Metal spheres, 10 mm in diameter, are to be annealed by heating them to 827°C then allowing them to cool slowly in air at 27°C to the point where they are in thermal equilibrium with the air. 2000 balls are annealed in one hour’s time. What is the total rate of their heat transfer if they are made of steel, lead, or copper?

Q: cylindrical tube in winter. One end of the tube is held by a hot piece o metal which is at 100 C.…

A:

Q: Cooking an egg involves the denaturation of a protein called albumen. The time required to achieve a…

A: Data given -  Ea = 418 kJ mol-1  P = 355 mm Hg = 13600 × 9.81 × 355 × 10-3 Pa  Pa = 47.362 kPa  t ∝…

Q: Earlier experiments have shown that a certain component cools in air according to Newton's cooling…

A:

Q: A mechanic needs to remove a tight fitting pin of material A from a hole in a block made of material…

A: GIVEN TOPIC- Thermal expansion of metals                         A mechanic needs to remove a tight…

Q: You are designing an enclosure which houses a PCB. Mounted outside the enclosure on its top is a set…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: Rod 1. with a thermal conductivity of 325 W/m-K. rod 2, with a thermal conductivity of 231 W/m-K,…

A:

Q: Recent studies show that the major energy consumption in Fijian villages is wood which is used for…

A: Typical consumption of wood per person per day = 1 kg/person/day

Q: 6. Two thousand pounds of banana per day is refrigerated to 25°F. Initial temperature of the bananas…

A:

Q: Codfish fillets originally at 10 °C are packed to a thickness of 102 mm. Ice is packed on both sides…

A:

Q: Aluminium, due to its high strength-to-weight ratio and corrosion resistance, is a metal critical to…

A: Given data: Mass of aluminum = M = 17 kg Initial temperature of aluminum bar = T = 106°C = 106 + 273…

Q: Calculate the heat flow per square meter (heat flux) through mineral wool insulation, U 5 cm thick,…

A: Given data  T1=200 °C T2= 30°C Thickness (t)=5cm=0.05m We take thermal conductivity of mineral wool…

Q: The cake mix, whose initial temperature is 25°C, will be baked at 120°C in a cylindrical mold. It…

A: Given: The initial temperature is Ti=25°C. The baking temperature of cylindrical mold is Tf=120°C.…

Q: 20,000 J of heat is supplied to a 5 kg mass. If the temperature rises from 20oC to 30o C, calculate…

A:

Q: A large piece of biological tissue has to be kept at a temperature as low as possible without…

A: Given Information:Freezing temperature of water Tw=273 KMolecular weight of water Mw= 18Latent heat…

Q: (1) The Surface tension of water in contact with air at 23°C is given as 725x10+ N/m. The pressure…

A: Surface tension is due to unbalanced cohesive forces (at the liquid side) at the interface of…

Q: A chamber for heat curing large aluminum sheets lacquered black on both sides operates by passing…

A:

Q: Two containers A and B of volume V are connected by a thin tube. A cock is equipped in the thin…

A: For tank A: Pressure = P volume = V Temperature = T For tank B: Pressure = 2P volume = V Temperature…

Q: Calculate the load on a cooler coil which cools the moist air mentioned in example 2 by 5 degrees.…

A: Given:flow rate,Q=1.5 m3/sInitial state:tdbt1=21°Ctwbt1=15°CP=101.325 KPadecrease in…

Q: A steel sphere 3” in diameter heated to 600oF, is to be cooled by immersion in an oil bath at 100oF.…

A: Lumped Heat Analysis: This method is used to find the temperature changes of a hot substance when it…

Q: Two long rods of the same diameter, one of brass(k= 85 W/mK) and the other of copper (k=375 W/mK)…

A:

Q: Codfish fillets originally at 10 °C are packed to a thickness of 102 mm. Ice is packed on both sides…

A:

Q: Oxy-acetylene torches can be used to cut or weld metal .Oxygen and acetylene are fed from separate…

A: 1. In a closed system, no mass crosses the boundary and hence no matter exchange is possible with…

Q: How do I set up equations for a mass connected to a wall by a spring and a damping pot, which then…

A: Consider the schematic diagram of the mass connected with spring and damping pot. The block is…

Q: The mass of water in a single popcorn kernel was found to be 0.905 grams after it popped at a…

A:

Q: Air surrounding a light bulb is moving at 25 m/sec. The surrounding conditions are kept at…

A: For forced convective heat transfer across a sphere we use the Whittaker correlation Nu¯=h¯Dk=2+ 0.4…

Q: ou are designing an electric air heater for large conference rooms. A 75mm OD, 4mm wall thickness…

A: Given Data: The outer diameter of the pipe is D = 75 mm. The wall thickness of the pipe is t= 4 mm.…

Q: 2) A very long copper rod, 9 mm diameter, has one end maintained at 140°C. The surface of the rod is…

A:

Q: An air conditioned room in the Basra city that measures 3 m wide, 3.5 m high and 6 m deep. The…

A: Given Data

Q: Create two problem solving about steady-state heat flow (Heat convection in fluids) and show your…

A: Problem 1   Problem 2

Q: in The pattern is dipped into a slurry of refractory material such as very fine silica and binders,…

A: In ceramic mold casting, there are two different type of slurries used which are know as true…

Q: The ductility of a large copper (k = 386 W/mºC, a = must be increased by quenching before it can be…

A: When a body is an abrupt change in its surface temperature then body will attain steady state…

Q: Measuring the temperature of very cold substances can be challenging. Here is one way of measuring…

A:

Q: a) How long does the temperature at the fruit's center was decreased 20°C from the initial state b)…

A:

Q: Two plane disks each 1.25 m in diameter are parallel and directly opposed to each other. They are…

A:

Q: Two plane disks each 1.25 m in diameter are parallel and directly opposed to each other. They are…

A: In steady state, Disc 2 loses as much heat as much as it gains.Heat gained by disc 2= F12A1σT14…

Q: 350 pipes are fixed as square in a pipe bundle used for condenser. Pipe The outer diameters are 8 mm…

A:

Q: Calculate the specific heat capacity of 10 000 kg of sea water if the rise in temperature is 0.00255…

A: Specific heat of a substance is defined as the amount of heat required to raise the unit mass of the…

Q: Estimate the thermal diffusivity of butter at 20°C.

A: As per given question  We have to find thermal diffusivity of butter

Q: A 40-gram water with temperature of 60°C is placed into a 60-gram aluminum cup of temperature 25°C.…

A:

Q: 5.) The bottom of a pan is made of a 4- mm-thick aluminum layer. In order to increase the rate of…

A:

Q: Two inches of urethane foam will reduce heat loss close to 1000% when applied to a 2-inch diameter…

A:

Q: Two identical 7.5-cm cubes of copper at 425 and 90°C are brought into contact. Assuming that the…

A: Given…

Q: A manufacturer of medical devices uses shape memory alloys (notably nickel-titanium) to manufac-…

A: Given:- Rate of failures=0.008333 failures/month=(.008333×12) failures/year  Device Price=$1250,…

Q: de a very large surface area for cell interaction. Calculate the surface area of a collagen sponge…

A: Pores are important for the cells to enter and grow as well as in capillary suction of tissue fluid…

Q: If temperature difference is doubled whereas thermal conductivity and wall thickness are halved,…

A: Heat conducted through wall is given by, Q = k A ∆T∆x Where, k = Thermal conductivity A  =Cross…

Q: One measure of the scale of a process is its throughputs of fuel or other input raw materials,…

A: 3 Boilers=1020MWBoiler heat rate=8980Btu th/hrgross heating value=14000 Btu th/lb To-Find:- Power it…

Q: A linear thermal actuator is being used, inside it contains wax with a specific volume of 15%, that…

A: Gievn Data The specific volume is: v=15% The expansion of the wax is: 15% The required stroke…