. None of these
The single - phase ac voltage controller with inductive load. Plot the waveform of output voltage and voltage in each thyristor if the B = 10 %3D degree and delay angle (alpha) in both thyristor is 1- (30 degrees) 2- (90 degrees) 3- (120 degrees)
Two identical 2,000 kW alternator operates in parallel. The governor of the first machine is such that the frequency drops uniformly from 50 Hz at no-load to 48 Hz at full-load. The corresponding uniform speed drop of the second machine is 50 Hz to 47.5 Hz. What is the maximum load that can be delivered without overloading either machine?
A synchronous generator with a synchronous reactance of 1.15 p.u. is connected to an infinite bus whose voltage is one p.u. through an equivalent reactance of 0.15 p.u. The maximum permissible active power output is 1.2 p.u.A. Compute the excitation voltage E.B. The power output is gradually reduced to 0.7 p.u. with fixed field excitation. Find the new current and power angle δ.
DC machine question
Comment briefly on the relationship between input and output power at varying excitation levels and on the relationship between excitation and power factor or reactive power, when the synchronous machine is connected to an infinite busbar
In 2-pole machines: the wave winding have greater generated voltage than *.the lap winding armatures True False *.For high rotating speed machines the number of poles must be Little True False The reactance voltage is added in the coil undergoing commutation to * reduce the spark True False
Two gen. A and B operate in parallel. The station capacity of A is 50MW and that of B is 25MW. The full load speed regulation of station A is 3% and of B is 3.5%. Find the load sharing of 50MW between both the machine and the no load frequency is 50Hz. Don't use pen and copy.