In the calculation of the maximum available valid host addresses in each subnet, the total addresses is subtracted by 2 addresses that are used for the following: 19 : 1 Choose one a. Network Address and Default Gateway IP Address answer. b. Default Gateway IP Address and Broadcast Address. c. Subnet mask and Default Gateway IP Address d. Network Address and Broadcast Address. You're being assigned a task of subnetting a Class B network, so you choose 172.29.100.0/28. Which of the following answer choices reflect a valid VLSM subnet that can b obtained from your Class B network? 20 Choose one a. 172.29.100.104 answer. b. 172.29.100.60 c. 172.29.100.32 d. 172.29.100.8

In the calculation of the maximum available valid host addresses in each subnet, the total addresses is subtracted by 2 addresses that are used for the following: 19 : 1 Choose one a. Network Address and Default Gateway IP Address answer. b. Default Gateway IP Address and Broadcast Address. c. Subnet mask and Default Gateway IP Address d. Network Address and Broadcast Address. You're being assigned a task of subnetting a Class B network, so you choose 172.29.100.0/28. Which of the following answer choices reflect a valid VLSM subnet that can b obtained from your Class B network? 20 Choose one a. 172.29.100.104 answer. b. 172.29.100.60 c. 172.29.100.32 d. 172.29.100.8

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

An IP address can be written as a 32-bit number. For a class B network, the two most significant bits are set to 10. The 16 most significant bits are used as a network ID, and the 16 least significant bits are used as a host ID. However, the host ID cannot be all 0's or all 1's. How many hosts (i.e., host IDs) can there be on a class B network?
Refer to the network figure above, showing two Ethernet Subnets connected through an IP Router, answer the following question 1-5. The devices in each subnet are connected locally to each other through layer two intermediate devices such as Ethernet switch and ethernet hub. For each device in the subnets, both its Internet Protocol (IP )address and its MAC address (also called the Physical address or the Ethernet address are shown. The subnet mask used by all devices is 255.255.255.240 (which is the same as the prefix length “/28”). 1. If Client #1 wants to send a broadcast packet to all the devices on the left subnet (containing client #1, client #2, client #3) what destination IP address should be used? (Mention in both binary and decimal format.) 2. What is the first and last assignable IP address for the left subnet above (containing client #1 and #3)? (Mention in both binary and decimal format.)
An IP address can be written as a 32-bit number. For a class B network, the two most significant bits are set to 10. The 16 most signi cant bits are used as a network ID, and the 16 least signi cant bits are used as a host ID. However, the host ID cannot be all 0's or all 1's. How many hosts (i.e., host IDs) can there be on a class B network?
You, the network administrator, has been assigned the task of setting up the network for the company NETpal, as shown in the below diagram. You have been allotted a pool of IP addresses of 107.47.96.0/19. OFFICE R was the first subnet to be set up and Computer B has an IP address of 107.47.96.106/23. The others are to be set up, in the following order are, fourteen (14) IP addresses for the WAN, four hundred and eighty six (486) IP addresses for OFFICE S and one thousand, eight hundred and seventy five (1875) IP addresses for OFFICE Q. (a) In the a.b.c.d/n notation (i) For OFFICE R, what were the number of addresses allocated and its broadcast address? (ii) What is the network address of OFFICE Q? (iii) What are the network and broadcast addresses for the WAN?
The following shows the part of the entries in a routing forwarding table. Prefix Match Link Interface 11001000 00010111 00010 11001000 00010111 00011000 1 11001000 00010111 00011 2 otherwise 3 The packages with the following destination IP addresses (DAs) will forwarded to which interface? DA1: 11001000 00010111 00010110 10111111 → Interface DA2: 11001000 00010111 00011000 10101111 → Interface DA3: 11001000 00011101 00010110 10111111 → Interface DA4: 11001000 00010111 00011001 10101111 → Interface DA5: 11001000 00010111 00011000 00000001 → Interface
39. The figure below shows the TCP Congestion Window for various transmission rounds of a TCP connection. 20 18 16 14 12 10 4 2 2 4 6 10 12 14 16 18 20 Transmission Round How many more (or less) segments will TCP Tahoe send compared to TCP Reno between the transmission rounds 12 and 16 inclusive (i.e., t12 to t16) for the same sequence of events as shown in the graph above (i.e., loss events at t11, tl4 and t16)? a. TCP Tahoe send 13 less segments compared to TCP Reno b. TCP Tahoe send 20 more segments compared to TCP Reno c. TCP Tahoe send 13 more segments compared to TCP Reno d. TCP Tahoe send 20 less segments compared to TCP Reno e. TCP Tahoe send 28 less segments compared to TCP Reno Congestion Window (MSS) 00
Q6 A company has 4 branches (LANS) connected through a router. As a network expert you are required to design the IP configuration of these branches in three scenarios: Scenario one: If you have been given 4 class C IP addresses, i.e. one for each branch, what a is the maximum number of devices (hosts) per each branch? Note that the first usable host address is typically reserved as a gateway (router) address. Scenario two: If you have been given only the IP 200.75.64.0/25. Use subnetting b technique distribute the IP's in a table showing the Subnet/Branch IP, usable host range (excluding the gateway address), the gateway address, the broadcast address and the subnet mask for each subnet/branch. Show all you calculation/design steps. Scenario three: If each branch is designed to have up to 4 staff members with only one device each. You have been informed that the number of branches may increase in the future. Using the same given IP in part b, improve your C design to maximize the…
A UDP packet is to be sent to a network with MTU=1460 Bytes. The size of UDP data field is 2992 Bytes. Assume this packet is fragmented when traversing the network. Please give the values for the following IP header fields in each IP fragments: Total Length, MF and Offset. Note: Assume IPV4 is used. There is no option field in IP header, i.e., the size of IP header is 20 Bytes. The size of UDP header is 8 Bytes. All numbers are in decimal.
The given IPV6 subnet address is 2001:0DA7:FF00:FAF8: :/64. • Use the above IPV6 address for Subnet 0. • Increment the subnet field by 1 and find the IPV6 address for the remaining subnets. • Write simplified IPV6 address. Subnet IPV6 network address (Write simplified IPV6 address) Number 1 3. Complete the 2 following IPV6 addressing table 3 using IPV6 subnetting. Follow the instructions given below and write the IPV6 address in the table.
Which of the following instructions falls in the category of data transfer instructions? JUMP LOAD ROTATE AND
An ISP is granted a block of addresses starting with 130.100.0.0/16. The ISP needs to distribute these addresses to 4 large companies. Each company requires 1024 IP addresses. Write the address ranges for these companies into the following table with /n notation. Company First address Last address 1 2 3 4
Answer the following questions: The IP address is based on your student number SN as follow: The first byte is 198. The second byte is the 6th and 7th numbers of your SN, for example, if your SN is 438051221, the second byte is The third byte is the 8th and 9th numbers of your SN, for example, if your SN is 438051221, the third byte is The forth byte is 0. Consider a company which owns a license of this IP address. Write this IP address, for example 198.12.21.0 How many hosts at the maximum can be in this network? What are the first and the last addresses given to hosts? The company likes to divide its network into 10 subnets. Determine the necessary number of bits borrowed. Determine the new subnet mask. Determine the maximum number of hosts in each subnet. Fill the following table Subnet Subnet address First host address Last host address Broadcast address 1…