How many microliters of a 904.0 ppm Co2+904.0 ppm Co2+ stock solution are required to prepare 20.00 mL20.00 mL of a 19.0 ng/?L Co2+19.0 ng/μL Co2+ solution? Significant figures are graded for this problem. Be sure you do not round your answers until the very end of your calculations.

Q: If 50mL of NaOH (mw=40g/mol) solution required 30mL of sulfuric acid (mw=98g/mol) solution in a…

A: The normality of sodium hydroxide has to be given, Formula used, Normality=Gram of equivalent of…

Q: Data for Unknown NaCl Solution Unknown Number 6. Mass of 50 mL beaker 28.94 g Mass of beaker +…

A: The density of a substance is defined as the mass of the substance upon its volume. The density is…

Q: Five different solutions were prepared in the laboratory. One was prepared by dissolving 7.1g of…

A: Answer: Given data- 7.1g of NaOH make 200 ml solution.

Q: A solution contains 6 umol Na,SO, in 284 ml. How many ppm Na" does it contain? A.W Na-23 S-32 0-16…

A: The question is based on the concepts of solutions. we have been given number of moles of solute. We…

Q: Five different solutions were prepared in the laboratory. One was prepared by dissolving 7.1g of…

A: Moles = Mass / Molar mass Molarity = Moles / Volume (L) Also, Initial concentration of solution = M1…

Q: Five different solutions were prepared in the laboratory. One was prepared by dissolving 7.1g of…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Five different solutions were prepared in the laboratory. One was prepared by dissolving 7.1g of…

A: a) Concentration of first solution=Mass of NaOHMolar mass of NaOH×Volume of solution (in L)

Q: A sample of a potential pharmaceutical is being tested for effectiveness at different dosages. 250.…

A:

Q: Calculate [ I- ] given the following information: In a test tube, 2.0 mL 0.060 M KI solution 4.0 mL…

A: The initial concentration of KI or I- (M2) is calculated as follows:

Q: Determine the distance traveled by the solvent if the solute travels 3.1 cm. The weight of the…

A: Given,Solute travels = 3.1 cmWeight of the analyte = 0.984 mgRf value = 0.647Required,…

Q: Pipet (1.0x10^1) mL of a sample solution into a 250.00 mL volumetric flask and dilute to the mark…

A:

Q: A chemist needs to make 3 standard solutions of 10ppm, 50ppm, and 75ppm to read the chloride…

A: A stock solution with 1000 ppm of chloride, which has to be diluted into 10 ppm, 50 ppm and 75 ppm.

Q: a) What mass of a 30% (w/w) hydrogen peroxide solution is required to provide the 3.06g H2O2…

A: Given, mass of hydrogen peroxide =3.06 g volume = 5.0 mL molarity of solution = 3.6 M

Q: Five different solutions were prepared in the laboratory. One was prepared by dissolving 7.1g of…

A:

Q: 0.05 g of acetyl salicylic acid has been dissolved to the volume 25.00 ml to create a stock…

A:

Q: а) Draw the following volumetric glassware: 10.0 mL graduated cylinder, 100.0 mL volumetric flask,…

A: (a) Drawing  of different apparatus, used in volumetric Analysis are - 10.0 mL Graduated Cylinder -…

Q: A dilution of benzene in methanol is made by placing 1.5 mL benzene (density of benzene is 0.879…

A: We know that, density is defined as the mass per unit volume. i.e.                     density =…

Q: How many mL of 15.1 micromolar stock solution are needed to make 50.0 mL of 6.04 micromolar…

A: Consider the given information is as follows; Concentration of stock solution M1=15.1 μM Volume of…

Q: A chemistry student wishes to extract 2.34 g of compound X from 15 mL of an aqueous mixture. She has…

A: Given that : The mass of compound X to be extracted = 2.34 g The volume of the aqueous mixture = 15…

Q: Which is not required in recrystallization? a. solution is filtered at high temperature b.…

A: Remember this point, recrystallization is used for purify the crude sample of compound so that all…

Q: Five different solutions were prepared in the laboratory. One was prepared by dissolving 7.1g of…

A: Since you have asked a question with multiple subparts, we will answer only first three subparts for…

Q: What would be the concentration in ppm of the final solution made by mixing 200. mg of ethanol into…

A: PPM stands for parts per million. It is the mass of solute  dissolved in solution and multiplying…

Q: o determine the amount of copper and the identity of the copper compound in the unknown sample, a…

A: Given :-  Stock volume of copper containing sample = 100 mL  Mass of copper containing sample in…

Q: Compounds used in pharmacology experiments are often initially made as stock solutions. Stock…

A: Solution - According to the question - Given - 1) Acetylcholine stock concentration is 10mM…

Q: How many milliliters of a 2.00% KCl solution are needed to provide a patient with 5.00g of KCl?

A: Concentration of has been defined in many units like molarity, molality, ppm, m/v %, V/V %.…

Q: Part C A 53.5 mL sample of an 9.0 % (m/v) KBr solution is diluted with water so that the final…

A: Part C Solution. 53.5 ml of  9 % M/V KBr solution is diluted with to give final volume 231 ml.…

Q: Five different solutions were prepared in the laboratory. One was prepared by dissolving 7.1g of…

A:

Q: An 8 grams of a powder drug is dissolved in 20mL of pure water. Upon dissolving, the volume became…

A:

Q: Calculate the temporary and total hardness of a water sample containing Mg(HCO3)2= 73mg/L,…

A: Given :           Mg(HCO3)2 = 73 mg/L           Ca(HCO3)2 = 162 mg/L           MgCl2 = 95 mg/L…

Q: What is the standardization factor of this iodine solution?

A: Standardization is the process of determining the exact concentration (molarity) of a solution.…

Q: Use only 1 decimal point (X.X) for all atomic weights. What will be the final molarity of 10.0 mL of…

A: GivenVolume of the intital solution = 10.0mlMolarity of the solution = 12.0MVolume of the diluted…

Q: The boiling point of pure chloroform is 61.20°C.,A solution of 100.0 g of chloroform and 2.67 g of…

A:

Q: What is the normality of a KOH solution given the following experimental data:…

A: Normality is defined as the number of gram or mole equivalents of solute present in one litre of the…

Q: Using M1V1=M2V2 Make 100ml of a solution that contains 0.5mM MgCI2, 15 mM CaCI2 and 120 mM KCI 0.5M…

A: Dilution is the solution prepared by adding the solvent to the stock solution (more concentrated…

Q: A chemist mixes 31.7 g of carbon tetrachloride with 59.7 g of 2-ethyltoluene and 10.5 g of…

A:

Q: Give the mass of the solute and mass of the solvent for 210 gg of a solution that is 0.75 mm in…

A: The molality of a solution refers to the number of moles of solute present in 1 kg or 1000 g of the…

Q: How can you prepare 250 ml, 0.1N HNO3 solution from 35% HNO3      and 1.26 g/cm3  density?

A:

Q: How many microliters of a 857.0 ppm Co²+ stock solution are required to prepare 20.00 mL of a 18.0…

A: volume = ? concentration = 857 ppm = 857 mg/μl 1 ml = 1000μl 20 ml = 20000μl C1VI = C2V2

Q: A solution was prepared by dissolving 35.0 mL of methanol in sufficient water to give a total volume…

A: We have to predict the percentage by volume of given solution.

Q: 500 ml of 2000 ppm of sodium chloride is equal to 1g False True

A: ppm means parts per million. ppm is also expressed in (mg/L). In the case of solute (solid)…

Q: A 335 −mL−mL can of soda pop contains 44 gg of sucrose (C12H22O11C12H22O11). Part A What is the…

A:

Q: o NB3: What is the dilution factor of the 50 mM stock solution relative to the 1 mM solution?…

A: The dilution factor can be determined by the ratio between initial concentration to the final…

Q: Concentrated Standard Solution: 3.0168 weighed mass (NH4)2SO4-FESO4-6H2O g in L of solution 99.70…

A:

Q: MULTIPLE CHOICE: Choose the letter of the best answer Please answer all questions correctly 1. The…

A: Question 1 Answer: B (Cerimetry) Explanation: 1. Use of KMnO4 solution which is standardized by…

Q: You measure out 42 mL of 6.0 M HNO3 to make the 250.0 mL of dilute solution. What volume of…

A: Given, Vacid = 42 ml Vsolution = 250.0 ml Vwater = ?

Q: Calculate the mass of a 400.0 ml solution with a density of 1.5g/ml

A: density (d) is the ratio of mass of substance (m) to volume of solution (V) Density (d) = mass (m) /…

Q: lable Preparatiol Of Standard affeine SOlutions Standard [Caffeine] (mg L-1 or ppm) Volume of Volume…

A: Standard [Caffeine], mg /L or ppm Vol of caffeine stock, mL Vol of internal standard, mL…

Q: The solubility in water of ionic compound X is measured and found to be 0.143 B at 10. °C. Calculate…

A:

Q: 115 milliliters are required to prepare 900 mL of 2.00 M H2SO4 (98.1g/mol) from the commercial…

A: Given: Concentration of commercial H2SO4 (w/w) = 96.5 %  Volume = 115mL New solution of 900mL of 2M…

Q: Question 28

A:

Analytical Tools

Analytical tools or analysis tools help one to get into a conclusion or results from the data collected. Analytical tools can be applied for simple data sets and also in the case of big data analytics.