For a submerged curved surface, the vertical component of force is equal to O a. Weight of the liquid above the curved surface O b. Volume of the liquid above the curved surface O c Specific weight of the liquid above the curved surface O d. Mass of the liquid above the curved surface

For a submerged curved surface, the vertical component of force is equal to O a. Weight of the liquid above the curved surface O b. Volume of the liquid above the curved surface O c Specific weight of the liquid above the curved surface O d. Mass of the liquid above the curved surface

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 5RQ: In what direction does a liquid exert force?

See similar textbooks

Related questions

Q: A cubic meter of a liquid has a weight of 980O N at a location where g = 9.79 m/s2. What is its…

Q: (b) Starting from first principles, show that the variation of pressure due to gravity between two…

Q: The force, in kN, acting on one of the 1.5-m sides of an open cubical water tank (which is full) is:…

Q: If the density of a gas is 0.003 slug/ft3, what is the specific weight (in N/m³) of the gas? * O…

A: Given:- Density = 0.003 slug/ft3 To Find:- Specific gravity

Q: Nitrogen gas is confined in a cylinder and the pressure of the gas is maintained by a weight placed…

A: Answer: The force exerted by the atmosphere, Fatm = 3183.22 N and the force exerted by the piston…

Q: A tank contains oil with specific gravity of 0.80, gasoline with specific gravity of 0.90, and sea…

Q: The density of an oil is 760 kg/m^3. determine the specific gravity of the oil. Fluid question.

Q: If the specific volume of a certain gas is 0.852 m/kg, what is its specific weight? 11.51 N/m? 15.21…

Q: Two pistons of a hydraulic lift have diameters of 60 cm and 5 cm. What is the force exerted by the…

A: Given data: The diameter of the larger piston is dl = 60 cm. The diameter of the smaller piston is…

Q: which of the following gives the absolute pressure, 8m below the surface of salt water? assume the…

A: Given data:

Q: A vessel with 24 in diameter and 36 in in height is filled with a liquid X whose density is 50…

Q: A fish tank that contains 60 cm high water is moved in the cabin of elevator. Determine the pressure…

Q: C1 (b). 1.the value of surface tension (water) in N/m C1 (b). 2. the value of surface tension…

Q: When a car is parked in a parking space, the value of resultant force acting on the car is

A: Answer This statement is (FALSE)

Q: The atmospheric pressure in a location is measured by mercury ( density of 13,600 kg/m^3) barometer.…

Q: A cylindrical drum (2 ft. diameter, 3 ft. height) is filled with a fluid whose density is 40…

A: We have given A cylindrical drum (2 ft. diameter, 3 ft. height) is filled with a fluid whose…

Q: In Fig. P2.31 determine Ap between points A and B. All fluids are at 20°C. Kerosene Benzene B 9 cm…

A: Given: Density of benzene, ρb=878 kg/m³Density of water, ρw=998 kg/m³Density of kerosene, ρk=804…

Q: The diameters of a small piston and a large piston of hydraulic jack are 2 cm and 10 cm…

A: Given Data Fs =60 N d=2 cm D=10 cm FL=(?)

Q: cylindrical drum (2 ft. diameter, 3 ft. height) is filled with a fluid whose density is 40 lb/ft^3 .…

Q: Fluid A fills a one-gallon [gal] container and weighs 50 newtons [N]. The density of Fluid B is 1125…

A: Given data for fluid A volume of container (VA) = 1 gal = (1*0.003785) m3…

Q: A town has a 1.4-million-gallon storage capacity water tower. If the density of water is 62.4 lb/ft3…

Q: (1) The list consisting only of intensive properties is a) Volume, temperature, pressure. (c)…

A: *As per our guidelines we are supposed to answer first three sub-parts of the question. Kindly…

Q: 1-kg cube of wood floats in an upright position in fresh water. If a side of the cube measures 12.5…

A: here given data Mass m = 1 kg Side of cube Length = L = 12.5 cm = 0.125 m Density of water =…

Q: 2. Differentiate intensive, extensive and specific properties with their units.

A: Intensive, Extensive and Specific properties

Q: 2. The large piston in a hydraulic lift has a radius of 250 cm2 . What force (kgf) must be applied…

A: The mentioned unit is in cm2 therefore it is area not radius

Q: The weight of a 25 lbm mass at sea level is:

A: Given:m=25 lbmT=-40° F

Q: Why power is a scalar quantity?

A: There are two types of quantities first is vector and second is scalar. The vector quantity is that…

Q: The specific gravity of mercury is 13.6. The specific weight of mercury is (a) 1.36 kN/m3 (b) 9.81…

A: Given: The specific gravity of the mercury is SG=13.6.

Q: A manometer consists of a U-shaped tube containing a liquid. One side is connected to the apparatus…

A: Given Data: The difference in heights of the liquid in the two sides of the manometer is h= 10.0…

Q: cylindrical drum (2-ft diameter, 3-ft height) is filled with fluid whose density is 40lb/ft³.…

Q: g. The difference between extensive and intensive properties.

Q: What volume should a balloon (filled with helium) need to be in order to lift an 85 kg man? The…

A: Given data, M= 85 kg Density of helium=d1=0.164 kg/m³ Density of air =d2=1.29 kg/m³ Let V be the…

Q: A spherical drum, 80 cm in diameter, is filled with fluid whose density is 6.4 x 10-4 kg/cm3.…

A: Given: Radius = 80 cm Density = 6.4× 10-4 kg/cm3

Q: Which of the following is intensive property heat: work, internal energy, specific heat, heat…

A: Explanation: Intensive property: The properties which are independent on mass of the system is…

Q: Substance A has a density of 1.7 g/cm^3. Substance B has a density of 1.7 kg/m^3. Without doing any…

A: Given data: The density of substance A is, ρA = 1.7 g/cm3. The density of substance B is, ρB = 1.7…

Q: Include a free body diagram The diameters of a small piston and a large piston of hydraulic jack…

Q: Relative density is the ratio of weight density of liquid to ___________________. A_ Specific…

Q: Q2 Calculate the density of the air in a room whose Dimensions are (4 m, 5 m, 6 m) and have mass 140…

Q: 1. A tank of oil has a mass of 25 slugs. (a) Determine its weight in pounds and in newtons at the…

A: Given data: m=25 slugs Need to determine the weight and mass on earth and moon surface.

Q: A boat having a mass of 80 Mg rests on the bottom of the lake and displaces 11.75 m^3 of water.…

A: To find: The smallest radius r of each spherical balloon and the mass of air in each balloon. Given:…

Q: A truck weighing 50kN is not moving on a hill which is inclined at 22 degrees to the horizontal.…

Q: A fixed mass of gas undergoes changes of pressure and volume as shown below. R. P

A: Givenalong path PQRQPQR=8kJWPQR=3kJalong path PSRQPSR=?WPSR=1kJ

Q: As shown in the figure below, a hydraulic system has two pistons of different diameter and uses a…

Q: NASA would like a rocket to accelerate upward at a rate of 125 ft/s2. The mass of the rocket is…

A: For solution refer below images.

Q: An unknown mass and a 12 kg mass are tied to a light string and hung over a frictionless pulley. If…

Q: A solid object whose specific gravity is 3.47 floats above the surface of mercury in a container. 1.…

Concept explainers

Basic Terminology in Mechanics

The area of science and mathematics concerned the motion of the objects, the relation between the force matter, and motion if specified. Forces exerted over the objects result in displacements or changes in the position of an object concerning its environment. This branch of physics keeps its roots in Ancient Greece in the form of the scripts of Aristotle and Archimedes.

Question

For a submerged curved surface, the vertical component of force is equal to
O a. Weight of the liquid above the curved surface
O b. Volume of the liquid above the curved surface
O c Specific weight of the liquid above the curved surface
O d. Mass of the liquid above the curved surface

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is a collinear system of forces for the system of the fluid liquids? A. The force system having all the forces parallel to each other B. The force system having all the forces perpendicular to each other C. The force system having all the forces emerging from a single point D. Forces cannot form a collinear system of forces, it is not possible Select one: O A B The device used to measure the fluid pressure is Select one: O hygrometer calorimeter O manometer O thermometer to the surface of the body. Pressure acts A. nomal B. linear C. parallel D. coplanar Select one: B D O O O O
1. Two pipes A & B caries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe A is 75 cm above the pipe B. The height of oil in right limb is 35 cm. Also, the mercury level difference is found in right limb as 60 cm. Find the pressure difference between these two pipes in kPa. Also find the pressure equivalent in water head in mm. A. The difference of pressure between two pipes (PA-Pa) (Unit is in kPa) = B. Equivalent to Water head in mm =
For surface submerged horizontally in a liquid, the centre of pressure and the distance of centre of gravity (C.G) of the area from the free surface of the liquid are equal. Select one: True False
(b) A vessel of 4 m? volume contains an oil which weighs 30.2 kN. Determine the specific gravity of the oil.
2. A tank that weighs 5kg is filled with 3 liquids shown below. What is the force at the bottom of the sea water (S.G. = 1.3) if the diameter of the tank is 2m. 1 m S.G. = 0.8 S.G = 0.9 1.5 m S.G.= 1.3 2.5 m
1) The centroid of the submerged plane surface and the center of pressure are at the same location. True or False 2) The magnitude of pressure at the centroid of a surface and the magnitude of average pressure are different. True or False 3) On a plane surface, if we want to calculate the hydrostatic force, we need to determine (1) the magnitude of the force and (2) the location of pressure center. True or False
Q4; A liquid when poured into a cylinder is found too weigh 12 N when occupying a volume of I liter. Determine its specific weight, density, and specific gravity of this liquid.
Density of liquid is 850 kg/m Determine relative density and weight density of the liquid.
A reservoir of glycerin has a mass of 1,200 kg and a volume of 0.952 cu.m. Find its (a) weight (b) unit weight (c) mass density (d) specific gravity.
a drum has gasoline s.g=0.9, with oil s.g=0.8 and sea water s.g=1.03. the depth of the liquid is 0.8m, 0.5m, and 1.0 for gasoline, oil and sea water.1. find absolute pressure at depth 1.2m 2.find the depth at 1.8m 3. find the force F at depth 2.1m when diameter of drum is 0.5m
The pressure in a fluid at rest decreases with depth. Select one: True False
Q2: A cubical tank has sides of 3.75m which contains three immiscible liquids at same depths. A water upto a height of 1.25m above the base, An immiscible liquid of specific gravity 0.9 is filled in between both liquids upto 1.25m height, the upper remaining part is filled with oil of specific gravity 0.85. Calculate (1) The value of pressures at the top, at the interface points and at bottom on one side of the tank (ii) The position of center of pressure for one side of the tank. (iii) What suggestions would you give to your client on the basis of obtained results? (iv) Pressure distribution Diagram