Given the following data, which part do you think has the highest water potential or has the ability to pump water and minerals to parts/ regions with lower water potential? * Parts Water Potential in Megapascal (Mpa) unit -0.1 Mpa АВ CD -1Mpa EF 1 Мра GH 2 Мра IJ - 5 Mpa

Given the following data, which part do you think has the highest water potential or has the ability to pump water and minerals to parts/ regions with lower water potential? * Parts Water Potential in Megapascal (Mpa) unit -0.1 Mpa АВ CD -1Mpa EF 1 Мра GH 2 Мра IJ - 5 Mpa

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Homework: Apply Grueblers to determine DOF and is it Grashof? CopyreMedra Education A ed Norrodutoner n thereenentof edre 51.26 View as a videa so http://www.designof- machinery som/DOM/ oil pump.avi 47.5 76 12
%AY |I1, 76% fTV s INTV Uo 10:21 یلیجرام 2.pdf Q1 1. How can recognize an extensive or intensive properties such as density, colour of gold, Volume of water in a graduated cylinder. 2. Drive the relation 1-x = Vavg - 3. A glycerin pump is powered by a 5-kW electric motor. The pressure differential between the outlet and the inlet of the pump at full load is measured to be 211 kPa. If the flow rate through the pump is 18 L/s and the changes in elevation and the flow velocity across the pump are negligible, the overall efficiency of the pump is (a) 69 percent (b) 72 percent (c) 76 percent (d) 79 percent (e) 82 percent. Q2 1. While solving a problem, a person ended up with the following equation at some stage: E 25 kJ +7 kJ/kg where E is the total energy and has the unit of kilojoules. Determine how to correct the error and discuss what may have caused it. 2. Define isolated system, specific gravity and thermal equilibrium. 3. Initially P-400 kPa and T-400 °C, as shown in FigQ2-1. What is…
Florida Tidal power plant is one of the famous efficient tidal plant. What is the energy or power capacity if the barrage area is equal to 1,820 sq.m. and vertical height range of 3.2 meter where the sea water density is equal to 1.020 kg/hr. A) 73.24 KW В 83.242 Kw 90.282 Kw 93.242 Kw
An automobile lift in the Karsha car wash and service station raises 5.6 kN car of 2.4 m above the floor level from the ground,As shown in the below given figure , If a hydraulic cylinder has a piston of diameter 234.5 cm . Find the following: (a) Necessary Work to lift the car vehicle (in J) (b) Required Pressure to lift the car in pascal (c) Power needed to the raise the car in 0.8 minutes in kW (d) Speed of the the lift for 505 m3 per minute in m/s and Required flow rate for the vehicle to descend in 5.9 seconds. m3/s
I need help calculating these values using the defined quantites: Fin using the given values (remember its units are m3/hour) the mass flux of water of the inlet stream E from the given values (make sure that it is in the correct units!) Vp= Volume of pond ** For this question, assume that Fin, Fout, and E do not change over time, and that Vp is at steady state Quantities: Pond geometry: r = 100 m; h = 8 m. cin = 0.5 g/m3 (constant over time); ci = 0.01 g/m3 Fin: The inlet stream can be approximated as rectangular in cross-section, with width w = 3 m and depth d = 1 m, and an average velocity uin = 0.5 m/s. E: The evaporation rate can be determined from the evaporative volume flux of 0.1 mm/hour.
a) In an open vessel, a certain volume V of water is perfectly agitated by means of an impeller 20 cm in diameter D. Consider a case in which the impeller steadily rotates at 150 RPM (=revolutions per minute) Draw up a proper energy balance to find how temperature changes with time as a result of the power input øw, also named P, by the revolving impeller. This P is given by the formula P = 3.5 PN³DS in which N denotes the impeller speed in revolutions per second. Calculate P. When V = 120 litre and the specific heat of water amounts to 4.2 kJ/kgK, calculate the temperature increase of the water after one hour of stirring.
1: 18 PM | 19.0KB/ 65 BME ASsignment 2 .pdf Sr. Assignment Questions Bloom's No taxonomy level What is the physical significance of gas constant? Write about combined gas law, Gas constant and non-flow process? Prove that Cp-Cy=R with usual notation. 1 R 2 R 3 U 4 Represent the following compression process on p-v diagram with the same initial R condition (1) constant volume (2) constant pressure (3) Isothermal (4) adiabatic Differentiate isothermal process and adiabatic process. Show that change in internal energy AU = m Cv (T2-T1) for perfect gas. 5 R A 7 Prove that dryness fraction + wetness fraction= 1 R What is dryness fraction? Explain throttling calorimeter A sample of gas occupies 24.0 m³ at100.0K.Determineitsvolume at 200.0K 10 | 1kg of air at a 9 bar pressure and 80 °c temperature undergoes a non-flow work Polytropic process. The law of expansion in pV1l=C. the pressure falls to 1.4 bar during process. Calculate (1) final temp. (2) Work done (3) change in internal energy (4)…
Find the air horsepower of an industrial fan that delivers 26 cu.m/s of air through a 1 m x 1.2 m duct3; pressure of 127 mm of water; air temperature is 21 C and barometric pressure is 760 mm HG. 43.18 kW 42.62 kW 38.12 kW 39.72 kW
An automobile lift in the Nizwa service station raises 6.6 kN car of 3.4 m above the ground floor level,As shown in the below given figure , If a hydraulic actuator has a piston of diameter 404 cm . Find the following: (a) Work necessary to lift the car vehicle (kJ) (b) Required Pressure to lift the car. in pascal (c) Power needed to the raise the car in 0.6 minutes in watts (d) Speed of the the lift for 580 m3 per minute in m/s (e) Required flow rate for the vehicle to descend in 4.5 seconds.in m3/s
What would be the rotation rate (in rad/sec) if during rotation the water in the right leg (with a diameter of d) decreases a distance h13D0.07 m? U-tube. Elevation = 20 cm %3D 20 cm 2d - Elevation 0 %3D -20 cm- +20 cm-
Liquid biofuel (density= 789 kg/m3) is being pumped from a storage tank through a pipe with 1-inch innerdiameter (ID). The fuel is being pumped at a rate of 3.00 gallons per minute. In this process, what is thekinetic energy transport rate (Ėk) in units of horsepower (hp) and ft•lbf/sec.
find Step 1: Known, UnknownStep 2: SchematicStep 3: FormulaStep 4: CalculationsStep 5: Discussion A 30 cm diameter pipe, conveying water, branches into two pipes of diameters20 cm and 15 cmrespectively. If the average velocity in the 30 cm diameter pipe is 2.5 m/s, find the discharge inthis pipe (m3/s). Also determine the velocity (m/s) in 15 cm pipe if the average velocity in 20cm diameter pipe is 2 m/s.