Mathematical Modelling: State Space Representation of Transfer Function Systems 1. Based on the following ordinary differential equations: x₁ (t) = = x₂(t) R *₂ (t) = x₁(t)-x₂(1) + m(t) y(t) = x₁(t) Obtain the transfer function of the system.

Mathematical Modelling: State Space Representation of Transfer Function Systems 1. Based on the following ordinary differential equations: x₁ (t) = = x₂(t) R *₂ (t) = x₁(t)-x₂(1) + m(t) y(t) = x₁(t) Obtain the transfer function of the system.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: What is the real component for the equivalent impedance, Zeq, for the following circuit if = 790…

A: Given data, ω=790 rad/s

Q: AM spectrum consists of a) Carrier frequency b) Upper sideband c) Lower sideband d) Carrier…

Q: Calculate the bandwidth and baud rate for an FSK signal with mark frequency 34 kHz, space frequency…

A: Given a FSK signal,Mark frequency= 34kHZ Space frequency = 26Khz…

Q: 25 cos 250t V {+21) 50 M 60 V 200 μF 80 mH 15 ↑) 8 A 9⁰.

Q: Determine the power relations delivered by the dependent source on the circuit below. P S W ~2420° V…

Q: 12v( R₁ t +=0 R₂ 1. Determine the initial conditions i₁(0+) and v.(0+) 2. Determine the steady state…

Q: Identify the CORRECT answers about resistivity I…

A: Given: Identify the CORRECT answers about resistivity

Q: ii) Derive the expression of EMF induced in a Transformer? Why is a transformer rated in KVA?

A: The basic circuit of the transformer is shown below: In the above circuit: Current losses are…

Q: An LII system is represented by the following difference equation: y(n) = 0.5y(n-1) + 1.5y(n-3) +…

A: Given data, Function is given as, yn=0.5yn-1+1.5yn-3+2xn-0.8xn-2

Q: Sketch a diagram showing the ohmmeter face for a reading of 1.2k ohms. Indicate the setting of the…

A: Ohmmeter:- An ohmmeter is a piece of electrical equipment used to measure electrical resistance.…

Q: A 105MHz, 90 v peak signal is incident on a 50-ohm transmission line. The line is 125m long and is…

Q: manufacturing process is b) A represented by the following block diagram where G₁(s) = 4/s, G₂(s) =…

A: Mason's Gain Formula- It is a technique used for finding the transfer function of a control system.…

Q: Loads, Service, and Overcurrent Protection 17.a. A one-family dwelling contains an electric range…

Q: 20.a. What's the primary disadvantage of using copper conductors? A. Durability B. Cost C.…

A: 20. (a) Although one of the most electrically conductive materials known, copper is easily corroded…

Q: 1.b Using a table of Bessel functions, determine the minimum bandwidth for the FSK signal from the…

A: Given: fm=34 kHz,fs=26 kHz and fb=2kbps=2000 bps Required: Minimum bandwidth for the FSK signal.

Q: b) A manufacturing process is represented by the following block diagram where G₁(s) = 4/s, G₂(s) =…

Q: A galvanometer has a resistance of 30 Ω and full scale deflection is achieved with a current of 1…

Q: Discuss solar energy in future power system

A: In the given question we need to discuss solar energy in future power system.

Q: Using op amps with Vsat = +/- 13 V, design a square/ triangular wave function generator circuit to…

A: Triangular Wave Generator Using Op amp- A Triangular Wave Generator Using Op amp can be formed by…

Q: A series circuit of 27 ohms, 3.06 Henry Inductor and 0.0172 capacitor are energized by 700 Volts DC…

Q: Given the information provided in Fig. 4.126, determine: a.lc . b. VE C. VB d. R. R₁ VB 5.6 ΚΩ -018…

A: Types of biasing circuit Voltage divider biasing Fixed biasing Emitter biasing Collector to base…

Q: Analyse the steady state error of the system ( I correct the question now please solve it )

A: For the given unity negative feedback system we need to calculate steady state error. Note : It is…

Q: 4. Write nodal equations for V1, V2, V3, V4. Do not simplify. 50 Vi ele V3 2H Заст 40 V₂ For #F V4…

A: Given figure,

Q: An abrupt Si PN junction at 300 K is characterized by ND = 1016 cm-3 and NA = 2.5 x 1015 cm-3.…

A: the required parameters can be calculated by using the general expression of build in voltage and…

Q: Discuss the important requirements to be satisfied by protective system

Q: Draw a qualitative plot of the Voltage Transfer Characteristic of the CMOS inverter. Pleas indicate…

Q: For the network, determine re for a voltage gain of Av = -200. VoH 1 MQ -Vcc 4.7 ΚΩ Hf ovo B =90

Q: a) [ Explain in your own words how we can choose the state variables of a system. Justify your…

A: Transfer function is defined as the ratio of output to input with zero initial conditions. The…

Q: (c) Obtain Z-transform of 1-e-Ts S -) (+)

A: C) To obtain the z - transform

Q: Two three-phase alternators operate in parallel. The rating of one machine is 50 MW and that of the…

A: Must Condition for parallel operation of the generator The voltage phase sequence should be same…

Q: Discuss about the performance characteristics of wind turbine

A: Introduction - Wind turbines use aerodynamic force by the propeller blades to convert wind energy…

Q: 14.a. A clothes dryer in a one-family dwelling is rated at 6,000 VA. What's the demand load on the…

Q: G₂ AC meter C₁

Q: IB3 +10 5 кл 10 кл in Alo - 10V de |c Find. B=50 (6=2 13 => 1c=> vc=> V<= ?

Q: 2. In the circuit below vin (t) = 10V, and has been present for a very long time. $1 1 In 2 S 1F HH…

A: For the above given circuit we need to calculate all the voltage parameters of the capacitors.

Q: Consider the following differential equation; d³y dr 3 di dt d³x =2 +4 dt -+9x dt Derive the…

Q: In the circuit given below, V=7 V. Determine the current through the 10-kΩ resistor. V Μ 4 ΚΩ M 3 ΚΩ…

A: Given circuit, Here V= 7 Volts

Q: What are the reason for variation in solar radiation reaching the earth than recieved at the outside…

A: Sun is the source of energy. It produces the light energy as well as heat energy. The energy…

Q: 1. a) With the aid of a diagram, explain the working principle of a common-base NPN BJT transistor…

A: (a) Common-base NPN BJT transistor (A)NPN BJT Common Base TransistorIn a C-B configuration, the…

Q: 3. For the circuit shown in Fig. Q3: (1) compute the total impedance in polar form. (ii) compute the…

Q: Design a monostable 555 timer circuit to produce an output pulse 5 ms wide.

A: The monostable 555 timer is a Integrated circuit consist of a RC network which is used to produce…

Q: 5V 2 ΚΩ Μ I 7 kΩ Ι', ΚΩ 2 9V

A: Given data : The given circuit is shown below,

Q: 7. Space diversity s also known as

A: The solution is provided in the following section.

Q: Loads, Service, and Overcurrent Protection 6.a. The general lighting load is based on a _______ per…

Q: B 3.18 V C) 3.33 V A power-supply filter with DC output voltage of 9.2 V has a load resistor of 10…

A: According to the questions, if one of the diode and capacitor will remove then it will become a half…

Q: 6.a. The amount of short-circuit current that flows depends upon the amperes available at the source…

A: The short circuit current is depends on impedance of short circuit and voltage across it. From that…

Q: Explain what will happen to a semiconductor doped by equal concentration of donors and acceptor…

A: Doping:- Doping is the deliberate introduction of impurities through an intrinsic semiconductor in…

Q: The resistance and Calculate wel me for Ls 1) The ii The Пе 11 2 if الا lto connected SO curent coil…

A: Given data:: current coil resistance (let Ra)= 0.03 ohms pressure coil resistance (let Rp) = 6000…

Q: what is the size of decoder for 16 x 4 ROM

A: We know that DECODER: It is a combinational circuit, which contains N-inputs , 2^N outputs and one…

Q: Solve for question iv) and v)

A: Given: A 3-phase star connected 6-pole 60 Hz induction motor draws 16.8 A at a power factor of 80%…

Question

Mathematical Modelling: State Space Representation of Transfer Function Systems
1. Based on the following ordinary differential equations:
x₁ (t) = = x₂(t)
*₂(t) = -x, (t)-7xx(1) + u(t)
y(t) = x₁(t)
Obtain the transfer function of the system.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Simplify the following expression to sum of products F = (A, B, C, D) = n(1, 3, 6, 9, 11, 12, 14)
(c) Full-wave rectifier. Show that the Laplace trans- form of the full-wave rectification of sin vt is (in the image shown) (only solve part c!!)
1. Write the differential equation of the given mechanical systems and determine the transfer function X2(S) Fa(S) x1 k m2 mi Fa bi X2 k b2
intransfere funCtion of LTI syste in giving such that (३) = S n S+4 @ find the differential equation describing the system 6 find the output 4() af that system When imput t Xe)=e* UCE)
Example 2 For the unit step response shown in the figure, find the transfer function of the system. 3 0.05 0.1 0.15 0.2 0.25 8. Time (seconds) Response 2.
9. if C(s) = Teia) 3 s(s2+4s+3) ,the form of response will be c(t) = (Write in A, B, C for residues) 10. o is called ..... .in English
Q/ Implement the following P.O.S function (A,B,C,D)=sum(1,5,8,9,12,13,15) using MUX's .of 3*8
Introduction to Control... Unit step response of system is 1 C(t) = (-et+e-²) for t > 0. The transfer function of system is. 8
Transfer functions of the system is : see attached picture. Please answer with detail of step by step ( for mathematic so find the value) a.Find the response output in the time domain : y(t) for t : 4r b.Please draw a first orde curve (with number or percen )
The minimum sum-of- products for the following function isF(A,B,C,D,E)=[m(0,1,15,16,17 ) +[d(14,24,25,30,31) using Quine - McClusky method
A system is described by the following differential equation dx +4 +2x%31 dt dt with the initial conditions x(0) = 2, = -2. Show a block diagram of the system and all pertinent inputs and outputs.
Consider a system with the mathematical model given by the following differential equation. Find the transfer function of the system. d²y + 10 dr? + 2y = u(t). dr dt