Answered: In the shown circuit, the capacitor is…

In the shown circuit, the capacitor is initially uncharged. The switch S is closed at time t-0. Find the current in the circuit (in uA) when the charge on the capacitor is 9.4 uC. 10 V 2.0uF 0.05 MO

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 55P: A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any...

See similar textbooks

Related questions

Q: Thermal energy is produced in a resistor at a rate of 108 W when the current is 3.74 A. What is the…

A: Electric power Electric Power is the rate that energy is supplied by a source or dissipated by a…

Q: In the Power Transfer experiment, A ioad resistance R = 5 Ohms is connected across the terminals of…

Q: C,=3F C2 = 1.5 P 20V I

A: Equivalent capacitance in parallel C = C1 + C2 +C3 In parallel combination potential difference…

Q: A capacitor, C is connected across an emf given by: v(t) = Vo sin(wt) Write an expression for the…

A: We know that charge stored in capacitor is given by Q=CV

Q: In your DC experiment, when the capacitor was just beginning to charge the current in the circuit…

Q: The voltage across a component is 100 V r.m.s. and the current is 7 Ar.m.s. If the current lags the…

A: Formula of apparent power is as follows: Papparent=VrmsIrms…

Q: For the following circuit R1=R2=60 ohms , R3 = 250 ohms , R4= 325 ohms , R5= 260 ohms, and Vtotal =…

A: Resistances R1 and R2 are parallel. Their effective resistance is,

Q: resistor R = 10MΩ is connected in series with a 1µF capacitor and a 12V source. Find the charge of…

Q: A solar cell operating at a temperature of T = 300K has the following specifications: N=5 x 101 cm³,…

A: In this question we have to find the open circuit voltage.Please give positive feedback if the…

Q: For the circuit in the figure, at t = 0 the switch S is closed with the capacitor uncharged. If C =…

A: Given,

Q: A capacitor, C'is connected across an emf given by: v(t) = Vo sin(wt) Write an expression for the…

Q: A 40-m-long transmission line shown in Figure 11.9 has V = 15/0° Vms Z. 30 + j60 0, and V = 5/-48°…

A: Iin = 0.112 angle (-63.4o) A V = 7.5 angle (0o) Vrms

Q: In the figure, suppose the switch has been closed for a time sufficiently long for the capacitor to…

A: Kirchhoff's current law or junction law states that the algebraic sum of the currents meeting at a…

Q: The figure below shows a capacitor, with capacitance C = 50 µF, and a resistor, with resistance R, =…

Q: Consider a capacitor of capacitance C that is being discharged through a resistor of resisiance Ras…

A: Given,

Q: A capacitor has a potential difference of V0 = 375 V between the plates. When the switch S is…

A: Given: V0= 375 V R= 14.5 kohm t= 10 sec Vc= 1V

Q: The power dissipated in a resistor R, carrying a current, I, and a potential difference Vab across…

Q: A 225 µH choke coil of negligible resistance is to limit the current through it to 25 mA when 40 V…

Q: PBL 21.8 If an R=1k2 resistor, a C=1 µF capacitor and a L=0.2 Hinductor are connected in series with…

Q: nsider a series RC circuit as in the figure below for which R = 9.00 MO, C = 9.00 µF, and &E = 31.0…

Q: Thermal energy is produced in a resistor at a rate of 100 W when the current is 3.00 A.What is the…

A: Given : rate of thermal energy production = 100 W current, I = 3.0 A Thermal energy…

Q: A 2.00-nF capacitor with an initial charge of 5.27 µC is discharged through a 2.47-kN resistor. dQ…

Q: A capacitor, C = 2 µF, resistor, R = 500 Q, and a battery, V = 10 volts are connected as shown in…

Q: In the circuit shown above, R = 22, §1 12.8V, and 52 = 9V. What is the %3D %3D power delivered to…

Q: In Figure, suppose the switch has been closed for a time interval sufficiently long for the…

Q: In the shown circuit, the capacitor is initially uncharged. The switch S is closed at time t=0. Find…

A: Given, Voltage V = 10 V Capacitor C = 2 μF Resistance R = 0.05 MΩ

Q: In the shown circuit, the capacitor is initially uncharged. The switch S is closed at time t=0. Find…

A: Charge at capacitor at time t is Q(t) = 5.5 uC Voltage of the circuit is V = 10 V

Q: In the Power Transfer experiment, A load resistance (R) is connected across the terminals of a 3V…

A: r = 10 Ω VL = 3 V

Q: in the circuit shown in the figure, the S switch is closed at t=0 and the capasitors, which are…

Q: Energy is to be transmitted over a pair of copper wires in a transmission line at a rate P with only…

A: The expression for the rms value of current in the transmission, Since the transmission line is…

Q: In the shown circuit, the capacitor is initially uncharged. The switch S is closed at time t-0. Find…

A: Given: V=10 VC=2.0 μFR=0.05×106 Ω The initial current in the circuit is I0=VR

Q: Switch A +Qo C = 2 µF R1 = 2 2 R1 -Qo R2 = 4 2 %3D R2 Qo = 36 µC %3D

A: The capacitor discharging equation is given by Io=(V/R) e-t/RC R = R1+R2 = 2+4 = 6 ohm

Q: In the circuit below, the switch has been in the open position for a long time. At t=0, the switch…

Q: A man foolishly tries to fish a burning piece of bread from a toaster with a metal butter knife and…

A: Given Data: The voltage is, V=120 V The threshold of sensation current is, I=1 mA The expression…

Q: For the circuit shown below, ε=22 V, L=7.5 mH, and R=6Ω. After steady state is reached with S1…

Q: A wire of diameter d, length l and resistivity ρ forms a circular loop. A current enters and leaves…

Q: A charged capacitor of C=60.0 µF is connected to a resistor of R=2.8 MQ as shown in the figure. The…

Q: 2. A 12.4-µF capacitor is connected through a 0.895-MQ resistor to a constant potential difference…

A: Capacitance C=12.4 μF Resistance R=0.895 MΩ Applied potential difference V=60 V

Q: The instantaneous current (I) at time t is given by equation I = (10 + 5) e ^ -t / CRwhen the…

Q: In the Wheatstone bridge experiment shown in 2,2 kn the figure the values of the resistors are R=2.2…

Q: Two 3.8microF capacitors, two 2.2kohms resistors and a 16.0V source are connected in series.…

A: Resistors and capacitors are in series.

Q: Given the equation, V – Voe-(2.6x10-3)t, at what time will | %3D oe the voltage drop by its original…

A: According to guidelines we need to solve only first question kindly repost other questions in the…

Q: In the circuit below the current depends on the time t, and is given by / (t) = 1mAcos(wt). What is…

A: Given that,

Q: What is the maximum power in W that can be generated from an 18 V emf using any combination of a 6.0…

A: Given EMF E = 18 V Resistor R1 = 6 ohm resistor R2 = 9 ohm

Q: steady-state current in each resistor and (b) the charge Qmax on the capacitor. (c) The switch is…

Question

In the shown circuit, the capacitor is initially uncharged. The switch S is closed at time t-0. Find the current in the circuit (in uA) when the charge
on the capacitor is 9.4 µC.
10 V
2.0uF
0.05 MO

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A 2.00-nF capacitor with an initial charge of 4.68 µC is discharged through a 1.24-k2 resistor. (a) Calculate the magnitude of the current in the resistor 9.00 us after the resistor is connected across the terminals of the capacitor. mA (b) What charge remains on the capacitor after 8.00 us? (c) What is the maximum current in the resistor?
In the shown circuit, the capacitor is initially uncharged. The switch S is closed at time t=0. Find the current in the circuit (in uA) when the charge on the capacitor is 8.3 uC. 10 V =20 uF 0.05 MO
A capacitor with capacitance C = 2.5 μF is charged to a voltage V = 5V. It is then discharged through a resistor R = 100Ω. What is the initial discharge current through the resistor?
A 2.00-nF capacitor with an initial charge of 5.62 μC is discharged through a 1.24-k resistor. (a) Calculate the magnitude of the current in the resistor 9.00 us after the resistor is connected across the terminals of the capacitor. Your response is off by a multiple of ten. mA (b) What charge remains on the capacitor after 8.00 µs? X Your response differs from the correct answer by more than 10%. Double check your calculations. μC (c) What is the maximum current in the resistor? X Your response differs significantly from the correct answer. Rework your solution from the beginning and check each step carefully. A
A 2.00-nF capacitor with an initial charge of 5.14 µC is discharged through a 2.29-k2 resistor. dQ (a) Calculate the current in the resistor 9.00 us after the resistor is connected across the terminals of the capacitor. (Let the positive direction of the current be define such that dt > 0.) mA (b) What charge remains on the capacitor after 8.00 us? (c) What is the (magnitude of the) maximum current in the resistor?
A 2.00-nF capacitor with an initial charge of 5.14 μC is discharged through a 1.32-k resistor. (a) Calculate the magnitude of the current in the resistor 9.00 us after the resistor is connected across the terminals of the capacitor. mA (b) What charge remains on the capacitor after 8.00 µs? μc (c) What is the maximum current in the resistor? A
In the circuit below each capacitor initially has a charge of magnitude 3.50 nC on its plates. After the switch S is closed, what will be the current in the circuit at the instant that the capacitors have lost 80.0% of their initial stored energy?
A lab technician wants to measure the electric current flowing through a circuit. The circuit consists of a load Resistor R=4Q connected at the terminals of a battery with internal resistance r=20 and emf e = 10V. The lab technician being amateur connects the (ideal) Ammeter WRONGLY in parallel to the battery. A 2.00 N 10.0 V 4.00 Q ro kaaen . g ny Find: 1. The current through the 4Q load resistor. 2. The current supplied by the battery. 3. The terminal voltage of the battery. 4. The current flowing through the 42 load resistor BEFORE the technician connects the Ammeter. 5. What would the correct way to connect the Ammeter be?
A conducting sphere is charged by an emf source E through a 1.00 MQ resistor. When the sphere is fully charged, it has 1 µC charge. The highest current during the charging was I mA. What is the radius of the sphere in meters?
A 2.00-nF capacitor with an initial charge of 4.72 ?C is discharged through a 1.38-kΩ resistor. (a) Calculate the magnitude of the current in the resistor 9.00 ?s after the resistor is connected across the terminals of the capacitor. mA(b) What charge remains on the capacitor after 8.00 ?s?
A cell of em.f. 2V and external resistance 0.5 Q is connected across a resistor (R). The current that flows is same as that, when a cell of e.m.f. 1.5 V and external resistance 0.3 Q is connected across the same resistor. Then R=03Q (b) R=0.60 R=05Q (d) R=0.75 92
1.00 MQ A conducting sphere is charged by an emf source E through a 1.00 MQ resistor. When the sphere is fully charged, it has 1 µC charge. The highest current during the charging was I mA. What is the radius of the sphere in meters? Your answer