Figure 12.31 shows a balanced three-phase three-wire system with positive phase sequence. Let Vnc = 120/60 V and R=0.622. If the total load (including wire resistance) draws 5 kVA at PF = 0.8 lagging, find (a) the total power lost in the line resistance, and (b) Van

Q: An AC three phase distribution system (given in Figure 2), which has end user with balanced three…

A:

Q: A single phase transmission line is delivering 410 kVA load at 10 kV. Its resistance is 5.5 ohm and…

A: Given: A single phase transmission line is delivering 410 kVA load at 10 kV. Its resistance is 5.5…

Q: A balanced three phase load of 10 MVA , 80 percent pf and 33 kV is connected at the end a TL whose…

A: For Regulation calculation, First, find the Sending end voltage using receiving end voltage and Load…

Q: A balanced Y-Y four-wire system has phase voltages bn Van = 12020° V, Von = 1202-120° V, V =…

A: In a three phase electrical wire system, Each current carrying line is separated by equal phase…

Q: The IAC current of a balanced three-phase delta connected load is known as 10 Amps (-10 degrees) and…

A: From the three phase balanced Delta load and Phasor diagram

Q: Sketch the connection of 3-phase source to 3-phase load using 3–phase 4 wire complete with labels

A: 3-phase source to 3-phase load using 3–phase 4 wire Diagram

Q: 2.27: 208V, , 3-, 3-wire and CBA-system with Y-load (ZA=60°Q. Z3=630°Q and Zc=5Z45°Q). Find the line…

A: A 3 phase balance star connected system.  Sequence of the system CBA.  Line to line voltage V=208V…

Q: A 220 kV transmission line is feeding a load as shown in Figure below, where: R1= 0 O/phase and X1 =…

A: Since you are asking a question with multiple sub-parts we will answer first one for you. If you…

Q: (a) Give THREE (3) advantages of a three-phase system compared to a single-phase system.

A:

Q: a) Discus why the transmission systems are mostly overhead systems. b)Discuss why all overhead lines…

A: a. The transmission lines are mostly overhead systems due to the following reasons,…

Q: For a single phase network shown in the figure below, work in per-unit with 200 VA & 250 V as base…

A: In this question we need to find a load current of the given system.

Q: (ii) tränsmission efficiency *. Estimate the distance over which a Joad of 15000 kW at 0-85 n f can…

A:

Q: A single phase transmission line is delivering 460 kVA load at 12 kV. Its resistance is 7 2 and…

A: Given that S=460KVAVL=12KVRLine=7 ohmXLine=9 ohmpf=0.8 lagging calculate the current supplied to the…

Q: A 3-phase transmission line operating at 33 kV and having a resistance of 5 2 and reactance of 20…

A: Given data, Sbase=15,000 kVASbase=15 MVA Single line diagram of the system,

Q: A Factory is supplied froma 3-phase, 4-wire, 400 V, simmetrical system. The resistance of each line…

A:

Q: Q1. What is the necessity of maintaining phase sequence? Suppose there are three loads connected at…

A: Given data: VR=1200 VVL=2400 VVC=2400 V

Q: A three-phase short transmission line connected in star has an effective resistance  of 0.6 Ω per…

A: The given problem is of power system.

Q: The single line diagram of a power system is shown below. Load represented as impedance, (13.2) kV…

A: Given: The single line diagram of a power system is shown below: Load represented as impedance,…

Q: A single phase transmission line is delivering 470 kVA load at 10 kV. Its resistance is 6.5 N and…

A: Receiving end voltage =10kV. Receiving end power factor=0.8 lag Receiving end power=470kVA So…

Q: As shown in Figure 1, a balanced three-phase, positive-sequence source with VAB = 480@0◦ V is…

A: Fig: Given…

Q: In the above figure, a single line model of a three-phase power system is given. Base power 50MVA,…

A:

Q: Q2// answer true or false and correct the 3, false ;if any. 1- The purpose of load test the single…

A: Need to find true false for the given Transformer statement

Q: A single phase transmission line is delivering 460 kVA load at 11 kV. Its resistance is 4.5 e and…

A:

Q: iv) Draw a single-phase equivalent circuit of the system. v) Calculate the following line currents,…

A:

Q: For the 3-phase system shown below, the source line voltage is 460 V, 60 Hz, 1). Phase "a" voltage,…

A: In the question, A three phase system given as shown in the figure find the each phase voltage and…

Q: A single phase transmission line is delivering 400 kVA load at 12 kV. Its resistance is 4.5 N and…

A: Sending end voltage = receiving end voltage +losses. Regulation = (Vs -Vr)/(Vr) Efficiency = output…

Q: In single phase AC distribution system, the net drop is the sum of the drop in resistance due to the…

A: In single phase AC distribution system, we will have resistance as well as reactance components.

Q: 2.21 The three-phase source line-to-neutral voltages are given by E= 10/0, E = 10/+240, and E =…

A:

Q: Q.3: Three symmetrical A-connected loads of impedance (15Z30°0/ph), and another three symmetrical…

A: In the question, 3 phase symmetrical two loads are connected in parallel.  These loads supplied by…

Q: An 11 KV, 3-phase transmission line has a resistance of 1.5 Ω and reactance of 4 Ω per phase.…

A: In this question, An 11 KV, 3-phase transmission line hresistance R=1.5 Ω reactance X=4 Ω per phase.…

Q: 1. Use Gauss-Siedel iterative method to find V2, perform one iteration 2. If V2-0.98 pu, find the…

A: The Gauss-Seidel technique, commonly known as the Liebmann method or the method of successive…

Q: A three-phase Y-connected load (6, 8, 10 Ohm) are energized by a balanced Y-connected three-phase…

A:

Q: Obtain the readings of wattmeter 1 and wattmeter 2 in a three-phase, three-wire system having…

A:

Q: A three-phase symmetrical double circuit line is arranged in a horizontal plane as shown in figure…

A: Transposed line: It is an arrangement of conductors. In this conductors are periodic changes its…

Q: A short 3-phase transmission line connected to a 33kV, 50 Hz generating station at the sending end…

A: The performance of a power system depends mainly on the performance of transmission lines in the…

Q: Problem 3.5: From a 3-phase, 480 V generator switchboard, a feeder takes 3-phase power to two…

A:

Q: QUESTION 4 a) Given the symmetrical components to be: Vo = 2020° V, V1= 7524° V, V2= 504-35° V i.…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: The resistance and reactance of the single- phase 60HZ transmission line conductors are 7.2 ohm and…

A: inductive reactance=2*π*frequency*inductance. sending end power factor=costan-1sendind end reactive…

Q: A short 3-φ transmission line with an impedance of (5 + j 20) Ω per phase has sending end and…

A: Resistance of each conductor R=5 ohm Reactance of each conductor XL=20ohm Load power factor is 0.8…

Q: a) Explain mathematically how to covert impedance Z per unit using new MVA and kV bas values. b) A…

A: In this question we will write how we will convert impedance from old MVA and KV to new MVA and…

Q: Qs : In a 3-phase 4-wire System in a, b,and e. lines under übnormol condifions of loading the…

A: Solve the problem

Q: The resistance and reactance of the single-phase 60HZ transmission line conductors are 5.4 ohm and…

A: Note: As per guidelines will be solving only first 3 subparts. Repost for others For the given data…

Q: 1. A delta connected load with impedance 20cis0- ohms per phase is supplied from a 220 volts, 60…

A:

Q: a) Discus why the transmission systems are mostly overhead systems. b) Discuss why all overhead…

A: As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the separate…

Q: Q3) A balanced 3-phase load of 30 MW is supplied at 132 kV, 50 Hz and 0-85 p.f. lagging by means of…

A:

Q: A short single phase transmission line has a loop impedance of (0.2+j1.2) ohm. At what leading power…

A: Given: A short single phase transmission line has, Loop impedance, Z=0.2+j1.2 Ω so Resistance, R =…

Q: A 3¢, with VL-L of 34.5 kV, grounded-Way feeder has 556.5 kcmil ACSR with 30-strands AL conductor,…

A: for star connection , phase current = line current . apparent power = 3 ×VL×IL

Q: State advantage and disadvantage of delta-connected three-phase voltage source compare to the…

A: Delta connected system has a closed path including the sources and is independent of load.  Where as…

Q: A single phase transmission line is delivering 400 kVA load at 12 kV. Its resistance is 6 2 and…

A:

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.