i) The general dividing line between reflected and emitted IR wavelengths is pproximately ( ) (a) 1 µm (c) 3 μm (b) 2 μm (d) 4 μm

Q: Identify the types of cells that contain chloroplasts

A: Chloroplasts are the food producers of the cell. The organelles are only found in plant cells and…

Q: When lava cools on the surface of the Earth, what type of rock is created? A. Metamorphic B.…

A: Molten rock that explodes onto the Earth's surface from a volcano or vent is called lava. This…

Q: this is wrong I believe each mineral should be used once

A: 1- Olivine2-Halite 3- Kaolinite 4- Cholorite 5- Muscovite 6- Biotite

Q: 69 66 65 67 65 69 64 64 62 68 Draw contours on the following map using a contour interval of 5 feet.…

A: Contours refer to lines on a map that connect points of equal elevation. These lines, known as…

Q: Concepts in Physics and Earth Science Rock Identification Name: Paulina Gonzalez   Identify each…

A: The extrusive rocks are formed when the cooling of rocks happens on the surface of the Earth.…

Q: Rock Descriptions: A B C D E F G H I J granite basalt sandstone limestone granite siltstone…

A: If we are taking about the sequence from granite to gabbro we are looking at the process of rock…

Q: Weathering and Erosion The Rock Cycle Heat + 11 Pressure Melting and re-solidifying and

A: Rock cycle is a process of transformation of rock phases that shows three different kinds of rocks,…

Q: How do astronomers know that globular clusters are made up of old stars?

A: Globular clusters are dense, spherical groups of stars that are bound together by gravity and are…

Q: Refer to the chart and identify each rock-forming mineral in Fig. A4.4.1 by writing its name below…

A: specimen 1     is olivine as it does not have any cleavage plane.specimen 11    is hornblend as it…

Q: I just needed a simple answer like #1 HAS THREE CLEVAGE FACES and #5 only has one. what do the other…

A: The term "cleavage" describes how a mineral fractures along specific weak points to produce smooth,…

Q: Use the travel time curve below to determine the distance of each seismogram from the Locate the…

A: The term "seismicity" describes the occurrence, distribution, and analysis of seismic events, which…

Q: An important discovery found that a highly abundant species of cyanobacteria is dependent on…

A: The question is asking us to identify the form of nitrogen that a certain species of cyanobacteria…

Q: How has Sverdrup's Critical Depth Hypothesis been supported?

A: The objective of the question is to understand how Sverdrup's Critical Depth Hypothesis has been…

Q: 3. The resistivity logs above are for the same interval as the logs for questions 1 & 2. Answer the…

A: A resistivity log is a type of well log used in the field of petroleum geology to measure the…

Q: C. REFLECT & DISCUSS The rock shown in Fig. A5.2.2ª has a porphyritic texture, which means that it…

A: The rock in the image has a porphyritic texture, which means that it contains two distinct sizes of…

Q: Explain what type of rock each of these are sedimentary , metamorphic or igneous.

A: A solid, naturally occurring substance made of minerals, mineraloids, or organic materials is…

Q: Explain in detail

A: The objective of this exercise is to create a GIS project for a chosen national park, gather and…

Q: 1. What have you observed in your rock samples? 2. What do you think is the purpose of water in the…

A: Water, rocks and soil make up the basic elements of the Earth and the geosphere, and govern the…

Q: When heat is transferred through electromagnetic or radio waves it's called radiation. When heat is…

A: Since you have posted a question with multiple sub parts, we will provide the solution only for…

Q: The thickest sediments are found: A) On the deep ocean floor, just over the edge of the shelf B) In…

A: Sediments are loose, solid particles that accumulate over time through various geological and…

Q: 2.9 Explain the effect of temperature on the fall velocity of sand. How much variation during a year…

A: Sand fall velocity is influenced by temperature in two main ways-Fluid viscosityExplanation:The…

Q: what is behaviour of rocks homogenous in geotechnical engineering

A: In geotechnical engineering, the behavior of rocks that are homogenous (homogeneous) refers to how…

Q: Classify and explain the geological situation in which the oil traps in the figure occurred.

A: Oil traps are geological formations that are important in the recovery of oil and natural gas. These…

Q: What is the Cambrian Explosion and how does it relate to both geologic and biological evolution

A: The Cambrian Explosion was a pivotal event in Earth's history that occurred approximately 541…

Q: 3. The citizens decide to retest the water and obtain a new average of 11.2 +/- 0.2 micrograms per…

A: The stated precision (+/- 0.2 micrograms per liter) indicates an improvement over the prior data,…

Q: Various tectonic plate boundaries are shown in the diagram in the figure. Indicate what type they…

A: The objective of the question is to identify the types of tectonic plate boundaries shown in the…

Q: When a pressure gradient moves lighter, warmer air over the land towards denser, cooler air over the…

A: The question is asking about a specific meteorological phenomenon that occurs when there is a…

Q: 3. The resistivity logs above are for the same interval as the logs for questions 1 & 2. Answer the…

A: A resistivity log is a type of well log used in the field of petroleum geology to measure the…

Q: Indicate in each of the boxes in the figure the type of metamorphism that would be characteristic…

A: The objective of the question is to identify the type of metamorphism that occurs in different…

Q: When a parcel of air rises it ( expands / Compresses) Select ? This process causes the air to (heat…

A: A number of changes that occur to air as it rises in the atmosphere have an impact on cloud…

Q: A diagram representing an unconfined primary sandy aquifer is given below. Use the given information…

A: Since you have posted multiple questions, we will provide the solution only for the first question…

Q: a. Calculate the SLCA RERP values for the two products in the Table. Numbers on the left side are…

A: SLCA RERP (Structured Life Cycle Assessment Reliability, Maintainability and Supportability) is the…

Q: An asymmetric split spread extends from x1 = -400 m to x2 = 800 m. A reflection observed on the…

A: Normal move out (NMO) correction is a process used in seismic data processing to correct for the…

Q: describe the Cosmological Principle and its significance to the study of the Universe.

A: A fundamental idea in the study of the cosmos, the Cosmological Principle offers a framework for…

Q: Large-scale areas of upwelling, such as the Peruvian upwelling system, contribute to some of the…

A: The objective of the question is to identify what large-scale areas of upwelling, like the Peruvian…

Q: 2) Why do you think it is important to understand that processes happen at different scales when…

A: The objective of the question is to understand the importance of recognizing that processes occur at…

Q: Presentation about Disaster Risk Management on Flood and Disaster Risk Management on Typhoon,…

A: Disaster :A disaster arises from either natural or human-induced factors, resulting in an abrupt…

Q: Characteristics and functioning of an oceanic-oceanic convergent plate boundary.

A: The objective of this question is to understand the characteristics and functioning of an…

Q: Determine the amount of throw across the two faults labeled AA and BB, located near the southern…

A: Heave: The vertical displacement or offset that happens along a fault is referred to as "heave" in…

Q: In areas where tidal mixing occurs throughout the year, and the water column doesn’t remain…

A: The question is asking us to identify which organisms can thrive in areas where tidal mixing occurs…

Q: Layers of the Earth sort

A: There are multiple layers that make up the Earth's interior, and each has unique characteristics.…

Q: In 2004 to 2010 or so, Mount St Helens volcano experienced renewed activity, which can be seen in…

A: Igneous activities refer to geological processes involving the formation, movement, and cooling of…

Q: Presentation about Disaster Risk Management on Flood and Disaster Risk Management on Typhoon,…

A: Title: "Calamity Hazard The board: Exploring Floods and Storms"Slide 1: "Understanding Calamity…

Q: scale refers to the physical size, length, distance, or area of an object, or to the physical space…

A: Scale denotes the ratio or correlation between a specific distance or occupied space on the map and…

Q: Molten thymol in the cold petri dish crystallized in 1 minute and looked like this enlarged view.…

A: Geological crystals range in size from tiny flakes to multi-ton behemoths. Their size is determined…

Q: Summarize what is meant by plate-mantle convection and explain two of the primary driving forces of…

A: Plate moving is sustained by plate-mantle convection, an inherent geologic process. It entails the…

Q: Match the term to the correct definition. 1 2 ✓ Sea-level rise Sea-level fall 1. Transgression 2.…

A: Sea-level rise is transgressionSea-level fall is regression

Q: Proxima Centauri is part of the Alpha Centauri star system. It is the nearest star to the Solar…

A: Let us assume Proxima Centauri is Proxcent.“Proxcent” will be used instead of Proxima…

Q: Describe a prominent ethical dilemma for global warming.

A: The term "global warming" describes the gradual rise in Earth's average surface temperature brought…

Q: Using any reference, search and plot the climate patterns of the given countries for each month…

A: Climate refers to the long-term patterns and average conditions of temperature, humidity,…