Explain how you can calculate the RPM of a brushed electric fuel pump motor using the waveform on an oscilloscope (50 - 80 words)

Q: What advantages do fiber optic cables have over copper?

A: We need to tell about the advantage of fiber over copper cable .

Q: Figure Q2 depicts the topology of hexagonal cells deployed in a 15802.62 km² metropolitan area.…

A: Given: In this question, the given details are, The topology of hexagonal cells deployed in a…

Q: Q3/A- Answer the two branch: 1- A linear resistance potentiometer is 50mm long and is uniformly…

A: Given data: The resistance is R=10 kΩ=10000 Ω The length isL=50 mm. At normal condition slider at…

Q: Compare the output voltage for an CMOS NAND gate followed by a CMOS inverter when both inputs A and…

A: The given structure is a pass transistor logic. The voltage at each intermediate node will be one…

Q: Q. 4 Use 2-input XOR gates to create a circuit that outputs a 1 when the number of 1s on inputs a,…

A:

Q: (a) The control input is the elevator deflection angle u(t) = 8(t). Define the output as y(t) =…

A:

Q: A coil of 1000 turns is wound on a core. A current of 1A flowing through the coil creates a core…

A: Given- Coil with number of turns, N = 1000 turns Current, I = 1 A Core flux, ϕ=1 mWb   To find-…

Q: INDUCTION MACHINES PROBLEMS P1. Determine the number of poles, the slip, and the frequency of the…

A: The question is from induction machines. Here multiple questions are there and question 8 is not…

Q: Determine R and X₁ given the following values of impedance. Z = 780 + j 350 R = 2 and XL = Z = 560…

A:

Q: V₂ (t) 99e is↑ (t) = + mV and i, (0) = -45 mA, find i, (t) for t>0 8 mF 24 mF mA celer 20 mH

A:

Q: 1.20 Halle V, y la potencia absorbida por cada elemento en circuito en la figura 1.31. 30 V 6 A 12 V…

A:

Q: You want to design Geo Stationary s-band (2 GHz) antenna. If the diameter of an aperture is 1.5 m,…

A: Given: Geo Stationary s-band f=2GHz; Diameter of an aperture D=1.5m To find: Beam width of the…

Q: An n-type silicon bar 0.1 cm long and 100 µm² i cross-sectional area has a majority carrier…

A: Given- n-type silicon bar, length l=0.1 cm, area A=100 μm2, Carrier concentration = 5×1020/m2,…

Q: Apply voltage and current division to determine V, in the circuit given Vout=3.900 V. Vol 15 14 V35…

A:

Q: Ⓒ 60 Ω www 450 + 2 A Ö 10V 2002 50 {502 1002

A:

Q: Given a circuit with a voltage drop V across a resistance R, if V is 10V and R is 5 Ohm, then…

A: Given data: The voltage is V=10 V The resistance is R=5 Ω   Using the formula V=IR

Q: Please answer number 5

A:

Q: Please answer all subpart either dislike Please all subpart is compulsory please I will like it

A: This question deals with the time response and initial & final conditions of a second order RLC…

Q: 2 If 2 ohm resistor is connected across the open circuit terminal. Using Nodal principle determine…

A: We need to find out the current through given resistor for given circuit.

Q: Draw the directed linear graph of the systems, plot the normal tree, and obtain the equations of…

A: Given an electrical circuit. To (a)draw the directed linear graph of the system (b) Plot the normal…

Q: Q2/ For a source produces an equiprobable, symbols which has entropy 2.80735 bit per symbol, find…

A: Given: In this question, the given details are, For a source produces an equiprobable symbols which…

Q: For the circuit shown in below figure, find v and the power absorbed by the resistor? 15 mA( a. 90 V…

A: Given data, Circuit diagram is given as,

Q: A 1000 × 1000 bus admittance matrix for an electric power system has 8000 non-zero elements. The…

A: Given- 1000×1000 bus admittance matrix, 8000 non-zero elements, To Find- The minimum number of…

Q: When the charge in this circuit discharges, why does the charge on the capacitor have to go through…

A: In this question We need to explain why does the charge on the capacitor have to go through R2 only…

Q: A factory is supplied by a single-phase network of 220 V - 50 Hz. It contains in parallel: - 2…

A: As per the guidelines given to us, we can only provide the solution to the first three subparts of…

Q: An alternator is supplying a load of 300 kW at 0.6 p.f. lagging. If the power factor is raised to…

A:

Q: In Fig.4 is shown feedback control system with the following transfer functions:Ge(s) = K; G(s) = 1…

A:

Q: parameters are Ao = 5 x 10°, Ro Ri Rs + = VS = 7532, and 2MS. The input voltage is vs = 5V, and us…

A:

Q: Mechanical transnational system. Find the transfer function G(s) Reduce the transfer function to a…

A: Given: A mechanical transnational system,  To find: Transfer function,  X2(s)F(s).

Q: 1.1 An AC circuit is given in Figure 1.1. The supply voltage is Ē = E20° at a frequency 50 Hz. Ē (N…

A: In this question We need to determine the voltage across the inductor, resistor and capacitor.  We…

Q: How do we solve for the currents through the resistors in this problem (assuming we know the values…

A:

Q: QUESTION 1 The meter shows the number 773, the "ohms" button is pressed, and the setting is 2k. What…

A: Given data, Number shown by meter is 0.773 and the ohm button is pressed. The setting is 2k.

Q: Determine VL in the circuit below where R1=8 Ω and R2= 11 Ω.

A:

Q: Problem 4: The circuit below is a common configuration that can be used to determine the value of a…

A:

Q: The boolean expression F(X, Y, Z) = X Y+Y'. Z is O in simplest SoP form O in simplest PoS form O in…

A: Given, The boolean expression is, FX,Y,Z=X·Y+Y'·Z

Q: Determine Iy in the circuit below where V=8 V, R1=3 Ω, R2=5 Ω, and R3=6.

A: here we have to find the value of Iy .

Q: 1 Consider the continuous-time periodic signal: x(t) = cos(2nt) + 2 sin(6лt). a) Determine the…

A: Given: A continuous time periodic signal,  x(t)=cos(2πt)+2sin(6πt), To find: a) Fundamental period,…

Q: 2. Consider the following circuit: a) What does Req, equal? b) What does Reqz equal? Req1 2 ΚΩ Μ × 6…

A: We need to find out the equivalent resistance for given circuit.

Q: 201900 1 V 5n. 70 n 10 n 5n 120کروا Tizn

A:

Q: 2) vs has magnitude 10 V and the complex frequency is s = -2 +j10 s¹. Determine i(t) in time domain.

A:

Q: Convert each of the following equations directly to gate-level circuits: a.F = ab' + bc + c' b. F =…

A:

Q: Orange Black Brown Silver

A: Introduction: Resistor: An electronic component called a resistor is used in a circuit to control…

Q: 1. Drive the exact E field produced by an infinitesimal dipole located at the origin with a…

A: Introduction Electric Field and Magnetic Field: The electric field can be described in terms of flux…

Q: a I R1 R₂ R3 R7 RO R522 R8 + RAZVA /= 24A, /₁ = 12A, R7= 100, and Rg = 160. Determine the power…

A:

Q: The depth of penetration of electromagnetic wave in a medium having conductivity o at a frequency of…

A: Given- Frequency f1=1 MHz, Depth of penetration d1=25 cm, Frequency f2 =4 MHz, To Find- Depth of…

Q: Question 7 Using the magnetorheological properties of the materials, how could we design a product…

A: Properties of the materials:

Q: R(s) ; H(s) + G.(s) G(s) H(s) Fig. 4. Feedback control system Y(s). In Fig. 4 is shown feedback…

A: Given: A control system, with,  Gc(s)=K, G(s)=s+40ss+10, H(s)=1s+20, To find: We have to sketch…

Q: a. For the system shown in the block diagram shown in Figure Q3-1 b. C. d. R(S) e. Where G, (S) = G₂…

A:

Q: The figure below shows the block diagram of a dc-motor control system. The signal N(s) is the torque…

A: Given a transfer function H(s) so that the output Y(s) is not affected by N(s)

Q: Q. 1 ) (n+12) power 2 perform the indicate operation

A: Basic operation: