Answered: If the current flowing through a 75 mH…

If the current flowing through a 75 mH inductor has the waveform shown in the Figure (a) sketch the voltage which develops across the inductor terminals. i(t) (A) -1 1 0 2 3 t(s)

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Related questions

Q: H(s) = + is the transfer function of a 2nd order lowpass filter. If R-2500 02, C-0,5 μF, L-1 H and…

A: Since given input is sinusoidal, output will also sinusoidal except magnitude and phase change .…

Q: Design a circular aperture antenna with a field distribution over its opening of E = C[1-(p'/a)²],…

A: According to the question, we need to design a circular aperture antenna with a field distribution…

Q: An initially uncharged parallel plate capacitor is connected to a circuit containing a battery with…

Q: 30 Ω resistor in the circuit in the figure. and 1.273 mH coil to the source with a frequency of 5…

Q: The mathematical model of a system is gº"(t) + ∞y"(t) + by(t) =="(t) + cz(t) where a=0, b=1 and c=3.…

A: Given Data: A system of,To Find:Zeros and poles.S-plane.BIBO stability.

Q: Consider the transfer function 6s² + 6s +12 3s² +9s +6 Which one of the following state-space…

Q: If the current gain of a BJT Transistor is 200 and the collector current is 100mA, What is the base…

A: Current Gain (β) is defined as the ratio of collector current and base current.i.e., β =…

Q: Question 2 Determine v (t) for all t in the circuit of Figure Q2. Sketch the response, v(t). 392 24…

A: To determine v(t) for all t in the given circuit. Sketch the response, v(t).Here, the given circuit…

Q: 1. The switch in the circuit given below has been in position "a" for a long time. At t=0, it moves…

A: The given circuit is shown below.The switch in the circuit has been closed in position "a" for a…

Q: Translation: Given that the Beta value is 80 and the IC current is 1mA as stated above, what is the…

A: Here given a circuit and asked to calculate the collector resistance value.

Q: Consider the circuit shown in the figure. Take R₁ = 2R, R₂ = Rand R3 = R, find the magnitude of the…

Q: An average voltage of 20 V is induced in a 500-turn solenoid as a result a change of flu which…

A: Induced voltage e=20 volts,Number of turns N=500Change of flux which occurs in time dt=0.5…

Q: A square cross section of a magnet has a strength of 50,000 lines of flux and a flux density of 1.25…

Q: Problem#1 Determine the ohmmeter reading in the figure below. W 10 92 www 2012 www 33 02 68 1 560…

Q: Two loads connected in parallel are respectively 2 kW at a pf of 0.75 leading and 4 kW at a pf of…

A: It is given that:

Q: V₁ 4092 1x + ww 800 22 200 S2 1 + 16092 ww 16.2Vx + Yandaki şekilde verilen devrenin Hybrid (h)…

Q: 2) for the circuit given below V-150cos(1000t) V and the mutual inductance between two inductors is…

A: Given:A circuit, with, and mutual conductance between inductors is 500 mH. To find:Complex power…

Q: 1) Find zeros and poles of the system. 2) Show them onto the S-Plane (the complex plane) 3)…

A: The given mathematical model of a system is written below..Here .We need to find the zeros and poles…

Q: Electromagnetic question Consider a hollow cylindrical surface centered on the z-axis with radius r…

A: To calculate the magnetic field intensity (H) in the different regions described, we can apply…

Q: Develop a simple Arduino-based System that will utilize TIMER and LED. Present your answer in the…

A: It is asked to develop a simple Arduino-based System that will utilize TIMER and LED.We need to…

Q: Consider the state equation x(t) = [²3²]x(t) and the similarity transformation x = Px The matrix P…

A: The given state equation is,

Q: Find Dout for the Sigma Delta ADC given below when Vin = 0.7 V and Vref= 1 V. Difference amplifier…

A: Delta-sigma converters are ideal for converting signals over a wide range of frequencies from dc…

Q: 7. Calculate the power dissipated in each resistor in the circuit in Fig. 3.104. 0.51, 1Ω 4Ω 8 Ω 10…

A: In this question we need to find the power dissipation in each resistance.To determine power…

Q: The signal x(t) is applied at the input of an LTIC system shown below. Determine (a) X (ω) (b) H (ω)…

A: Given signal isThe circuit is

Q: How do you mathematically derive this modified refractivity equation? M_rf = (77.6/T)*(P + 4810e/T)…

A: M_rf = (77.6/T)*(P + 4810e/T) + 0.157zWe need to mathematically derive this modified refractivity…

Q: 2. The switch in the following circuit has been closed for a long time and it is opened at t=0. Find…

Q: d A 3-phase, 4 pole, 415 V, 50 Hz, star-connected induction motor has the following circuit…

Q: (Q1) For the following circuit, v₁ = 2v & v2 is a sine wave with an amplitude of 4v. V10 V20 OVO -Vs…

A: Given Data:An Op-amp with,Inverting input Non-inverting input To Find:Plots of .Plot of the output…

Q: Provide me with at least five suggestions for the proper storage and use of electronic devices.

A: Here are five suggestions for the proper storage and use of electronic devices:

Q: Q. What is the output resistance, rds, in kΩ for an NMOS FET operating in saturation with Id = 989μA…

Q: Being the following circuit, to analyze only the effect of the Is or Vs sources, the resistances…

Q: the following truth table: (119-no), = (abcdefg), ABCD F 0000 X 0001 a 0010 b 0011 0100 d 0101 0110…

A: It is mentioned to assume , here no.The given truth table of the Boolean function is shown below.

Q: For an inverting amplifier the input waveform is shown in the figure below. Assume that the voltage…

Q: Consider the resistive circuit shown below. Find the minimum power/wattage ratings of the resistors…

A: The labelled circuit is redrawn above

Q: 2. The swich in the circuit in Figure has been open a long time before closing at t = 0. Find vo(t)…

A: Switch is closed at t=0Asked to find v(t) for (t)

Q: vitch in the circuit shown below has been in position y for a long time. At t=0, the moves…

Q: by 55 dt² output is The transfer function of the system described dy dt du. = 2+ 4u, with u as input…

A: It is given that:

Q: Deisgn a counter that counts cars coming in and out of a barriered car park that then closes the car…

A: I will design a car counter system for a barriered car park that keeps track of cars entering and…

Q: RF direncinin değerini k cinsinden bulunuz. Find Re in ΚΩ V₁=16 Volts, V₂=20 Volts, Vout=-47 Volts…

Q: Find the values of I1 and I2?

Q: 6. Determine the total impedance, ZȚ and I in the circuit below. I 50/60° V + 4Ω -j10Ω 6Ω j8Q

Q: 2. Complete description of an FM modulator (transmitter) and an FM demodulator (Receiver) 3.…

A: Since the solution of all the other parts 2,3 and 4 has already been provided I will provide the…

Q: A cos t V a. Zin=42,00+j2,40 ohm b. Zin=38,00+j2,00 ohm c. Zin=53,00-13,50 ohm xQ d. Zin=38,00-j2,00…

A: In this questionWe need to choose the correct option.What is the input impedance Z. We knowInductive…

Q: . Find the load impedance in the circuit shown in the following figure for maximum power transfer.…

Q: A unity negative feedback system has the open-loop transfer function: K(s+1) s² + s +1 What value of…

A: In this questionWe need to choose the correct options. What is break in point of the given system.

Q: Q1. Assume that an infinitely long cylindrical shell extending between r = a and and r = b contains…

A: The above question is based on the calculation of the electric field by Gauss's law.

Q: Consider the circuit shown in the figure. The capacitance C₂-9,3 μF. C₁ = 15 µF C₁ = 25µF 9₁ Q₂=C₂2₂…

A: The given circuit is shown below.Given values of the capacitances areF.F.F.We need to determine the…

Q: 1. What is the state of the MOSFET shown below? a. Sub-threshold. b. Below saturation. c. Above…

A: A MOSFET.

Q: Q1 a. Consider you have to choose b/w the Full-Wave Bridge Rectifier (FWBR) & Center-Tapped Full…

A: It is an electrical device that is used to convert AC power into DC power. This DC power can be…

Q: Question 7 . Full explain this question and text typing work only We should answer our…

A: R1=10 ohmR2=12 ohmL=3mHC=?Power delivered by voltage source real meanTotal impedance seen by the…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

If the current flowing through a 75 mH inductor has the waveform shown in the Figure (a) sketch
the voltage which develops across the inductor terminals.
i(t) (A)
-1
2
0 1
12
3
t (s)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Determining i(t) in different time intervals

VIEW

Step 2: Calculation of v(t)

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
R = 91 ohm L = 93 H C = 3 mF Can you please find the equation for the voltage across the capacitor ..
In the circuit below, Find the voltage across the inductor at time t = 0.000909 s. The values are V1 = 146V, R = 4.4 ohms, L =0.02 henries
The current through a 10 mH inductor is shown in the figure below. Sketch with proper labels the voltage waveform in the same time interval. Show your solution.
An inductor and a resistor are in series with a sinewave voltage source. The frequency is set so that the inductive reactance is equal to the resistance. If the frequency is increased, then options: Voltage across the inductor= Source Voltage Voltage across the inductor> Voltage across the resistor Voltage across the inductor= Voltage across the resistor Voltage across the resistor > Voltage across the inductor