In traveling a distance of 4.2 km between points A and D, a car is driven at 91 km/h from A to B for t seconds and 47 km/h from C to D also for t seconds. If the brakes are applied for 3.7 seconds between B and C to give the car a uniform deceleration, calculate t and the distance s between A and B.

In traveling a distance of 4.2 km between points A and D, a car is driven at 91 km/h from A to B for t seconds and 47 km/h from C to D also for t seconds. If the brakes are applied for 3.7 seconds between B and C to give the car a uniform deceleration, calculate t and the distance s between A and B.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter1: Introduction To Statics

Section: Chapter Questions

Problem 1.19P: Plot the earths gravitational acceleration g(m/s2) against the height h (km) above the surface of...

See similar textbooks

Similar questions

4. 2) The hydraulic cylinder D extends, moves the rigid rod ABC, and causes the collar A to move with velocity and acceleration both to the left. If the dimensions 4 1.0 ft, and 2 = 1.7 ft, VA = 4.9 ft/s, aa = 2.6 ft/s2, and the angle 0 = 27°, determine the speed of point B. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point, and proper unit. В 12 D a Your Answer: Answer units 1,
A camera on the left edge of a circular track of radius D = 4 m tracks a particle as it travels around the circle. The polar equation of the path is given above. At the moment shown, the camera angle is € = 30°, and the camera is rotating at 0 = 0.5 rad/s, which is accelerating at a rate 0 -0.1 rad/s². What is the velocity, acceleration, and rate of change of speed of the particle at that instant? = V= r = D cos(0) a = v = m/s m/s² m/s²
M, 1)Write the time derivative of the usual basis vectors in polar coordinates in terms of ø. Use these relation to compute the acceleration of a point mass (in vector form). Find kinetic energy of point mass m in polar coordinates. 2)In the figure above the pulley and mass m2 form a pendulum of variable length. Size of mass m2 is so small that it can be treated as a point mass. Initially mass mi is at y=0 and length of the pendulum is Lo and angle ø =n/3. Initial velocities are zero. At the instant mass m, reaches y= Lo/4 the angle Ø = n |4 the angular velocity is measured as 2rad/sec. What is time derivative of the length of the pendulum (the rope slides over the pulley without friction, rope is massless) 3) Find accelerations for ø = n/4
A car P travels along a straight road with a constant speed v-76 mi/hr. At the instant when the angle 0-46°, determine the values of in ft/sec and 0 in deg/sec. Assume - 106. Answers: 0- 1011 ft/sec deg/sec
A train started moving from rest with a constant acceleration, and at one time it was traveling at a speed of sec/m30 and after a distance of 160m it was traveling at a speed of sec/m50. Find: 1: the wheel. 2: The time it takes to reach its velocity sec/m30.
A particle travels along the circular curve from A to B in 1 s. The particle takes 3 s to go from A to C. r C В A Values for the figure are given in the following table. Note the figure may not be to scale. Variable Value 25 m 30 degrees 02 10 degrees a. Write position vector r B as a cartesian vector. b. Write position vector rg as a cartesian vector. c. Find the average velocity V avg as a cartesian vector.
with a deceleration of 5 ft per sec. If the total distance traveled is 1000 ft, find the Jers. An automobile starting from rest speeds up to 40 ft per sec with a conatant acceleration of 4 ft per sec", runs at this speed for a time, and finally comes to reat 256 total time required. atione mile enert in e minin
Q1/ A motorist drives North at 2 m/s for 1.5 min, then turns East and travels at 2.5 m/s for 1 min, and finally travels Southeast at 3 m/s for 0.5 min. For this 3 min trip, find (a) the total vector displacement, (b) the average speed, and (c) the average * .velocity
Given: A boat travels around a circular path, p= 40 m, at a speed that increases with time, v = (0.0625 t2) m/s. v30.06252 40 m Find: The magnitudes of the boat's velocity and acceleration at the instant t = 10 s.
The x-coordinate of a particle in curvilinear motion is given by x = 3.8t3 - 2.6t where x is in feet and t is in seconds. The y-component of acceleration in feet per second squared is given by ay = 3.9t. If the particle has y-components y = 0 and vy = 5.2 ft/sec whent = 0, find %3D %3D the magnitudes of the velocity v and acceleration a when t = 5.3 sec. Sketch the path for the first 5.3 seconds of motion, and show the velocity and acceleration vectors for t = 5.3 sec. Answers: V = i ft/sec a = ft/sec2
Two radio transmitters positioned 400 mi apart along the shore send simultaneous signals to a ship that is 200 mi offshore and sailing parallel to the shoreline. The signal from transmitter S reaches the ship 200 microseconds later than the signal from transmitter T. The signals travel at a speed of 186,000 miles per second, or 0.186 mile per microsecond. Find the equation of the hyperbola with foci S and T on which the ship is located. (Hint: For any point on the hyperbola, the absolute value of the difference of its distances from the foci is 2a.) 200 mi Help me solve this C 400 mi Assume the origin is located at the midpoint of the foci. What is the equation of the hyperbola with foci S and I on which the ship is located? (Simplify your answer. Type your answer in standard form.) View an example Get more help. Ship Clear all Skill builder Check answer orre
1) Most of us rode bikes a kid. Did you ever accidentally apply the front brake while riding down a hill and flip over your handlebars? Let's analyze the level of deceleration needed to cause this to happen (at this instant the normal force of the rear tire is zero). Assume the rider is moving down a hill at a constant velocity and att = 0, the rider squeezes the brakes and begins to decelerate. This action results in a force that points in the bi direction and passes through the contact points between the tires and the pavement. Be sure to include your FBD, IRD, and transformation array. b2 30 in. FB 13 in. 23 in.