Given a parallel plate capacitor where the medium between the 2 plates is pure vacuum, the cross sectional area is 6 x 10³ m² and the separation between the plates is 5 mm: Determine the value of the capacitance for the capacitor. ii. If a 120 V source is connected to the capacitor, determine the magnitude of charge on each plate? iii. Determine the charge on the plate if acrylic is placed between the plates. The thickness of the acrylic sheet is 5 mm and its relative permittivity is given as 6. iv. Calculate the flux density for the capacitor states in part (iii).

Given a parallel plate capacitor where the medium between the 2 plates is pure vacuum, the cross sectional area is 6 x 10³ m² and the separation between the plates is 5 mm: Determine the value of the capacitance for the capacitor. ii. If a 120 V source is connected to the capacitor, determine the magnitude of charge on each plate? iii. Determine the charge on the plate if acrylic is placed between the plates. The thickness of the acrylic sheet is 5 mm and its relative permittivity is given as 6. iv. Calculate the flux density for the capacitor states in part (iii).

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3PA: You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors...

See similar textbooks

Similar questions

In reference to the load, how are capacitors connected to help prevent voltage spikes and surges? Are capacitors connected in parallel or in series with the load?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
4. In what form is the energy of a capacitor stored?
In a pure capacitive circuit, does the current lead or lag the voltage?
Can current flow through a capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
The plates of a parallel-plate capacitor are square and have the length of one side. 20 cm and the distance between the plates is 0.5 cm. The material between the plates is air.What is the capacitance of a parallel plate capacitor in farads?
What will happen to the value of the current if the capacitance will be increased or decreased? Explain further
Determine the capacitance of each other and tolerance of each capacitors shown below
Qno.3 If the equivalent capacitance between a and b is 10„F for the combination of capacitors shown in Figure 2. Calculate the value of capacitance "x" All capaci- tances shown in figure are in pico farads. 4.0 10.0 X 2.0 Figure 2
3.1 A capacitor is made up of two dielectric materials A and B of relative permittivity of 2.5 and 4, and thickness 1 mm and 3 mm respectively connected in series. 3.1.1 If the cross-section of each dielectric is 500 mm2 determine the total capacitance.
In the box below, show that the time constant r is the time it takes the voltage across a discharging capacitor to reach the value V0/e.