is a digital process that allows several connections to share the high bandwidth of a linkSelect one:O a. WDMO b. FDMO c. TDMO d. CDM The logical address:Select one:O a. assigned in application layerO b. assigned in datalink layerO c. assigned in transport layerO d. none of the above

TDM Time-division multiplexing (TDM) is a method of transmitting and receiving independent signals…

Answered: is a digital process that allows…

is a digital process that allows several connections to share the high bandwidth of a link Select one: O a. WDM O b. FDM O c. TDM O d. CDM

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 27VE

See similar textbooks

Related questions

Q: . What is the main feature of Time Division Multiplexing? a. simple and easy to implement b. fair…

A: Synchronous TDM does not require identity bits to be included in a message since the receiving…

Q: 16. What's the data transfer rate in an FDDI network if only the primary fiber link is used? A. 2…

A: Introduction: The American National Standards Institute (ANSI) established the Fibre Distributed…

Q: What is Multiple Access ? What is the difference between TDMA and FDMA ? Whet

A: what is multiple Access? Numerous access is a method of allowing multiple mobile users to share the…

Q: Ethernet implements the Frame Check Sequence (FCS) using a technique called Cylic Redundancy Check…

Q: e the 00 Mbps link, 0.3 00 bit packet for oneration

A: Solution - In the given question, we have to find the utilization at the sender using the given…

Q: If the available channel is a ____ channel, we cannot send a digital signal directly to the channel.…

A: Answer is given below .

Q: Q3)A slotted ALOHA network transmits 800-bit frames using a shared channel with a 400-kbps…

A: In this case G=2. So, S = G*e-G S = 2*(2.71)-2 S = 0.272 = (27.2 percent) This means that the…

Q: Can I have a detailed, step-by-step explanation for the following question? Thank you very much!…

A: We have 4 channels that are multiplexed using TDM. If each channel sends 100 bytes/second and we…

Q: Q3. A link has a signal-to-noise ratio of 2000 and a bandwidth of 12000 KHz. What is the maximum…

A: The answer is

Q: Find the minimum bandwidth of a FDM system which multiplex five

A: The answer is

Q: What is the typical data rate for HD services? (the answers are in Mbps) 3.75 to 5.50 8 to 20 5 to…

A: The typical data rate for HD services are : 8 to 20. Below is the explanation.

Q: For a p-channel JFET the transfer characteristics is drawn for O lo versus Vps O IG versus Vos O lo…

A: Task :- identify the corrrect option.

Q: Which transmission characteristic is never fully achieved? a. Latency b. Throughput c. Bit rate d.…

A: Answer: The correct option is (d) Bandwidth

Q: Briefly state the principle following multple access protocol a). TDMA; B).FDMA; C) Pure ALOHA…

A: Solution: Multiple access protocols : They are group of protocols that operate in Medium Access…

Q: MC7: is a sublayer in data link to decide who sends next frame on a multi- access link. OFDM TDM…

A: Database Management System(DBMS) is a software for storing and retrieving users data while…

Q: What is the bit rate for high-definition TV (HDTV)?

A: What is the bit rate for high-definition TV (HDTV)? 1.4 Gbps 2 Gbps 1.5 Gbps 1.8 Gbps

Q: The Very high-bit-rate Digital Subscriber Line's (VDSAL) downstream rate is a. 768 kbps b. 1.5 Mbps…

A: Given that: The Very high-bit-rate Digital Subscriber Line's (VDSAL) downstream rate is a. 768…

Q: To improve the efficiency and quality of digital communications, Time Division Multiple Access…

A: TDMA: The TDMA stands for Time-Division Multiple Access which is a channel access method for…

Q: Which of the following is a digital multiplexing technique ? O a. WDM O b. both TDM & WDM O. FDM O…

A: Multiplexing is a process of combining various signals to single signal These signals can be analog…

Q: Subject - Data Communication Networks 1. What features are true about of Time Division…

A: Multiplexing is used when a single transmission medium needs to be shared. Suppose there is a single…

Q: >A transmission scheme that Drag answer here allows multiple senders to use a single transmission…

A: A transmission scheme that allows multiple sender's to use a single transmission medium one at a…

Q: What are the most popular frequency reuse factors for 1G FDMA, 2G TDMA, and 3G CDMA?

A: To Do: To write the frequency reuse formula.

Q: A channel has a 1-MHz bandwidth. The SNR for this channel is 63. What is the appropriate bit rate?…

A: Answer to the above sum related to finding bit rate is detailed in step2.

Q: Q3. A link has a signal-to-noise ratio of 2000 and a bandwidth of 12000 KHz. What is the maximum…

A: Given that, Signal to noise ratio (SNR)= 2000 Bandwidth= 12000 KHz The given channel is Noisy…

Q: DSL is a combination of what two types of multiplexing? a. FDM and TDM b. FDM and FM c. AM…

A: DSL (Digital Subscriber Line) is a technology that allows you to send and receive data over phone…

Q: A slotted ALOHA channel has an average 10 % of the slots idle. a) What is the offered traffic G ? b)…

A: Introduction :Given , A implementation for Slotted ALOHA.Ideal Slots = Average 10% .We have to…

Q: 1. (a) What is Frame Synchronization in TDM technique? Why are guard bands used in FDM and are not…

A: Frame Synchronization in TDM technique: TDM frameworks, it is significant not just that an edge must…

Q: 39. The _________ product defines the number of bits that can fill the link. a. bandwidth-period b.…

A: The ___ bandwidth-delay______ product defines the number of bits that can fill the link. So, option…

Q: 1 Which of the following technology allows multiple calls transmitting at the same time and over the…

A: The correct answer in given in next step with explanation

Q: Computer Science Suppose that you had more than 4GByte of data to send and could only afford one…

A: In data transmission, network throughput is the amount of data moved successfully from one place to…

Q: When two or more signals share a common channel, it is called (a) sub-channeling O tb) channeling O…

A: In multiplexing two or more analog and digital signals transmitted via the shared link. It is used…

Q: 12.a. Which measurement is used to determine CWDM and DWDM channel losses? A. Span loss B. Patch…

A: Ans 1: The measurement that is used to determine CWDM and DWDM channel losses is: a) Span loss

Q: 21. __________ uses thin coaxial cable. a. 10Base5 b. 10Base2 c. 10Base-T d. 10Base-F

A: Please see the next step for answer.

Q: 246. The High-bit-rate Digital Subscriber Line (HDSL) was designed as an alternative to a. ADSL b.…

A: We need to find the correct answer for the given statement-"The High-bit-rate Digital Subscriber…

Q: A link has a signal-to-noise ratio of 2000 and a bandwidth of 12000 KHz. What is the maximum data…

A: Here in this question we have given signal to noise ratio =2000 Bandwidth= 12000khz Find - maximum…

Q: (Dont copy) Four digital channels each transmitting at rate 2 Mbps with 4 bits are carried by one…

A: FDM is an analog multiplexing technique FDM is an analog multiplexing techniquethat combines analog…

Q: Q3. A link has a signal-to-noise ratio of 2000 and a bandwidth of 12000 KHz. What is the naximum…

A: The answer is

Q: j. If link transmits 4000 frames per second, and each slot has 8 bits. Then what is the transmission…

A: Question j. If link transmits 4000 frames per second, and each slot has 8 bits. Then what is the…

Q: 6- Bits can be sent over guided and unguided media as analog signal by a) digital modulation b)…

A: 6)Bits can be sent over guided and unguided media as analog signal by -‐-------------…

Q: 1. each call allocated periodie slot(s), can transmit at maximum rate of (wider) frequency band…

A: Time Division Multiplexing It is a method of transmitting and receiving independent signals over a…

Q: 40 devices share a clean ALOHA channel. The drawer is 2μs in size. Because they want the devices to…

A: Here given is the number of channels as 40. So our N will be 40. Drawer is 2 micro seconds. So our…

Q: Please find the required bit rates for the following video source and express it in Mbps (with two…

A: 1. Given Total frames = 60 Number of pixels in each frame = 640 x 400 Total number of colors = 16…

Q: Q3. A line has a signal-to-noise ratio of 2000 and a bandwidth of 12000 KHz. What is the maximum…

A: The maximum data rate supported by this line: C=W log2(S/N+1)

Q: 25.A. Which of the following could inoti be a SONET transmission rate? A. 9.953 Gbps B. 99.66 Mbps…

A: Introduction 25.A. Which of the following could inoti be a SONET transmission rate?A. 9.953 GbpsB.…

Q: Q4) Four users are multiplexed using FDM and each user is allocated 150 KHz bandwidth separated by…

A: Given: To find out capacity of link given that four users are multiplexed using FDM and each user is…

Q: One of the following is not related to FDDI: A) Single & dual attached stations. B) Data rate 100…

A: FDDI uses optical fiber as its physical medium.

Q: "The Bandwidth utilization of the CDMA (Code Division Multiple Access) Technique used in 3G is more…

A: Code-division multiple access : Code-division multiple access is a channel access method used by…

Question

is a digital process that allows several connections to share the high bandwidth of a link
Select one:
O a. WDM
O b. FDM
O c. TDM
O d. CDM

The logical address:
Select one:
O a. assigned in application layer
O b. assigned in datalink layer
O c. assigned in transport layer
O d. none of the above

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Answer 1

VIEW

Step 2 Answer 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.