(iii), Why is the voltage-divider bias the preferred bias configuration? (iv) In a certain voltage-biased npn transistor, VB is 2.95 V. The DC emitter voltage is (a) 0.7 V (b) 2.95 V (c) 2.25 V (v) The emitter current is always (a) greater than the base current (b) less than the collector current (c) greater than the collector current (d) 3.65 V (d) answers (a) and (c)

(iii), Why is the voltage-divider bias the preferred bias configuration? (iv) In a certain voltage-biased npn transistor, VB is 2.95 V. The DC emitter voltage is (a) 0.7 V (b) 2.95 V (c) 2.25 V (v) The emitter current is always (a) greater than the base current (b) less than the collector current (c) greater than the collector current (d) 3.65 V (d) answers (a) and (c)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

with the aid of a diagram describe a simple common emitter circuit with npn bipolar transitor and discus the relationship between base emitter voltage and base current
The term cut-off for a transistor refers to a. the transistor is at its operating point b. no current flow from emitter to collector c. maximum current flow from emitter to collector d. there is no base current
(b) If the base current is 100 mA and the current gain is 30, the emitter current is?
Why is the base current in transistor much less than collector current
Why is the collector current much larger than the base current?
All field-effect transistors are unipolar rather than bipolar devices. That is, the main current through them is comprised either of through an N-type semiconductor * ..... .....
Problem-5 The LED in Figure below requires 30 mA to emit a sufficient level of light. Therefore, the collector current +Vcc should be approximately 30 mA. For the following circuit values, determine the Re amplitude of the square wave input voltage necessary to make sure that the transistor saturates. Use double the minimum value of base current as a safety ON ON margin to ensure saturation. OFF Vcc = 9 V, VCE(sat) = 0.3 V, Rc = 220 N, RB = 3.3 kÝ Bpc =50, and VleD = 1.6 V. 1
In the common emitter configuration the base emitter junction and collector emitter junction are a. forward bias and forward bias b. reverse bias and reverse bias c. reverse bias and forward bias d. forward bias and reverse bias
Q6:A) A transistor dissipates 50W in an ambient temperature of 60°C.The thermal resistance are exc-0.5 the junction temperature without a heat sink. Determine the thermal resistance of the heat sink to avoid the junction exceeding 170°C. °CW¹,0a-4°CW.Determine 5% single polver supply
The maximum drain current for the n-channel enrichment type MOSFET is 30 mA.Determine VGS with this current level if k= 0.06x10-3 A/V2 and VT is the maximum value.
For the common emitter configuration, the current amplification factor (B) is 90. What will be the value of the current amplification factor (a)? a. 0.5 b. 0.95 c. 0.978 d. 0.989
The statements below are true except (the transistor is Si) A. collector emitter voltage of 8.7V B. Base collector voltage of -8V C. Transistor dissipates of a power of 13mW D. Transistor is in the active region