Give an example of a material’s electrical property.
Q: 7.27. A linear time-invariant discrete-time system has transfer function 3z H(z) = (z+0.5)(z- 0.5)…
A: Given:- transfer function Hz=3zz+0.5z-0.5 Output response, yn=0.5n-3-0.5n+4un We have to find…
Q: An inductor, a capacitor, and a resistor are all connected inseries across an ac source. If the…
A: It is given that: 1. An inductor, a capacitor, and a resistor are all connected in series across an…
Q: 02. A three phase full wave uncontrolled bridge rectifier has an AC input voltage of 90 V RMS at 60…
A: Given: 3 phase full wave uncontrolled bridge rectifier AC input voltage, Vin=90V Frequency, f=60Hz…
Q: 3.45. Show that if x() is a left-sided signal and X(s) converges for some value of s, then the ROC…
A: Region of convergence (ROC): For finite duration signal condition for right-sided signal or casual…
Q: easure the DC voltage across resistor R2 might lead to inaccurate sults. Include in your answer how…
A:
Q: Some linear system has a transfer function 9(s+2)/(s+4). Determine the Bode plot gain (dB) and phase…
A:
Q: Use mesh analysis to solve for V in the circuit below. Vs = 20 V, R₁ = 30 02, R2 = 50 Q, R3 = 20 Q,…
A: Given that: VS=20 V, R1=30 Ω, R2=50 Ω, R3=20 ΩR4=30 Ω, R5=40 Ω, R6=60 Ω, R7=80 Ω A circuit is shown…
Q: RMS value of an alternating current is 30 A and its frequency is 25 Hz. Write its equation to find…
A: We have an RMS value of an alternating current and we have been asked to find its instantaneous…
Q: In an L-R-C series circuit the phase angle is 53.0° and the sourcevoltage lags the current. The…
A: Given: Phase angle, ϕ=53° Resistor, R=300Ω Reactance of capacitor, Xc=500Ω Power, P=80W
Q: Using Gauss- iterative method, calculate the value of x accurate upto 4 decimal places, equation is…
A: We have an equation and we have been asked to find value of x accurate upto 4 decimal places using…
Q: what is the logic function of the circuit shown
A: The given circuit is as shown below,
Q: 1. The instantaneous value of current in an a.c.circuit at any time t seconds is given by: i-50…
A: Given data, Current equation is given as, i=50sin100πt-0.45 mA
Q: Can you please explain noise shaping concept in Delta-Sigma ADC without using equations in the…
A: An delta sigma analog to digital converters are used for converting analog signal to digital over a…
Q: 3. A Pure Inductance of 3mh Carries A Current Of The Waveform Shown in Fig. Sketch The Waveform Of V…
A:
Q: 1. For the network of Fig., determine: (a) S(co) {b) S(Var) (c) S(B) Using T, as the temperature at…
A: Solution !!
Q: 6. For the follow logic circuit system, the output f is: [ (A) ab. (B) a + b. (C) a'+b'. (D) a'b' a…
A: Given, The logic circuit is,
Q: Find the transfer function from e; (t) to e(t). O CLs+1 CLS2+RCs+1 CLs+R CLS2+RCs+1 CLs² +1…
A: Given circuit,
Q: 3. Find the current value, V₁, V₂, and V.. R₂ = 4.7 k M Vin = 10 V M -5 V V₂ R₂ = 2.2 KQ
A:
Q: Use Superposition theorem to calculate current through R, resistor. R₁ E 48 V 10 A 10 A R₂ 200 R₂ 50
A: Given data, Circuit diagram is given as,
Q: 1. Write 10+j 20 in polar coordinates 2. Sein rectangular coordinates 3. 15-j 30 in polar…
A: Given data, 1. Function is given 10+j20 Converting it in polar form, 102+202∠tan-12010=22.36∠63.430
Q: A capacitor of value 100uF is connected across a 200 V, 50 Hz supply. Calculate : (i)reactance of…
A: We have an capacitor with, C = 100 μF = 100 * 10-6 F Voltage (V) = 200 V Frequency (f) = 50 Hz…
Q: State and explain Carson's Bandwidth Frmula. Need urgently help.
A: Carson's bandwidth method is used in telecommunication systems to calculate the bandwidth utilized…
Q: The reciprocal current is denoted by i = 100 in (314 t + 30°). Then its (1) maximum value (2)…
A:
Q: Question 2 View the chart on the characteristics of electromagnetic and mechanical waves and answer…
A: The given chart is shown below:
Q: 6. For the follow logic circuit system, the output f is: 5 (A) ab. (B) a + b. (C) a'+b'. (D) "E a bo
A: Option - B ( Answer )
Q: The reactance of the Impedance Z=100 261 ° is: O 100 Ohms 48.48 Ohms 87.46 Ohms 1.64 Ohms
A:
Q: determine the transfer function Vo(S) Is (S)
A: Given- In series- Resistance, R Capacitance, C Inductance, L To find- Transfer function, V0sI0s=?
Q: The SCR based half-wave rectifier with a resistive load is shown in Figure 1 (left). The voltage…
A: The SCR based half-wave rectifier with a resistive load is shown below, The applied signals…
Q: A 6-pole motor turns at 1080 rpm when connected to a 60 Hz voltage source. Most nearly, what is the…
A: Step-1--> We have motor speed(Ne)=1080 rpm f=60Hz We know , synchronous…
Q: A coil takes 2.5 A, when connected across 200V, 50 Hz main. The power consumed by the coil is found…
A: We need to find out resistance and inductance for given coil
Q: Q2. A three phase full wave uncontrolled bridge rectifier has an AC input voltage of 90 V RMS at 60…
A: Given data, Supply RMS voltage Vr=90 V Frequency f = 60 Hz Load resistance RL=440 Ω
Q: A 4-pole, 50 Hz, 3-phase induction motor has a rotor resistance / phase of 0.03 ohm and reactance of…
A: We have an 3-phase induction motor. Given data of motor, Pole (P) = 4 Frequency (f) = 50 Hz Rotor…
Q: When a second-order system is subjected to a unit step input, the values of = 0.5 and wn = 6…
A: Given, A second order system is subjected to a unit step input. ζ=0.5ωn=6 rad/s
Q: For Z₁ = 1 KQ, Z₂ = 0.1 µF, Z3 = 500 №2, Z4 = 1 ko, derive an expression for the transfer function…
A:
Q: Q-1-a) From the circuit in the Figure-1, determine the DC-bias operation Parameters: (i) IB (ii) Ic…
A: Given:
Q: Name 3 applications for closed-loop system
A:
Q: 18. A current of 16 amperes divides between two branches in parallel of resistances 8 ohms and 12…
A: We need to find out current for given circuit
Q: Calculate the dissipation in power across 200 resistor for the FM signal v(t)= 20 cos(6600t+…
A: The expression of the frequency modulated signal is given as vt=20cos6600t+10sin2100t The power…
Q: The magnetic field due to an infinitely long wire at a certain point is 'B'. If the distance of the…
A: Given: Magnetic field due to infinity long wire ,B1=B Distance between point and wire, d1=d If the…
Q: F(s) = 1 (s² + 4)(1- eπS)'
A:
Q: V₁ and V₂ have been calculated so the circuit can be simplified and arranged as a potential divider.…
A: The question is calculated potential V using potential divider.
Q: If an 8-bit binary number is used to represent an analog value in the range from 200 ounces to 700…
A: Step 1-->We have, analog range 200 ounces to 700 ounces Binary number(n)=8
Q: Activity 4: Let the start date of the project shown in Activity 3 be January 1, 2020. Determine…
A: First lets prepare a project network diagram as shown below
Q: A signal of 5 kHz frequency modulates a carrier of frequency 1 MHz and peak voltage 25 V. If the…
A: Given, Frequency of modulating signal, fm=5 kHz Frequency of carrier signal, fc=1 MHz Peak voltage…
Q: is (t) (* = 0 IF R{ v For the RC circuit above, the initial voltage across the capacitor is zero.…
A: Given a circuit with following data R = 2kΩ C = 25μF is(t) = 10mA Switch is closed at time t = 0…
Q: A moving coil instrument requires 20mA and 100mV for full-scale deflection. What is the value of the…
A: Given data, Full scale deflection current Im=20 mA Full scale deflection voltage Vm=100 mV Current…
Q: Finally, the multimeter is used to measure VOUT_C for the third potential divider. The circuit…
A: We need to find out the output voltage for given circuit
Q: Find the energy stored in the m 1H 24V 6Ω www
A: Given data, Circuit diagram is given as,
Q: 5. Determine the current,power 'X' in the 4ohm resistance of the circuit shown in below.(N/D-2015)…
A: Solution !! i) total current = 4.5A
Q: Vs VA R₁ 1₁ R3 Vc VB R₂ 2 = 100 (2, R3 = 50 (2, R4 = 90 02, and Vs = 10 V. 01 Substitute the values…
A: This question belongs to circuit theory . It is based on the concept of mesh analysis in the circuit…
Give an example of a material’s electrical property.
Step by step
Solved in 2 steps
- I would like to know...what are electronic applications of specific conductive and resistive materialsWhat are the possible limitations in measuring electrical properties in materials (e.g., conductors, semiconductors, and insulators)?Graphically show the effect of changes in temperature on the resistance of conductors, semiconductors, and insulators.
- 5c.State hooke’s law and explain it to the changing state of materials.1. Briefly describe engineering materials.Find out which of the following statements is/are ALWAYS TRUE for the resistivity and conductivity of a material? I. The resistivity of a material is temperature-dependent. II. The conductivity of a material is temperature-dependent. III. As the resistivity of a material increases. its conductivity decreases.
- Question 3 a. Some materials exhibit the property of superconductivity under certain conditions. State what is meant by superconductivity and explain the required conditions for the material to become superconducting. b. The diagram below shows the cross-section of a cable consisting of parallel filaments that can be made superconducting, embedded in a cylinder of copper. copper cylinder filament The cross-sectional area of the copper in the cable is 2.28 x 10-7 m². The resistance of the copper in a 1.0 m length of the cable is 0.075 N. Calculate the resistivity of the copper, stating an appropriate unit. State and explain the what happen to the resistance of the cable when the embedded filaments of wire are made superconductive? i.this is the ability of a material to conduct electricity a. impedane b. conductance c. reactance d. capacitanceEnergy levels in an n-material compared to a p-type material Please choose one: a. is the same b. is bigger c. is lower
- In high voltage engineering( brielfy explanation each ionization and parts) What do you mean by ionization ? Explan different types of ionizationsa). Explain the difference between an electrical conductor and an electrical insulator. (b). Give an example material/object of a conductor and an insulator.Discuss the variation of resistivity with temperature for insulators, semiconductors and conductors. Support your discussion with resistivity versus temperature graph/curves