For the network in Figure 3.51, suppose the forwarding tables are all established as in Exercise 44 and then the C-E link fails. Give: (a) the tables of A, B, D, and F after C and E have reported the news. (b) the tables of A and D after their next mutual exchange. (c) the table of C after A exchanges with it. A Consider the following network having nodes A, B, C, D, E and F: 8 2 2 1 Step-by-step solution E Step 1 of 8 A 6

For the network in Figure 3.51, suppose the forwarding tables are all established as in Exercise 44 and then the C-E link fails. Give: (a) the tables of A, B, D, and F after C and E have reported the news. (b) the tables of A and D after their next mutual exchange. (c) the table of C after A exchanges with it. A Consider the following network having nodes A, B, C, D, E and F: 8 2 2 1 Step-by-step solution E Step 1 of 8 A 6

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Question 5: Suppose you attach a network monitor to observe the sequence of frames that travel over a link from sender A to receiver B. The problem is to deduce what protocols, if any, could have generated the observed sequence. The following diagrams depict a flow of frames, with their corresponding sequence numbers, from the sender (A). There may be traffic from B to A, which is not depicted in the diagram. A gap between adjacent frames implies passage of time with no transmission from the sender. Note that the x-axis is time, and not space. Justify your answer. A A A ● ● ● ● 1 5 ● 3 5 0 ● 0 0 1 1 1 ● Go-Back-N ● Selective Repeat 1 0 5 0 c) For Diagram 3, the protocol is not: Stop-and-Wait Time Diagram 1 2 Time a) For Diagram 1, the most likely protocol being used is: Stop-and-Wait ● Go-Back-N (if Go-Back-N, give the window size) Selective Repeat (if Selective Repeat, give the window size) Diagram 2 Time 3 Diagram 3 1 Time b) For Diagram 2, the most likely protocol being used is:…
QUESTION 77 Consider the network topology shown below with routers labeled A through F, inclusive. Each link is labeled with its "cost" for routing purposes. The link state routing algorithm is used in this network. (a)Show how Djikstra's algorithm works to compute paths from Router E to all other routers (show your answer in a table format similar to the one used in the lectures). (b)Show the final forwarding table at Router E after completion of the algorithm.
Consider a node called A that sends packets to an adjacent node called B. To control the packet flow to node B, node A employs a credit manager scheme in which parameters C=3(credits), C_max=4(credits) and \tao=6(msec), respectively. node A has an infinite buffer to temporarily store packets. When a packet arrives at node A, node A stores the packet at the bottom of the buffer. Node A also has a single server (transmitter). As soon as the server becomes idle, the server picks up a packet at the head of the buffer, if any, and serves the packet for packet transmission time T_p as far as there remains a credit. (The packet transmission time T_p = 4 (msec).) We observed the arrival times of the first 12 packets, denoted by aA(1)⋯A(12), which were as follows: n A(n) 1 0.5 msec 2 1.0 3 1.5 4 2.0 5 4.5 6 5.5 7 6.5 8 12.5 9 13.0 10 13.5 11 14.0 12 14.6 1. Let R(n) denote the departure time of the n th packet from the buffer for n∈{1,2,...}. Find R(n) for…
Please draw a sequence diagram for the following scenario. In a network, two nodes communicate with each other. These are the sequence. 1) Node F sends ping message to Node H 2) Node H sends ICMP echo reply to node H. Now Node F is having the MAC address of Node H. 3) Node F starts TCP handshake with Node H by sending SYN message. 4) Node H sends (SYN+ACK) back to node F. 5) Node F sends the ACK to Node H.
3. Consider the arrangement of learning bridges shown in the following figure: B1 C sends to A. C sends to D. A sends to D. B3 B2 B4 Assuming all are initially empty, give the forwarding tables for each of the bridges B1 to B4 after the following transmissions: Identify ports with the unique neighbor reached directly from that port; that is, the ports for B1 are to he labeled "A" and "B2"
Consider the communication network in figure 1. 9 Figura 1: Graph representing a data communication network (a) Using Dijkstra's algorithm, construct the tree of shortest paths from router A to all the others (you must show the execution of the algorithm). (b) Using the previous result, identify the next hop used by router A to reach each of the other routers.
A frame containing http request is sent from Computer (A) [in whichever subnet it is now, make sure to show it in your figure], to the access point it is associated with. Draw the address fields (1, 2, and 3) of the frame travelling from Computer A to AP and the source and destination addresses of the frame travelling from AP to R1. The MAC addresses of AP1, AP2, and AP3 are M1, M2, and M3 respectively, and the Router R1’s MAC address connected to this Switch/AP is MRA. IP address values are already given, and the port addresses could also be used as given. The Router’s MAC address facing WAN side is MRW.
Consider four Internet hosts, each with a TCP session. These four TCP sessions share a common bottleneck link - all packet loss on the end-to-end paths for these four sessions occurs at just this one link. The bottleneck link has a transmission rate of R. The round trip times, RTT, for all fours hosts to their destinations are approximately the same. No other sessions are currently using this link. The four sessions have been running for a long time. i) What is the approximate throughput of each of these four TCP sessions? Explain your answer briefly. ii) What is the approximate size of the TCP window at each of these hosts? Explain briefly how you arrived at this answer.
Problem 2. Consider a packet of L bits that is sent over a path of Q links (i.e., a source and destination connected by a sequence of (Q-1) routers or switches). Each link transmits at R bps. This packet is the only traffic transmitted by the network (so there are no queuing delays) and the propagation delay and processing delay at routers are negligible. How long does it take to send this packet from source to destination if the network is: a) a packet-switched datagram network b) a circuit-switched network. Assume that bandwidth of R bps on each link is sliced into five individual circuits, so that cach circuit receives (R/5) bandwidth. Also assume that the circuit setup time is t,.. Give an expression for the number of links Q such that the packet delivery from the sender to the receiver will be faster over the packet-switched network, and the expression for the number of links Q such that the circuit-switched network will be faster.
2. Packet transmission. a. Consider a packet of length L that begins at end system A and travels over 2 links to a destination end system B. These two links are connected by one packet switch. Let d₁, S₁, and R₁ denote the length, propagation speed and transmission rate of link I, for i in {1, 2}. The packet switch delays each packet by dproc b. There is a queuing delay of 100 msec at the switch (but no queuing delay at A). The packet is 1500 bits in length, the propagation speed on all links is 2.5 x 108 m/sec, the transmission rate on both links is 1 Mbps, and the packet switch processing delay is 3 msec. The length of the first link is 4000 km and the second link is 1000 km. What is the end-to-end delay from A to B? c. The switch fails and is replaced. This changes the following information for the switch only. The packet switch processing delay is reduced from 3 msec to 2 msec, the queuing delay is reduced from 100 msec to 40 msec but the second transmission link increases to 8,500…
Consider a computer 1 that communicates with a computer 2 via LAN1, router R1, and LAN2. The sending computer1 is running two processes at this time with port addresses k and l. The receiving computer 2 is running three processes at this time with port addresses f, g and h. Process k in the sending computer 1 needs to communicate with process g in the receiving computer 2. Draw the network and show the contents of segments, packets and frames at the network, data link, and transport layer for each hop. Note: Computer 1 has: Physical address=15, Logical address=A Router R1 has: Physical address in the side of LAN 1=20, Logical address in the side of LAN1=B Physical address in the side of LAN 2=50, Logical address in the side of LAN2=D. Computer 2 has: Physical address=77, Logical address=E.
Below is a nested MPLS network by MTN. With the assumption that Customer 6 (C6) is connected to Router 6 (R6), execute a Dijkstra Algorithm on a Link State routing to determine the shortest path for Customer 6 to transmit packets to every other Customer/Destination connected to the rest of the Routers on the network. Tabulate the executed iteration for the Dijkstra Algorithm using the table below. Iteration Nodes R1 R2 R3 R4 R5 R7 R8 R9 R10 0 [6] 1 [6,3] 2 [6,3,2] 3 [6,3,2,1] 4 [6,3,2,1,4] 5 [6,3,2,1,4,5] 6 [6,3,2,1,4,5,7]…