Answered: If three #10 AWG THHN/THWN wires were…

If three #10 AWG THHN/THWN wires were run in a conduit inside a building the MAXIMUM size fuse or circuit breaker you could use to protect these wires would be

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter28: Overcurrent Protection–fuses And Circuit Breakers

Section: Chapter Questions

Problem 8R: List the standard sizes of fuses and circuit breakers up to and including 100 amperes. ____

See similar textbooks

Related questions

Q: Can Type TW cable be used in an area that has an ambient temperature of 65degreesC?

A: IN the NEC table of standard cables, it is given the correction factors for the TW cable at…

Q: What is the smallest square box that will accommodate four No. 12 conductors and four No. 10…

A: conductor A conductor is any piece of material that easily allows heat or electricity to pass…

Q: How much cubic inch space is required inside a box for 4 #6 XHHN current carrying conductors?

A: When employed, space provided by the rings of plastic, domed covers, extension rings, as well as…

Q: what wire size is needed on a one 20 amp, 120-volt laundry branch circuit? what wire size is needed…

A: 12 gauge what wire size is needed on a one 20 amp, 120-volt laundry branch circuit.

Q: essential electrical system in health care facilities

A: Circuit classified essential electrical system in health care facilities is shown in below

Q: True or False If a metal rack is properly grounded the equipment that is mounted on the rack and…

A: The above-mentioned statement is TRUE which states that the equipment which is mounted on the rack…

Q: Give me about ten examples of electrical code violations in maintenance and repair. Hopefully the…

A: Choose the wrong Circuit breaker There is a need to follow the national electric code. 1. Standard…

Q: The minimum depth for a 120-volt, 20-ampere, GFCI protected circuit to an outdoor receptacle run…

A: The depth for the underground installation of the cable is described in the Electric code Section…

Q: Mention the different parts of the Solar evacuated tubes used for heating purposes

Q: what is the largest size overcurrent protection device (fuse or breaker) allowed to protect the…

A: Concept: The circuit which is used to electrically describe and model either continuous materials or…

Q: A 600 volt, 100 amp class K fuse will fit into the same fuse holder as a 600 volt ,100 amp RK fuse.…

A: Class K fuse- This is the fuse available in the DC Rating. Current and voltage ratings are…

Q: The NEC requires that each service-disconnecting means be suitable for A. the prevailing…

A: The service disconnecting mechanisms used to isolate a building's premises wire from the utility…

Q: What authority enforces the compliance set by NEC

A: The National Electrical Code or the NEC provides a set of standards which must be followed during…

Q: Explain why GFCI protective devices won’t work on multiwire branch circuits unless they are designed…

A: GFCI : Ground fault circuit interrupters These are installed to provide ground fault protection…

Q: Which of the following statements about equipment grounding conductors (EGCs) is true? A. The…

A: Statement about the equipment grounding conductors (EGCs)

Q: Can a round 4 in. x 1/2 in. box marked as 8 cu in. with cable clamps supplied with 14/2 W/G NM cable…

A: Given data: Can a round 4 in. x 1/2 in. box marked as 8 cu in. with cable clamps supplied with 14/2…

Q: Draw the possible block diagram (at least THREE devices) that could be found in this black box and…

A: The black box is a term refers to a device or a set of devices for which only the value of the input…

Q: What is the largest voltage drop in the wires that is allowed by the code?

A: As per the NEC keeping in mind about the performance issue. The NEC recommends the largest voltage…

Q: What is the NEC code for a receptacle by a pool

A: NEC stands for National Electric code. It is standard for safe installation of Electrical wiring and…

Q: What are Diagram,Construction, Operation, Advantages and Disadvantages of Air Blast Circuit Breaker.…

A: link https://circuitglobe.com/air-blast-circuit-breaker.html

Q: A 14/2 type NM copper used for a general lighting branch circuit Ampacity : Maximum fuse or circuit…

A: Circuit breaker:- Circuit breakers are used for safety purpose in electrical equipment. It is used…

Q: Write specifications details of all types of wiring/ cables

A: Electrical wiring A method of connecting different accessories for electrical energy distribution…

Q: What are Diagram,Construction, Operation, Advantages and Disadvantages of Air Circuit Breaker

Q: A wiring job requires 7,645 feet of cable. If the cable comes in 250 ft. coils, how many coils of…

A: Given: The total length of the cable required is 7645 feet. The length of a cable coil is 250 feet.…

Q: A water heater nameplate indicates 4200 watts @ 240 Volts. What is the maximum current draw? What…

Q: What device can determine how far a cable damage is

A: Cable faults are defined as an unacceptable characteristic or performance of the cable utilized in…

Q: The minimum value of current at which the fuse element melts is called?

A: The minimum value of current at which the fuse element melts

Q: What is the largest size circuit breaker or fuse permitted to protect this wire

A: Concept: The circuit which is used to electrically describe and model either continuous materials or…

Q: Four 6 AWG THW Cu conductors are installed in the same conduit to supply fastened-in-place…

A: Given Ambient temperature =30 degree celcius three conductors are carrying current

Q: What are Diagram,Construction, Operation, Advantages and Disadvantages of Oil Circuit Breaker.…

Q: What is the NEC code for receptacle near a pool

A: NEC stands for National Electric code. It is standard for safe installation of Electrical wiring and…

Q: Discuss as to how you would connect your landline and mobile to the local telephone exchange using…

A: Mobile Telephone Switching Office(MTSO) An operations center that connects the landline PSTN system…

Q: 14. Which of the following is a condition that must be met in order to qualify for the exemption…

A: Since #14 and #17 are two different questions, as per the guidelines, #14 has been solved in the…

Q: A one-family dwelling has a 175-ampere, 240-volt service that is fed with 75⁰ C (167 degrees)…

A: One family dwelling means to construct a house which is only suitable for one family.

Q: Which of the following is an installation requirement for the grounding electrode conductor in a…

A: ANSWER - (A,C,D) is correct EXPLANATION- Option (A)- Grounding…

Q: 20.a. What's the maximum number of switches or circuit breakers the service-disconnecting means may…

Q: Assuming that an outlet box for the entry ceiling has a fixture stud but has external cable clamps,…

A: Evaluating the number of conductor required for outlet box: The number of conductors present there…

Q: an electrical system operates at a potential higher than 600 volts, the nonmetallic conduit must be…

A: The correct option is 2inches.

Q: What is the maximum size Grounding Electrode Conductor regardless of the size of the

A: In this we will write about the maximum size Grounding Electrode Conductor regardless of the size of…

Q: what is the largest size conductor allowed to be used with a wirenut

A: Wire nut is an electrical connector used to connect two or more than two wire together. largest…

Q: an office building has an area of 36,000 sqft, and the number of receptacles is unknown. How many…

A: It is given that an office has an area of 36000 sqft and number of receptacles are unknown.First,…

Q: Explain what is PPE. Mention the PPEs used to protect the Head, Face, Eye and Breathing…

A: Given A question to explain about PPE and PPEs used to protect different parts

Q: Couses EEP Draw a WIRING DIAGRAM for wiring Two Way - One Gang Switches (51 and S2) to control…

Q: Terminals of switches and receptacles marked CO/ALR are suitable for use with _______________,…

A: The term CO/ALR is abbreviated as Copper Aluminium Revised. The switches are rated as 15 A and…

Question

If three #10 AWG THHN/THWN wires were run in a conduit inside a building the MAXIMUM size fuse or circuit breaker you could use to protect these wires would be

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Multiple Choice. Refers to a point in a circuit where three or more wires are connected. A. Conductor B. Junction C. Loop D. Resistor
A 10/3 Type NM copper used for an electric dryer branch circuit ampacity = maximum fuse or circuit breaker size =
For the circuit shown in figure 4 Calculate the value of ITotal & IC1?.
What is a circuit breaker and how does it work to protect electrical systems? Explain its operation and various types used in electrical engineering.
Write the types of fuses
explain the Reasons for coordinating electrical protections
What's the maximum number of 400 kcmil THHN conductors that can be installed in a 6 in. x 6 in. wireway?
True or False: The correct fuse size for an electrical circuit is one that is sized twice as large as needed for circuit protection.
List the standard sizes of fuses and circuit breakers up to and including 100 amperes. ____
Mark the correct statement Select one: Oa. Insulators are those materials that contain electrons that can move freely. Or b. Conductors and insulators are materials with similar electrical properties. Or c. Conductors and insulators are those materials containing electrons that can move freely. Or d. Conductors are those materials containing electrons that can move freely. Are the materials that will be used to make electrical circuits.
Explain Coordination between fuses and over current protective devices.
If the NEC provides a requirement to grounding equipment, it generally implies that there will be a direct connection to Earth of connection through a/an A. Equipment grounding conductor B. Bonding conductor C. Grounding electrode conductor D. Equipotential bonding conductor