%3DSee the following circuit. Assume e = (v2)(20 V) sin(1000r + 40°), R= 14 2, L= 72 mH, R:= 26 2%3Dand C= 22 µF, find:a) Total impedance Zr in polar form.b) Total current I in polar form.c) Voltage Ve across the inductor C in polar form.d) Voltage Vi. across the capacitor L in polar form.e) Power factor seen by the voltage source e.R2+ VRI -+ VR2-VcVLI.EZ7 -

Answered: Image /qna-images/answer/cdfd0ee6-abb8-401b-bc2e-5243f4387e49.jpg

Answered: %3D See the following circuit. Assume e…

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
List the five capacitor replacement rules.
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
Energy stored in capacitor. Answer it in 30 mins. Draw/sketc the problem thank you. Write the basic equation before the soln. Thank you
The current through a 50 mH inductor is given below. Use Ohm’s Law to find the voltage. Convert to polar form, find the impedance and complete the math, then convert back to the waveform at i1 = 7.5sin(2500t – 20°) mA and i2 = 5.9sin(200t + 40°) mA
A 10.0-μF capacitor and a 2.00-H inductor are connected in series with a 60.0-Hz source whose rms output is 100 V. Finda. the rms current in the circuit.b. the voltage drop across the inductor. c. the voltage drop across the capacitor.
Please draw the problem and answer, thank you. A capacitor is made of 2 rectangular metal plates with side length of 3 cm x 6 cm separated by a distance of 2.36 cm with water in between the plates. The capacitor has a voltage of 110 v and is not connected to a battery. Calculate the capacitance. What is the new capacitance if we replace water with a new dielectric material with a constant of 3.75 in between the plates? What is the new voltage? What is the charge on each plate?
Compute the individual values and the total values of the capacitance, and voltage of the series circuit. Capacitances are, 2.5 x10^-12F and 4.1x10^-12F with a voltage of 1500V.
a) The voltage across a 20uF capacitance is v. = 50 sin( at - 80) volts and Frequency equal to 100 Hz. Determine the current through the capacitor i and sketch its waveform. b) Define phasor
What impedance vector (0- j15) Ohms represents:A. A pure resistance. C. A pure capacitance.B. A pure inductance. D. An inductance combined with a capacitance.
(iii). Determine the net capacitance C of the capacitor network shown in figure. Assume C-3 pF, C2 5 pF, C 6 pF and C 9 pl. Determine the charge on each capacitor, assun there is a potential difference of 15 V across cach network. C2 C, C3
A capacitor C is connected in series with a 400 resistor across a supply of frequency 60 Hz. A current of 3 A flows and the circuit impedance is 500. Calculate: (a) the value of capacitance, C, (b) the supply voltage, (c) the phase angle between the supply voltage and current, (d) the p.d. across the resistor, and (e) the p.d. across the capacitor. Draw the Phasor diagram.

SEE MORE QUESTIONS

Recommended textbooks for you

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Electricity for Refrigeration, Heating, and Air C…

Mechanical Engineering

ISBN:

9781337399128

Author:

Russell E. Smith

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Electricity for Refrigeration, Heating, and Air C…

Mechanical Engineering

ISBN:

9781337399128

Author:

Russell E. Smith

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS