In the last column in the data table, it says that it's about voltage(v) divided by current(A) is equal to ohms so V/A = ohms.
Q: An asteroid is spotted from earth moving in a parabolic path with earth as the focus. When the line…
A:
Q: Consider the sheet metal cross section shown in. Suppose that r = 2.2 in., a = 3.2 in., and b = 8.4…
A: Given the metal sheet has the following dimensions:We are tasked with determining the location of…
Q: (a) At what speed (in m/s) will a proton move in a circular path of the same radius as an electron…
A:
Q: A champion dart thrower has decided that he could easily win a spear fishing contest. Unfortunately,…
A:
Q: Consider the R-L-C circuit shown here. Calculate the Q-factor of the circuit. Does the circuit have…
A:
Q: Reference frame S' passes reference frame S with a certain velocity. Events 1 and 2 are to have a…
A: We are presented with the following relationship:Consequently, the gradient of the graph equals…
Q: and (1) T = 400 K. (b) Repeat part (a) for GaAs. in silicon between E, and 3.27 (a) Determine the…
A: The total number of energy states in a semiconductor can be calculated using the density of states…
Q: A karate chop breaks a board with a blow of 3000 N. The force that acts on the hand during this…
A: Given that :Force
Q: Shown in the figure below is a re-creation of the Rutherford experiment. The "target" (green)…
A:
Q: Q14. A horizontal uniform rod of length 1.2m and mass 1.8kg swings freely about one end. An angry…
A: To find the initial angular momentum of the bird, the moment of inertia of the rod-bird combination,…
Q: Consider two nested, spherical conducting shells shown in grey and red in the figure 7. The first…
A:
Q: Find DFT for the sequence [ 0.5 1 1.5-2] using FFT.
A: The FFT algorithm works by recursively dividing the input sequence into smaller sub problems and…
Q: A finite rod of non-uniform charge density λ = 3X0y sits on the y axis, as shown in figure 2 y(m) a)…
A:
Q: Jumping spiders jump by altering the pressure of their body fluid within them, thereby causing their…
A: To solve this problem, we can use the work-energy principle. The work done on the spider by the…
Q: Air moves through a wind turbine with radius 13 m at a uniform speed of 10.9 m/s. The density of the…
A: Radius of wind turbine,Speed,Density of air,To find that how much power is generated?
Q: Q2 - Physics: A motorcycle is going at a constant speed of 80 km/h and passes a vehicle moving…
A: The speed of the motorcycle is constant throughout. It is equal to 80 kmph. In m/s, it is Let the…
Q: At a department store, you adjust the mirrors in the dressing room so that they are parallel and 6.8…
A:
Q: 9) Calculate the maximum number of disintegration per minute of 210Po which could be obtained from…
A:
Q: 4. Consider the loop of wire shown below: P ΦΟ The loop consists of two circular arcs with smaller…
A:
Q: An ideal Refrigerator keeps its inside temperature at 2.00°C while it is 23.0°C outside of it. Which…
A: The coefficient of performance (COP) of a refrigerator is given by the formula:Where: We can now…
Q: To be internally reflected, the light must start in which material? in water in light flint in any…
A: Give are the options, we need to find out the phenomenon of total internal reflection will occur if…
Q: Jessie is an astronaut with a mass of 66 kg in an orbit (a fast moving circular path) around the…
A: In this question we will use the concept of Archimedes' principle.Archimedes' principle states that…
Q: Which of the following is least reasonable regarding a star's position on the HR diagram? Group of…
A: "White dwarfs are small and cool and are located in the lower left part of the HR diagram."This…
Q: monochromatic light is incident on a thin film of chloroform and equals 1.4 over water and equals…
A: The coating has higher refractive index than the actual interference medium. i.e. water…
Q: In a double-slit experiment, the slit separation is 0.160 mm and the width of each slit is 0.020 mm.…
A: In a double-slit experiment, the interference pattern is produced by the superposition of the light…
Q: Light of wavelength 550 nm illuminates a double slit, and the interference pattern is observed on a…
A:
Q: An optical fibre communication link 5 km long is to be constructed with an analogue modulation…
A: GivenAn optical fibre communication link 5 km long is to be constructed with an analogue modulation…
Q: An infinite solenoid with radius a and n turns per unit length carries a current which increases…
A:
Q: Sometimes a nonreflective coating is applied to a lens, such as a camera lens. The coating has an…
A:
Q: b) Show that the pressure of degenerate electrons is given by 8π 3h³ me where you may use the…
A: To show that the pressure of degenerate electrons is given by , we will start with the expression…
Q: Shown in the figure below is an RC circuit. At t=0, the capacitor already contains a charge and as a…
A: Given that,The resistance is The capacitor is .The source voltage is At t=0, the switch is closed.
Q: An object moving along a straight line is slowing down. Which one of the following statements…
A:
Q: Question 1 Trajectory O Both accelerations are equal to zero. O Both accelerations are equal to free…
A: The motion diagram of a connon ball is shown in given figure.We have to find the vertical…
Q: 25% Part (a) How far east, in kilometers, has the wind blown Jack? deast km
A: We will first find components of displacements of Jack along east direction. Then we add the…
Q: 4.) A uniform 25 N beam 6 m long is carried by two men A and B, one at each end of the beam. Show…
A:
Q: Given the arrangement of charged particles in the figure below, find the net electrostatic force on…
A:
Q: 9. A space probe is travelling along a straight line between two planets. Each planet is assumed to…
A: The mass of the first planet M1=5.90*10^24 kg and the radius = R1= 6.31*10^6 m.The mass of the first…
Q: Using the nearly free-electron approximation for a one-dimensional (1-D) crystal lattice and…
A: To start, let's recall the nearly free-electron approximation for a 1-D crystal lattice. In this…
Q: A square loop of wire of side a contains a resistor R and a capacitor C. The loop sits in a…
A: To find the maximum amount of charge on the capacitor, we need to determine the maximum induced emf…
Q: B3. In the alpha decay of uranium 233U-228Th + He, how much kinetic energy (in MeV) will the thorium…
A:
Q: Unpolarized light with intensity 350 W/m² passes first through a polarizing filter with its axis…
A:
Q: Calculate the wavelengths in air at 20°C for sounds in the maximum range of human hearing. The speed…
A:
Q: When the twins are 20 years old, Speedo, sets out on an epic journey from the Earth to Planet X,…
A: The scenario you've described is a variation of the famous "twin paradox" in Einstein's theory of…
Q: 1. Air at 1 atm and 20°C is flowing over the top surface of a 0.5-m long thin plate. The airstream…
A: Air temperature (Tair) = 20°C = 20 + 273.15 K = 193.15 KSurface temperature (Tsurface) = 180°C = 180…
Q: 7) Calculate the heat capacity at constant volume (Cv) for water vapour, assuming a water molecule…
A:
Q: A Q = 2.1 μC point charge is located at the center of a charged hollow metal sphere with inner and…
A: Gauss's law states that the electric flux through a closed surface is equal to the charge enclosed…
Q: A Kepler telescope has an objective lens of focal length 120 cm. It is used to observe a star…
A:
Q: Determine the location of the sweet spot of the bat shown in the figure (Figure 1). The linear mass…
A: To find the location of the center of mass (cm), we can substitute the values into the…
Q: Ⓡ (a) Determine the magnetic flux through the loop due to the current I. (Use any variable stated…
A: a) Determine the magnetic flux.b) If I=a+bt, then determine the induced emf when b=20.0 A/s, h=1.00…
Q: A rigid body consists of 12 identical thin rods of length a, forming the edges of a cube. Each of…
A: To find the moment of inertia tensor of the rigid body, we need to consider each of the three…
In the last column in the data table, it says that it's about voltage(v) divided by current(A) is equal to ohms so V/A = ohms.
So if it's V/A and if you divide them to get the slope it's (y2-y1)/(x2-x1) then shouldn't V be the y value and A be the x value?
And can you also try to use a line of best bit instead of drawing the line through each dot?
Step by step
Solved in 3 steps with 1 images
