HWA AC bridge is balanced at 20KHZ with the following components in each arm: Arm AB=10KN, Arm O BC=100µF in series with 100KN, Arm AD=50KN Find the unknown impendence R t jX in the arm DC, if the .detector is between BD

Q: Given, z1=10+j3 and z2=8+j5, determine the argument in two decimal places of the resulting value of ...

A:

Q: A resistor consists of 5 colour bands as shown in Figure la. Find the value of the resistance. [2] F...

A: Resistance Color coding is the special method to label the resistor with its value. The resistor is ...

Q: In the circuit of Fig. 2.75, calculate V1 and V2.

A:

Q: What is the voltage V1 in the circuit in the figure? V1 1Ω 20 10 V 8 A ( 4 A +)15 V +1) 3.

A:

Q: A signal r(t) is band limited to 5kHz; it is sampled at a very high rate of 100kHz using ideal sampl...

A:

Q: 1. Using Kirchhoff's Current Law (KCL) and Kirchhoff's Voltage Law (KVL), equivalent resistance and ...

A: 1) False Using Kirchhoff's law, equivalent resistance can not be obtained 2) True Kirchhoff's Voltag...

Q: Determine the magnitude and phase angle of the total impedance for the circuit below. R Xc 50 Ω 1V 1...

A: Given circuit:

Q: Apply parsevals theorem for n) = E xcn -rok) where x (n) =51 o su<s elge where

A: Parseval's theorem that average power in a periodic signal is sum of average power in its dc compone...

Q: Determine V, in the circuit in Fig. 2.80. 15 2 252 + 10 V +, Vo +. 25 V

A:

Q: a) Find the equivalent resistance of this circuit as seen from terminals A and B. b) Find the equiva...

A: In this question,  We need to find the equivalent resistance of this circuit as seen from terminals ...

Q: . 810. A PID controller has a derivative gain of 48. What is the integral gain and proportional gain...

A: We need to find unknown constant for PID controller and pole for controller

Q: In the circuit in Fig. 2.76, obtain vi, V2, and v3. +20 v - - 60 V + 40 V - + v2 - + 40 V V3

A:

Q: 2. Draw the sketch of 'Drilling machine' and explain any four parts. Use pencil to draw the neat ske...

A: In the diagram below, a radial drilling machine is depicted. This is intended for drilling holes in ...

Q: RS 2502 Vi Vz 1202 18V-234 ISV

A: We need to find out load resistance and power rating of zener diode

Q: Determine the following: (a) Total Current and Total Power of the circuit; (b) the current passing t...

A:

Q: Determine the total potential energy stored, in microjoules, in a cylinder of radius 7 m and height ...

A:

Q: A 2.5Ω and 2.8Ω resistors, connected in parallel, are in parallel with the series 3.2Ω and 2.2Ω load...

A:

Q: 1Referring to Fig. 424, caleuiate (a) the generator eurrents I and Is () the total battery-charging ...

A:

Q: If characteristic equation is s' +s (K+6)+s(6K+9)+9K =0 ,what is th minimum value for k to be in ord...

A:

Q: (6) Using the method that applies the Laplace Transform to the circuit below, (a) find the expressio...

A:

Q: Find the equivalent resistance Rab in the circuit of Fig. 2.111. 42 8Ω 10 Ω WWo a d Loa 3Ω f

A:

Q: Let G be a d dimensional spherical Gaussian with variance 1/2 centered at the origin. Derive the exp...

A: The distribution which forms a curve like a bell or a bell curve is known as Gaussian Distribution. ...

Q: mplify the block diagram shown in following figure and obtain the closed-loop ansfer function C(s)/R...

A:

Q: An inductor has an inductance of 1H. It is connected in series with a resistance of 23Ω. It is fed f...

A: This question belongs to circuit theory . It is based on the concept of transient analysis in RL cir...

Q: Find the equivalent resistance Rab in the circuit of Fig. 2.111. 6Ω ww 8Ω 10 2 wwo a d bow e ww 3Ω 3...

A: This question comes under network theory . It is related to calculation of equivalent resistance of ...

Q: Find the convolution of the following functions x[n] =[ 111] x[n] =[ 13 5 ] and а. b. What does the ...

A: The solution is given below

Q: Determine the Laplace transforms in Problems 1 to 9. 1. (a) 21 – 3 (b) 5t²+41 – 3

A:

Q: 1. a) Use the mesh-current method to write a complete set of independent equations that could be use...

A: Given the circuit, as shown below: a) We need to use the mesh current method to write a complete se...

Q: Consider two LTI systems A and B in cascade described by the differential equations: dv/dt + v = x d...

A:

Q: Find I, in the network in Fig. P2.55. 4 k2 7KO 31x 6 mA 2ΚΩ 8KO Ix Figure P2.55 ww

A:

Q: Schematic Diagram (Parallel RC) R1 = 1kN R2 = 100 C1 = 1µF – Metallized film Vp( R1 6Vpp at 500 Hz. ...

A: The solution is given below 

Q: Question 30 Solve for beta(5) collector current is 6.236mA and emitter current is 6.292mA. O 114.16 ...

A: This question belongs to analog electronics . It is based on the concept of relation among base curr...

Q: The wattage rating rating of an appliance, ?, varies jointly as the square of the current, ?, and th...

A:  Wattage                   W ∝ I2 R                  W = k I2 R Where k is constant of variation. ...

Q: In the microcomputer-controlled class-A IGBT transistor d.c. chopper shown in Fig.2., the input volt...

A: Given Ra =0.28Ω La =30 mH Full speed n= 2500 rpm Ia  =30 A

Q: mplify the block diagram shown in following figure and obtain the closed-loop ansfer function C(s)/R...

A: The transfer function can be obtained by reducing the parallel connected and cascade connected block...

Q: o 1f vg =ze volts assume V(o)=0. 452 నో

A:

Q: give me tips and solved questions on Thevenin's & Norton’s

A: Please find the attachment

Q: 2. For the network shown in the figure and the applied source: lic + IR i, = 5 x 10-3 sin(377t – 20°...

A: We will apply KCL at upper node and get: iR+iL+iC=iSe3kΩ+ej4kΩ+e-j2kΩ=5∠-20° mAe13-j4+j2=5∠-20°e(0.4...

Q: 1. Given Rs Determine: a. If the diode is "ON" b. IL, Is, Iz C. Pz 2202 Vi Vz RL 20V 10V 1802

A: The solution is given below

Q: 724 PART I Abranced Crouit Analyes cos ar.= 24 -1. Answer: 19) Figuel6 ha 4

A: Fourier transform is used for time domain discrete signals. It is used for converting the time domai...

Q: Find the total resistance of the circuit

A:

Q: for a certain load the power is -735 VAR , 1040 VA. the values of of the power factor and the active...

A: Given data, Reactive power, Q=-735 VAR Apparent power, S=1040 VA  

Q: 12 V 2.22k Rc SV Rb 4.7K GND

A: When the NPN transistor is used as a switch. The base current of the transistor is used to control t...

Q: Sketch v, for the network of Fig. 2 and determine the de voltage available. Ideal diodes 170 V 2.2 k...

A:

Q: Q) 13. For the network of Fig. 5.153 : 12 V 5.6 k2 a. Calculate I B,IC, and re. b. Determine Zi and ...

A:

Q: 5. Using nodal analysis, find V,, V, and V3 5A win Vi V2 V3 5 A ±) 12V

A: The solution is given below

Q: 2. Assemble the following program, starting address 200OH. P • MVI A, 8FH • MVI B, 68H • SUB B • STA...

A: The program are defined as MVI A, 8FH: 2 Byte instruction MVI B, 68H : 2 Byte instruction SUB B: 1 B...

Q: 五。 4.0 Iz 多62 Ve nd Y-Patametar

A:

Q: Mc エ2 Mc Me Mc トIs FS→-ダー→s→e 一ター>

A:

Q: 1. Calculate position of Fermi level in n-type silicon with donor concentration of 3x1017 cm-³ at a ...

A: Brief description : Generally semiconductors are divided as two types  1.Intrinsic semiconductors an...