In a geotechnical laboratory an oedometer test on a saturated clay soil was conducted. The results in the laboratory report stated that the Cc = 0.2, Cr = 0.04 and OCR = 4.5. The existing vertical effective stress in the field was 130 kPa. A building foundation was designed to construct above the soil condition. This will increase the vertical stress at the center of the clay by 150 kPa. The thickness of the clay layer is 2 m and its water content is 28%. Solve the primary consolidation settlement and determine the difference in the settlement if OCR value were 1.5 instead 4.5.

In a geotechnical laboratory an oedometer test on a saturated clay soil was conducted. The results in the laboratory report stated that the Cc = 0.2, Cr = 0.04 and OCR = 4.5. The existing vertical effective stress in the field was 130 kPa. A building foundation was designed to construct above the soil condition. This will increase the vertical stress at the center of the clay by 150 kPa. The thickness of the clay layer is 2 m and its water content is 28%. Solve the primary consolidation settlement and determine the difference in the settlement if OCR value were 1.5 instead 4.5.

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter10: Shear Strength Of Soil

Section: Chapter Questions

Problem 10.25CTP

See similar textbooks

Similar questions

Question 3 a) In a geotechnical laboratory an oedometer test on a saturated clay soil was conducted. The results in the laboratory report stated that the Ce= 0.2, C, -0.04 and OCR = 4.5. The existing vertical effective stress in the field was 130 kPa. A shallow foundation was designed to construct above the soil condition. This will increase the vertical stress at the center of the clay by 50 kPa. The thickness of the clay layer is 2 m and its water content is 28%. Solve the primary consolidation settlement and determine the difference in the settlement if OCR value were 1.5 instead 4.5.
In an undrained triaxial test on a sample of saturated clay the all-around pressure is maintained at 1.0 ton/sq.ft. The unconfined compressive strength is 3.62 tons/sq.ft. At what vertical load in addition to the all-around pressure should the sample fail?
Question The unconfined compressive strength of a saturated clay sample is 54 kPa. The value of cohesion for the clay is
A cohesionless soil is subjected to a shear test. The normal stress and shear stress on the failure plane at failure were determined to be 400kPa and 350kPa respectively. Which of the following most nearly gives the angle of the failure plane measured from the major principal plane?
A cohesionless soil is subjected to a shear test. The normal stress and shear stress on the failure plane at failure were determined to be 400kPa and 350kPa respectively. Which of the following most nearly gives the most principal stress?
A CD triaxial compression test conducted on a clay specimen revealed that c'=5 kPa and o'=22°. What is the major principal stress at failure if the confining pressure is 35 kPa? Solve the problem graphically and then analytically.
A plate loading test was carried out on a medium dense sand, using a 1 ft wide square plate, and k1 was determined as 350 lb/in3. Determine the coefficient of subgrade reaction for a 7.5 ft wide square foundation and a 7.5 ft × 10.5 ft rectangular foundation.
The soil profile at a site consists of 10 m of gravelly sand underlain by a soft clay layer. The water table lies 1 m below the ground level. The moist and saturated unit weights of the gravelly sand are 17.0 kN/m3 and 20.0 kN/m3, respectively. Due to some ongoing construction work, it is proposed to lower the water table to 3 m below the ground level. What will be the change in the effective stress on top of the soft clay layer?
A dry cohesionless soil is tested in a triaxial test to determine the angle of internal friction f. A confining pressure equal to 1,000 psf is used. The sample fails when the axial load causes a stress of 3,200 psf. What is the value of f?
Q.9 An unconfined compression test was conducted on an undisturbed sample of clay. The initial area of the specimen is 1105 mm?. The load at failure measured by the proving ring was 32N and axial strain at failure was 0.162. The undrained shear strength of the clay will be
A soft clay in an unconfined compression test did not develop a failure plane but bulged during the test. The sample was 40 mm in diameter and 85 mm in length. The load carried at a strain of 15% was 70.4 N. Determine the shear strength.
A soil specimen is subjected to a tri – axial test. The soil specimen is cohesionless. If the shear stress that causes failure is 300 kPa. and the normal stress at failure is only 500 kPa 5. Determine the angle of shearing resistance in degrees 6. Determine the angle that the failure plane measured from the major principal plane. 7. Determine the total axial stress in kPa at which failure is expected to occur.