In the following circuit,L2= 1.7 mH, R= 7.6 Ohm, C= 9.9 uF, the angular frequency w= 10000 rad/s, the source voltage amplitude VB is 7.8 v. What is the amplitude of the current through L2? VB R L2 ll

Q: H.W.// Find the current i(t) in the network in Figure shown below: i(t) 20 Ω v(t) = 120 sin 50 μΕ…

A: Given:R=20 ΩL=40 mHC=50μF

Q: Find the equivalent impedance for the circuit element group below if the frequency is 600 F R2 4k L1…

A:

Q: 0 Sketch v, for the network Vi 20 V -20 V Vjo M 9122 Vz = 8 V + 0.22 ΚΩ

A: We need to find out the output voltage for given circuit

Q: Using phasor analysis determine the voltage vo across the inductor in the circuit given in the…

A:

Q: For the circuit below calculate Zin in rectangular form if w = 100 rad/s L=0.04H R=10 V out C=0.25F

A:

Q: What is the potential difference between points P and M with respect to the system in the figure?…

A: We need to find out potential difference between P and M .

Q: For the following pairs of sinusoids, determine which one leads and by how much. a. v(t) = 14cos(4t…

A: We need to find out phase of given signal then we will find out which one leads

Q: R t = 0 ' i(t) Vs Find the transient component current value i(t) at t = 3msec for the values %3D Vs…

A: According to question we need to calculate value of i(t) at t= 3msec.

Q: Q2: find Z equivalent if the frequency is 50: R2 R3 502 Zeq =4mF m 752 2H R1 3022 3mF

A:

Q: Two alternating voltages are given as v, (t) = 5sin(5t +30°) V and v2 (t) = 5cos(10t - 60°) V. Find…

A: We need to find phase difference between the given signal

Q: For the circuit, find Vo if the input is sin(t) as shown in figure .below 1 k2 1V- +5 V 1k2 o Vo -1…

A: In this question, draw the output voltage Vo  If input voltage is Vi= sint

Q: In the following circuit i4 sin 2t A, and 5-0. 1 H 2H 1 H The voltage v is (A) -16 cos 2t V (B) 16…

A: Two conductor are inductively coupled when change in current in one conductor induce voltage in…

Q: For the circuit as shown in the figurel, Find i,(t), VL(t) and the phase angle between v,(t) and…

A: Referring to the given circuit all the elements are connected in series then the equivalent of…

Q: Determine the voltage vo(t) when vs(t) = 25 cos (100t-15°) V. As shown in the image.

A:

Q: In the given circuit: V t) = 10 cos100t, R= 10KN, L = 1mH, and C= 10mF. Calculate vo(t), R ww C=…

A: From the sinusoidal steady state response

Q: 19. An RLC series circuit has an applied voltage of 120 volts. R = 42 2, XL = 80 N, and XC = 24 N.…

A: The solution is given below

Q: In the following circuit,L2= 4.4 mH, R= 8.4 Ohm, C= 9.5 uF, the angular frequency w= 10000 rad/s,…

A:

Q: M (b) Given two current waveforms, UTM & UTM 8 UT Is(t) = 30 sin (wt + 50°)A M UTM %3D I9(t) = 10…

A:

Q: Find Vy(t) in the circuit shown below M= 10 mH 10 10mH 10 + Vy - 20 20MH cos(100t+90) 5 cos(100t)…

A:

Q: For the circuit in figure 7 2 Ω VR 2 cos(1000r) VL 5 mH 2 µF Figure 7 Detemine the phasor values VR,…

A: The RLC  circuit is shown below: The current through the given RLC circuit will be calculated, the…

Q: 42 58V + +lov LOOPI AND LOOPI

A:

Q: 60. In a series RC circuit, ET = 240 V, R=30 N, and Xc=40 N. What is the apparent power? %3D a.…

A:

Q: Find the equivalent impedance for the circuit element group below if the frequency is 600 Hz R2 4k…

A: In this question,  Find the equivalent impedance Z  If 2 impedance are connected in parallel, then…

Q: When the given Delta circuit is converted to Wye circuit, the resistance values in the Wye circuit…

A:

Q: 3. Compute: a) E, sin(t) 6 (t – ) dt b) -(t³ – 2t² + 10t + 1)8(t)dt 00

A: In this question,  Find the value of given signals.  We are solving this problem using the Delta…

Q: Compute a single equivalent impedance for this circuit for a source frequency of f =50 Hz. Express…

A:

Q: For the circuit in figure 7 2Ω VR 2 cos(1000f) VL 5 mH Vc 2 μF Figure 7 Detemine the phasor values…

A: The value of the voltage across the capacitor, inductor and the resistor is to be determined for the…

Q: 10Ω 0.05 Η : 10 Ω 5Ω V 400 μF 0.02 Η

A:

Q: Consider the circuit shown in the figure below. Find the phasors Is, V, IR. IL, and Ic- i,(1) = 0.01…

A: From the above question the given data is as follows: The source current:ISt=0.01cos104tPhasor form…

Q: R 10 mH 100 2 o b 80 2 ?For the circuit shown above, what is the magnitude of the equivalent…

A: The solution is given below

Q: A R2 R3 ib=aii R1

A: Given

Q: 4. Figure below shows a series-parallel AC circuit. Find the total impedance, total admittance,…

A: Given a circuit and asked for following ZT, YT, IS, VC

Q: :Q2: find Z equivalent if the frequency is 50 R3 R2 R1 552 792 3052 3mF Zeq :4mF 2H

A:

Q: 3. A circuit has a real power of 320 W and a reactive power of 110 VARS. A reactive power of 458…

A: The solution is given below

Q: 3 Given that the current through a circuit element as i(t) = 10sin(377t +85°) mA Dotormine the…

A: The circuit this is excited the use of alternating supply is referred to as an AC Circuit. The…

Q: When the given Delta circuit is converted to Wye circuit, the resistance values in the Wye circuit…

A:

Q: v = 10 sin (wt +30) : = 5 sin C ut + 70°) (a). v= 10 sin (wt - 20) (97 i = 15 sin (wt + 60) i = 2…

A: a..>> v(t)=10sin(wt+30o)i(t)=5 sin(wt+70o) So phase difference between voltage and current is…

Q: Consider a sinusoidal emf source, v(t) = Vm sin (@t) results of current of i(t) = Im sin (@t+0) is…

A:

Q: Problem Continues: In the circuit below, calculate the phase angle of the phasor current through the…

A: The solution is given below

Q: 150 X V 75V 32 Q f-60HZ %3D Figure 37 The magnitude of the current in the circuit shown in Figure 37…

A: find the explanation below

Q: 3- Using Phasors to Add Sinusoids vi(t) = 20 cos(ot-45) v2(1) = 10 sin(ot+ 60-) %3D

A: Disclaimer:  Since you have asked multiple questions, we will solve the first question for you. If…

Q: -- IS Consider the two-termìnal component of the figure, characterised by the terminals A- B.working…

A:

Q: Use mesh analysis to find it) in the given figure, where is = 4 cos(600t) A, vs = 110 cos(600t+ 30°)…

A:

Q: Find the equivalent impedance for the circuit element group below if the frequency is 600 Hz: R2 4k…

A:

Q: Convert the following to polar form and computethe product. Compare the result with that…

A: a). Using the polar form, Using the rectangular form, Hence, the result is almost equal.

Q: Curve 1 th R, L as shown in n the circuits is C-0.01 ality factor (Q1) for CL

A: The quality factor of a circuit  tell us about how much energy is lost in charging element like…

Q: 80. A series circuit with one branch of R = 60 and a single unknown element in the other branch has…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 400LF 12 22 V 0.4mH

A:

Q: Find the square root of (6 + j7) in polar form, 3.04<24.70° in rectangular form, 2.76 +j1.27 O NFTOC…

A:

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.