In the experiment of the acid dissociation constant of a weak acid using potentiometric titration, what primary standard was used to standardize NaOH in this experiment? Give the appropriate equation for the reaction.

In the experiment of the acid dissociation constant of a weak acid using potentiometric titration, what primary standard was used to standardize NaOH in this experiment? Give the appropriate equation for the reaction.

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter15: Additional Aqueous Equilibria

Section: Chapter Questions

Problem 32QRT: The titration curves for two acids with the same base are shown on this graph. (a) Which is the...

See similar textbooks

Related questions

Q: How will the amount of hydrochloric acid titrant used for the analysis be affected if the mixture of…

Q: The sample is dissolved in a mixture containing 10ml of distilled water and 20 ml of dilute…

Q: Synthesis of benzoic acid 1. What qualitative test is performed to monitor precipitate formation of…

A: Benzoic acid being an carboxylic acid which is aromatic in nature and hence used in preservative in…

Q: The substance to be analyzed – is white, highly soluble in water salt. Addition of diluted sulfuric…

A: The solution is as follows:

Q: Assess the suitability of methyl orange to signal the equivalence point in weak acid and strong base…

A: Methyl orange is a widely used pH indicator in titrations.

Q: For which titration is phenolphthalein the best choice? Explain your reasoning and support with…

A: Titration is a technique in which a solution of known concentration is treated with a solution of…

Q: How would the calculated value of pKa of the unknown acid be affected (higher, lower, or no change)…

A: The correct answer is given below

Q: A 39.3 mL aliquot of ammonia that has a concentration of 0.655 M will be titrated with 0.304 M HCl.…

Q: What are the functional groups for the Qualitative Tests for carbonyls and Unknown Carbonyl.

A: We are given an unknown carbonyl compound and its test results and IR spectrum.

Q: Iodometric titration of vitamic C with sodium thiosulfate Why was the known excess of iodine…

A: Ascorbic acid (vitamin C) is mainly found in fresh fruits such as lemon, orange, lime, peach,…

Q: Why was the flame test used for the qualitative determination of K and Na?

A: The identification or determination of the ions present in a sample is done using qualitative…

Q: In the experiment, 75 mL of 3M sulfuric acid is used to extract the 3-nitroaniline. In order to…

Q: Use the titration curve for the weak acid to calculate the pH of a 0.150 M solution of that weak…

A: The pKa of the acid will be equal to the pH at half equivalence point which can be determined by…

Q: Describe why the inside wall of the flask is rinsed with deionized water during accurate titration.…

A: During accurate titration we need to rinse the inside wall of the flask with de-ionized water…

Q: etermin

A: The absolute technique in which mass can be used to find quantity needed to electrolyze the…

Q: Why did the colour of the solution in the conical flask change at the end of the titration?

A: In the titration there is color change at the end.

Q: In the test for ammonium (NH4+) ion, why should you take care that the litmus paper is not wet with…

A: ammonia gas can be detected by its pungent odour (it smells a lot like cat pee) and it will turn…

Q: Before you proceed with the titration proper, you must first determine the exact concentration of…

A: In general before titration we first determine the exact concentration of titrant it against a…

Q: Describe what is done in a displacement titration and give an example.

A: In displacement titration a complex is formed as analyte displaces a reagent, and amount of…

Q: Describe how to analyze a solution of Nal by using the Volhard titration?

A: Solution - According to the question - Given - Volhard titration - The volhard method is an indirect…

Q: What would be the effect of a more dilute solution of NaOH on the titration?

A: In the titration process , the titrant is added slowly to the unknown solution . When we dilute the…

Q: Why is the electrometric method of pH determination more accurate than the colorimetric method?

A: The Electrometric Method for assessing a solution's Hydrogen Ion Concentration, or pH value, entails…

Q: Why is Potassium Chromate used as the indicator in Mohr Method Determination of Chloride? Explain

A: Potassium Chromate used as the indicator in Mohr Method for determination of Chloride.

Q: After a student determined the pK values of a H3PO4 by titration, she realized that she had recorded…

A: In the titration, pka Value is determined by titration with H3PO4 with NaOH. Molarity of NaOH Used…

Q: Ethanol is needed as solvent when preparing phenolphthalein color indicator in volumetric…

A: Ethanol - class of alcohol containing 2 carbons and 1 alcoholic group and it is a industrial…

Q: Explain the problem with each of the following techniques. The sodium hydroxide solution was not…

A: Distilled water you add to NaOH solution will change its volume but will not change the number of…

Q: Question attached

A: In a sample of water, there are many ions like calcium, magnesium and aluminium is present. Many of…

Q: Why should deionized water he used throughout the analysis?

A: Metal ions are formed by loss of electrons from metal. Electrons are negatively charged particles…

Q: At any stage of the saponification experiment of ethyl acetate, when the 25mL sample taken from the…

A: First we will calculate the amount of HCl used for reacting with excess NaOH left in saponification…

Q: Why should the solution be adjusted to pH 10 prior to EDTA titration?

Q: Why is it not necessary to know the exact volume of deionized water added when preparing the samples…

A: Since we know the volume and concentration of the acid or base taken for the titration hence the…

Q: What is the graduated glass tube used to add the titrant (base) to the analyte (acid)?

A: 1) To identify the graduated glass tube which is used to add the titrant (base) to the analyte…

Q: Phenolphthalein (transition pH range 8.0-9.6) is very appropriate for the titration of KHP with…

A: Phenol saline which has an essential progress scope of a pH =8 guide gracious toward 9.6 would be…

Q: Calculate the pH of the NH3/NH4Cl buffer after the addition of NaOH. How does it compare to the…

A: The pH of a basic buffer solution is determined using the Henderson-Hasselbalch equation - pOH =…

Q: Is the standardization of titrant always the first step in all titrimetric analysis? Why or why not?

A: To find: If the standardization of titrant always the first step in all titrimetric analysis?

Q: Explain the reason behind the addition of the starch indicator near the endpoint for this analysis.…

A: Starch is an indicator used in iodometric titration and it turns dark blue when iodine is present in…

Q: What is the primary standard used in this experiment (acid and base titration of HCl,KOH). Give the…

A: Acid-base titration involves the reaction between reaction between acid and base. Acid will be…

Q: When one would like to run an experiment with EDTA, sometimes it is necessary to do back titration.…

A: Sometimes when performing EDTA titration the metal ions block the indicator or metal EDTA complex…

Q: The titration curve from the reaction of a strong base with a weak acid is shown below. Recalling…

Q: 2. What is the physical observation when the endpoint has been achieved during titration?

A: Endpoint: refers to the point at which the indicator changes color in an acid-base titration.

Q: How would the calculated molar concentration of the analyte be affected if the burette is rinsed…

A: Before starting any titration it is very important to rinsed the burette with the corresponding…

Q: In the preparation of the titrant, the solution must be aged for at least 24 hours in the dark.…

Q: Why is the titration done with vigorous swirling?

A: Titration is the process of chemical analysis where the quantity of some constituent of sample is…

Q: Why should be solution of sodium bicarbonate be boiled during titration with HCI?

Q: Is a Kd value of 10.16 reasonable for the extraction of benzoic Acid between methylene chloride and…

A: In a simple liquid–liquid extraction the solute partitions itself between two immiscible phases. One…

Q: What makes bromocresol green and phenolphthalein suitable for the double-indicator process?

A: An indicator is added to a solution based on whether it is acidic or basic and what pH is being…

Q: An unknown sample containing mixed alkali (naoh, nahco3, or na2co3) was analyzed using the double…

Q: 25.0 mL sample of vinegar was analyzed via titration in the same manner as you will use in this…

A: We have given that Volume of NaOH =V1=10.5ml Molarity of NaOH =M1=0.950M Volume of vinegar solution…

Q: A mixture of Al3+ and Mg2+ in a sample of water. Explain a procedure to analyse this mixture using…

A: Aluminium ion, Al3+, form stable complex with EDTA than Mg2+does.

Q: Draw flow chart for the extraction of mixture containing a. Acid and Base

A: Given : mixture of an acid and base. To find : Draw a flow chart of acid base extraction. Solution…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

The titration curves for two acids with the same base are shown on this graph. (a) Which is the curve for the weaker acid? Explain your choice. (b) Give the approximate pH at the equivalence point for the titration of each acid. (c) Explain why the pH at the equivalence point differs for each acid. (d) Explain why the starting pH values of the two acids differ. (e) Which indicator or indicators, phenolphthalein, bromthymol blue, or methyl red, could be used for the titration of Acid 1? For the titration of Acid 2? Explain your choices.
What is the methodology of acid base titration for sodium hydroxide and hydrochloric acid.
Why is the ration of strengths of acids and bases significant in titration?
Which one of the following titrations is expected to have a pH < 7 at the equivalence point?
Why do we use a solid acid as a primary standard? During the standardization of NaOH, Shane didn’t notice that there was an air bubble in the tip of the buret when they started their rough titration. The bubble went away during the rough titration and Shane continued with two fine titrations. Does this affect the calculated concentrations of NaOH? Why or why not?
Use a primary standard to determine an unknown concentration using an acid-base titration. Potassium hydrogen phthalate is a solid, monoprotic acid frequently used in the laboratory as a primary standard. It has the unwieldy formula of KHC8H404. This is often written in shorthand notation as KHP. If 39.86 mL of a potassium hydroxide solution are needed to neutralize 2.437 grams of KHP, what is the concentration (mol/L) of the potassium hydroxide solution? M
Is it possible to use phenolphthalein as indicator in the titration of a strong base with a strong acid?
Why is titrant added rapidly at the beginning of titration but more slowly as titration proceeds?
Why are the standard reagents used in neutralization titrations generally strong acids and bases ratherthan weak acids and bases? Explain.
What is the difference between the endpoint of a titration and the equivalence point?
Use a primary standard to determine an unknown concentration using an acid-base titration. Potassium hydrogen phthalate is a solid, monoprotic acid frequently used in the laboratory as a primary standard. It has ths unwieldy formula of KHC3H,O. This is often written in shorthand notation as KHP. If 34.47 mL of a barium hydroxide solution are needed to neutralize 1.279 grams of KHP, what is the concentration (mol/L) of the barium hydroxide solution? M Check & Submit Answer Show Approach étv A hulu 20 ITA 44 F7 411 4A F10 DOO F8 F9 %24 4 %23 8. 6.
How would the titration curves differ if the volume of the acid used was halved?